Auto Parts Search
We have info for following modifications of 2005 Toyota Corolla
- 2005 Toyota Corolla XRS 1.8 L4 GAS, CC:1795, Fuel Injection
- 2005 Toyota Corolla 1.8 L4 GAS, CC:1794, Fuel Injection, Engine VIN:, Desg:R
MAINTENANCE LAMP RESET PROCEDURES FOR 2005 Toyota Corolla AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2005 Toyota Corolla cars and light trucks sold in the U.S. from 1990+.
Toyota -> Air Bag Warning Lamp -> 2003-09 Corolla
Vehicle: 2005 Toyota Corolla XRS 1.8 L4 GAS
- Connect two service wires to terminals Tc and CG of data link connector.
- Disconnect Tc within 10 seconds after DTC output begins.
- SRS warning lamps will illuminate 3 seconds later. Within 2-4 seconds, connect terminals Tc and CG of DLC.
- SRS warning lamp will go off within 2-4 seconds. Within 2-4 seconds, disconnect term...
CLICK HERE TO GET FULL ACCESS TO 2005 Toyota Corolla MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2005 Toyota Corolla AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2005 Toyota Corolla cars and light trucks sold in the U.S. from 1990+.
Toyota -> Anti-Lock Brake System (ABS)/Vehicle Stability Control (VSC) System Warning Lamp -> 2003-09 Corolla
Vehicle: 2005 Toyota Corolla 1.8 L4 GAS
The anti-lock warning lamp is used to warn of a system fault. The lamp will be lit during engine start-up, but should go out when the self-diagnostic system verifies proper anti-lock operation. If the lamp remains lit, a fault in the anti-lock brake system is indicated. After system diagnosis and repair are complete, the lamp can be reset using the following procedures:
- Place ignition switch ...
CLICK HERE TO GET FULL ACCESS TO 2005 Toyota Corolla MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2005 Toyota Corolla AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2005 Toyota Corolla cars and light trucks sold in the U.S. from 1990+.
Toyota -> Automatic Transmission Overdrive Lamp ->
Vehicle: 2005 Toyota Corolla XRS 1.8 L4 GAS
The "OD Off" lamp will be illuminated when the ignition switch is in the On position and the Overdrive (OD) switch is in the Off position. When the OD switch is placed in the On position, the "OD Off" lamp should go out. If the lamp flashes when the switch is placed in the On position, a fault has been detected by the electronic control system. After diagnosis and repair are c...
CLICK HERE TO GET FULL ACCESS TO 2005 Toyota Corolla MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2005 Toyota Corolla AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2005 Toyota Corolla cars and light trucks sold in the U.S. from 1990+.
Toyota -> Malfunction Indicator Lamp (MIL) ->
Vehicle: 2005 Toyota Corolla 1.8 L4 GAS
On some models equipped with OBD II, the MIL will also illuminate if the fuel tank filler cap is not properly tightened. Tighten fuel tank filler cap until it clicks.
The MIL should light when the ignition switch is placed in the On position without starting the engine. When the engine is started, the lamp should go out. If it remains lit, a fault has been detected by the diagnostic system and has logged a diagnostic trouble code. If the fault does not occur again within three trips, the lamp will go out but a diagnostic tro...
CLICK HERE TO GET FULL ACCESS TO 2005 Toyota Corolla MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2005 Toyota Corolla AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2005 Toyota Corolla cars and light trucks sold in the U.S. from 1990+.
Toyota -> Anti-Lock Brake System (ABS)/Vehicle Stability Control (VSC) System Warning Lamp -> 2003-09 Corolla
Vehicle: 2005 Toyota Corolla XRS 1.8 L4 GAS
The anti-lock warning lamp is used to warn of a system fault. The lamp will be lit during engine start-up, but should go out when the self-diagnostic system verifies proper anti-lock operation. If the lamp remains lit, a fault in the anti-lock brake system is indicated. After system diagnosis and repair are complete, the lamp can be reset using the following procedures:
- Place ignition switch ...
CLICK HERE TO GET FULL ACCESS TO 2005 Toyota Corolla MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2005 Toyota Corolla AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2005 Toyota Corolla cars and light trucks sold in the U.S. from 1990+.
Toyota -> Malfunction Indicator Lamp (MIL) ->
Vehicle: 2005 Toyota Corolla XRS 1.8 L4 GAS
On some models equipped with OBD II, the MIL will also illuminate if the fuel tank filler cap is not properly tightened. Tighten fuel tank filler cap until it clicks.
The MIL should light when the ignition switch is placed in the On position without starting the engine. When the engine is started, the lamp should go out. If it remains lit, a fault has been detected by the diagnostic system and has logged a diagnostic trouble code. If the fault does not occur again within three trips, the lamp will go out but a diagnostic tro...
CLICK HERE TO GET FULL ACCESS TO 2005 Toyota Corolla MAINTENANCE LAMP RESET PROCEDURES
Shop online for auto body parts, engines, wheels, lights...
More parts |
Get the Complete Technical Service Bulletins! |
Access diagrams and repair information such as wiring diagrams, diagnosis and repair charts, manufacturer service bulletins, and OEM Part numbers of your 2005 Toyota Corolla vehicle. |
Access the Complete guide! |