Auto Parts Search
We have info for following modifications of 2008 Toyota Yaris
- 2008 Toyota Yaris S 1.5 L4 GAS, CC:1497, Fuel Injection
- 2008 Toyota Yaris 1.5 L4 GAS, CC:1497, Fuel Injection
- 2008 Toyota Yaris RS 1.5 L4 GAS, CC:1497, Fuel Injection
- 2008 Toyota Yaris LE 1.5 L4 GAS, CC:1497, Fuel Injection
- 2008 Toyota Yaris CE 1.5 L4 GAS, CC:1497, Fuel Injection
MAINTENANCE LAMP RESET PROCEDURES FOR 2008 Toyota Yaris AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2008 Toyota Yaris cars and light trucks sold in the U.S. from 1990+.
Toyota -> Automatic Transmission Oil Temperature Warning Lamp ->
Vehicle: 2008 Toyota Yaris LE 1.5 L4 GAS
This lamp will be illuminated when automatic transmission or transfer case fluid temperature exceeds 302°F. If the lamp lights, allow vehicle to operate at idle speed until fluid temperature falls below 248°F; t...
CLICK HERE TO GET FULL ACCESS TO 2008 Toyota Yaris MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2008 Toyota Yaris AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2008 Toyota Yaris cars and light trucks sold in the U.S. from 1990+.
Toyota -> Engine Oil Reminder/Maintenance Required Lamp -> 2006-09 Yaris
Vehicle: 2008 Toyota Yaris RS 1.5 L4 GAS
- Turn the ignition switch to the On position and ensure that the display screen is in the Trip A mode.
- Turn the ignition switch to the Off position.
- While pressing the ODO/TRIP switch button, turn ignition switch On. Hold the button down through the entire reset procedure.
- The odometer indicates 000000 and then the oil replace...
CLICK HERE TO GET FULL ACCESS TO 2008 Toyota Yaris MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2008 Toyota Yaris AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2008 Toyota Yaris cars and light trucks sold in the U.S. from 1990+.
Toyota -> Malfunction Indicator Lamp (MIL) ->
Vehicle: 2008 Toyota Yaris CE 1.5 L4 GAS
On some models equipped with OBD II, the MIL will also illuminate if the fuel tank filler cap is not properly tightened. Tighten fuel tank filler cap until it clicks.
The MIL should light when the ignition switch is placed in the On position without starting the engine. When the engine is started, the lamp should go out. If it remains lit, a fault has been detected by the diagnostic system and has logged a diagnostic trouble code. If the fault does not occur again within three trips, the lamp will go out but a diagnostic tro...
CLICK HERE TO GET FULL ACCESS TO 2008 Toyota Yaris MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2008 Toyota Yaris AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2008 Toyota Yaris cars and light trucks sold in the U.S. from 1990+.
Toyota -> Air Bag Warning Lamp -> 2007-09 Yaris
Vehicle: 2008 Toyota Yaris S 1.5 L4 GAS
- Connect service wires to check connector terminals Tc and AB.
- Place ignition switch in Accessory or On positions and wait approximately 6 seconds.
- Apply body ground to terminals Tc and AB alternately, twice in 1 second intervals beg...
CLICK HERE TO GET FULL ACCESS TO 2008 Toyota Yaris MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2008 Toyota Yaris AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2008 Toyota Yaris cars and light trucks sold in the U.S. from 1990+.
Toyota -> Malfunction Indicator Lamp (MIL) ->
Vehicle: 2008 Toyota Yaris LE 1.5 L4 GAS
On some models equipped with OBD II, the MIL will also illuminate if the fuel tank filler cap is not properly tightened. Tighten fuel tank filler cap until it clicks.
The MIL should light when the ignition switch is placed in the On position without starting the engine. When the engine is started, the lamp should go out. If it remains lit, a fault has been detected by the diagnostic system and has logged a diagnostic trouble code. If the fault does not occur again within three trips, the lamp will go out but a diagnostic tro...
CLICK HERE TO GET FULL ACCESS TO 2008 Toyota Yaris MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2008 Toyota Yaris AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2008 Toyota Yaris cars and light trucks sold in the U.S. from 1990+.
Toyota -> Tire Pressure Warning Lamp -> 2008-09 Yaris -> Registration -> Relearn -> Reset -> System Initialization -> Tire Pressure Sensor & Transmitter -> TPMS ECU
Vehicle: 2008 Toyota Yaris S 1.5 L4 GAS
Reset
This warning lamp will illuminate when tire pressure falls below a specified psi. When the warning lamp illuminates, check the air pressure of the tire and adjust it to specified pressure. When the vehicle is driven more than 18 mph after the adjustment, the lamp will go off.
Relearn
Registration
TPMS ECU
If replacing the TPMS ECU, prior to removal, use a suitably programmed scan tool to read the registered transmitter identification number for all wheels and note them for registration.
- Connect a suitably programmed scan tool to DLC3 located under the LH side of the instrument pan...
CLICK HERE TO GET FULL ACCESS TO 2008 Toyota Yaris MAINTENANCE LAMP RESET PROCEDURES
Shop online for auto body parts, engines, wheels, lights...
More parts |
Get the Complete Technical Service Bulletins! |
Access diagrams and repair information such as wiring diagrams, diagnosis and repair charts, manufacturer service bulletins, and OEM Part numbers of your 2008 Toyota Yaris vehicle. |
Access the Complete guide! |