1995 Chevrolet K1500 Pickup Brake Service (ONLINE REPAIR MANUALS)

Single Diaphragm Type

Disassemble

• Remove boot, silencer, vacuum check valve, grommet and front housing seal, Fig. .
• Scribe a line across front and rear housing, then mount brake booster to brake mounting fixture tool No. J 23456 or equivalent, Fig. .
• Turn fixture handle counterclockwise to unlock housings.
• Remove return spring, power piston assembly and power piston bearing from rear housing, Fig. .
• Remove reaction body retainer, piston rod, reaction retainer and filter.
• Remove power piston and pushrod assembly as follows:
• While holding the pushrod down against a hard surface, ...

2WD Models

• Raise and support vehicle.
• Remove tire and wheel assembly.
• Remove caliper as outlined under "Caliper Service."
• Remove grease cap from hub/rotor.
• Remove cotter pin, nut and washer.
• Remove hub/rotor from spindle, being careful not to damage spindle threads or outer bearing.
• Reverse procedure to install, noting the following:
• Apply high-temperature wheel bearing grease to inner and outer wheel bearings.
• Torque nut to 12 ft. lbs. while turning wheel assembly forward by hand, back...

Disassemble

• Place accumulator compressor tool No. J-26889 or equivalent, around end of accumulator.
• Install nut onto stud as shown in Fig. , then depress the accumulator with a C-clamp.
• Remove retainer by using a punch.
• Release C-clamp and remove accumulator compressor tool.
• Remove accumulator, O-ring, retainer, plug and spring, Fig. .
• Remove retainer, output pushrod, baffle, piston return spring and retainer.
• Using a suitable saw, cut off eyelet of pedal rod, then remove the boot.
• Remove nut, bracket and bolts, then separate cover from housing.
• Remove piston assembly and seals...

In order to properly service power brake systems, a thorough understanding of the various power assist systems is necessary. These systems provide a mechanical assist, acting to increase the force applied to the master cylinder piston by the driver while decreasing the effort necessary to obtain acceptable stopping performance. Two basic types of power assist mechanisms are used: vacuum assist diaphragm assemblies which use engine vacuum and in some cases vacuum from an external vacuum pump, and hydraulic assist assemblies which use hydraulic pressure developed by an external pump (...

Height Sensing Proportioning Valve

The height sensing proportioning valve must be adjusted whenever the valve and/or linkage is disassembled or removed for service. In addition, adjustment should be checked if excessive front wheel lock-up is experienced with a lower than desired brake application rate when vehicle is at or near maximum GVWR.

• Raise and support vehicle leaving wheels on, and allow axle to hang freely.
• Remove lever retaining nut and disconnect lever from valve shaft, Fig. .
• Rotate valve shaft to permit installation of correct adjustment gauge, Fig. , ensuring that D shape...

Removal

• Remove caliper assembly as outlined above.
• Remove inboard pad with retainer spring. Dislodge outboard pad and position caliper on the front suspension so the brake hose will not support the weight of the caliper.
• Remove two sleeves from inboard ears of the caliper.
• Remove four rubber bushings from the grooves in each of the caliper ears.

Installation

• Lubricate new sleeves, rubber bushings, bushing grooves and mounting bolt ends with Delco Silicone Lube or equivalent.
• Install new bushings and sleeves in caliper ears. Position the sleeve so that the end toward the pad is flush ...