1998 Chevrolet C3500 Pickup Brake Service (ONLINE REPAIR MANUALS)

Removal

• Siphon ^2/3 of brake fluid from master cylinder reservoir serving front disc brakes.
• Raise and support vehicle, then remove wheel and tire assemblies.
• Bottom caliper piston in bore by inserting suitable screwdriver between inboard shoe and piston, then pry piston back into bore or by using suitable large C-clamp, Fig. .
• Remove support key retaining screw.
• Drive caliper support key and spring from steering knuckle with suitable drift and hammer, Fig. .
• Lift caliper from anchor plate and off rotor, Fig. . Hang caliper from coil spring with wire. Do not allow caliper to hang from ...

In order to properly service power brake systems, a thorough understanding of the power assist system is necessary. These systems provide a mechanical assist, acting to increase the force applied to the master cylinder piston by the driver while decreasing the effort necessary to obtain acceptable stopping performance.

Hydraulic assist units incorporate a basic open center spool valve, hydraulic cylinder and an accumulator assembly in a common housing. When the brake pedal is depressed, the hydraulic piston moves forward closing off fluid relief passages, the spool valve applies flui...

Height Sensing Proportioning Valve

The height sensing proportioning valve must be adjusted whenever the valve and/or linkage is disassembled or removed for service. In addition, adjustment should be checked if excessive front wheel lock-up is experienced with a lower than desired brake application rate when vehicle is at or near maximum GVWR.

• Raise and support vehicle, leave wheels on and allow axle to hang freely.
• Remove lever retaining nut and disconnect lever from valve shaft, Fig. .
• Rotate valve shaft to permit installation of correct adjustment gauge, Fig. , ensure D shaped ho...

Master Cylinder

Some vehicles use a conventional tandem master cylinder with two hydraulic pistons operating in-line. The primary piston controls the front brake system and the secondary piston controls the rear brake system.

Other models use a master cylinder that operates the same as the conventional master cylinder, but also incorporates a quick take-up feature in the rear chamber to reduce excessive pedal travel which may result from increased fluid displacement required to move the low drag caliper piston out against the rotor.

The quick take-up uses a spring-loaded ball check val...

Refer to "Troubleshooting," as outl...

When working on or around brake assemblies, care must be taken to prevent breathing asbestos dust, as many manufacturers incorporate asbestos fibers in the production of brake linings. During routine service operations, the amount of asbestos dust from brake lining wear is at a low level because of a chemical breakdown during use and a few precautions will minimize exposure. Do not sand or grind brake linings unless suitable local exhaust ventilation equipment is used to prevent ...