1995 GMC K3500 Pickup Brake Service (ONLINE REPAIR MANUALS)

Removal

• Siphon enough brake fluid out of the master cylinder to bring fluid level to ^1/3 full to avoid fluid overflow when the caliper piston is pushed back into its bore.
• Raise and support vehicle, remove front wheels.
• Using a C-clamp, Fig. , push piston back into its bore.
• Remove two mounting bolts and lift caliper away from disc.

Inspection

Should it become necessary to remove the caliper for installation of new parts, clean all parts in denatured alcohol, wipe dry using lint-free cloths. Using compressed air, blow out drilled passages and holes. Check dust boots for punctures or t...

In order to properly service power brake systems, a thorough understanding of the power assist system is necessary. These systems provide a mechanical assist, acting to increase the force applied to the master cylinder piston by the driver while decreasing the effort necessary to obtain acceptable stopping performance.

Hydraulic assist units incorporate a basic open center spool valve, hydraulic cylinder and an accumulator assembly in a common housing. When the brake pedal is depressed, the hydraulic piston moves forward closing off fluid relief passages, the spool valve applies flui...

Certain general service procedures apply, regardless of whether the brakes are vacuum or hydraulically assisted. Only top quality, clean brake fluid should be used. More seals and valves are used with power brake systems than with ordinary brakes, so an inferior brake fluid will do much more damage. For the same reason, be sure all dirt is kept out of the system. Additionally, care must be taken not to mix the fluids of the booster hydraulic system and brake hydraulic system as the fluids are not compatible.

If the power unit fails, the brakes will still operate, as the conventio...

Certain general service procedures apply, regardless of whether the brakes are vacuum or hydraulically assisted. Only top quality, clean brake fluid should be used. More seals and valves are used with power brake systems than with ordinary brakes, so an inferior brake fluid will do much more damage. For the same reason, be sure all dirt is kept out of the system. Additionally, on models with hydraulic assist brakes, care must be taken not to mix the fluids of the booster hydraulic system and brake hydraulic system as the fluids are not compatible.

If the power unit fails, the bra...

Except S & T Series w/VCM & VCM-A

This braking system, Figs. through , is designed to reduce the occurrence of wheel lock-up during severe braking conditions. To accomplish this function, the system regulates hydraulic brake line pressure by using an Electro-Hydraulic Control Unit (EHCU) module or a Brake Pressure Modulator Valve (BPMV). The EHCU/BPMV module has two types of valves: isolation valves, which maintain separate pressure for each front wheel and combine pressure for the rear wheels, and dump valves, which "dump" pressure to each front wheel separately and rear wheels comb...