Auto Parts Search
Automotix DIY provides automotive consumers and do it yourselfers; the most comprehensive repair information about 2007 Saturn Outlook car and truck
repair procedures including Saturn engine diagrams, wiring diagrams, repair work estimating measures, technical service bulletins, auto body work
guidance, starter & alternator replacement procedures, serpentine belt replacement procedures, radiator & hose replacement procedures, tune-up &
drivability specifications, quick lube illustrations, preventive maintenance guide, engine light reset instructions, parts removal and install
procedures, fuel filter replacement directions, component location diagrams, air filter locations & replacement instructions, a/c
system specifications, and general auto service procedures. You don't have to be a car mechanic or technician to know how to fix
your 2007 Saturn Outlook automobile. Try the Automotix DIY solution today!
We have info for following modifications of 2007 Saturn Outlook
- 2007 Saturn Outlook XR 3.6 V6 GAS, CID:217, Fuel Injection, Aspiration:217, Engine VIN:, Desg:7
- 2007 Saturn Outlook XE 3.6 V6 GAS, CID:217, Fuel Injection, Aspiration:217, Engine VIN:, Desg:7
DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES FOR 2007 Saturn Outlook AUTOMOBILES
Includes CV axle, universal joint, and driveline replacement, for domestic and imported 2007 Saturn Outlook cars and light trucks from 1990+.
DRIVESHAFT, Replace
Vehicle: 2007 Saturn Outlook XE 3.6 V6 GAS
- Raise and support vehicle.
- Mark relationship of front propeller shaft to transfer case drive flange.
- Mark relationship of rear propeller shaft to rear differential yoke.
- Remove mounting bolts and propeller shaft bolts from rear differential drive flange.
- Support propeller shaft at rear differential.
- Remove propeller shaft bolts and washers.
- Remove propeller shaft from transfer case flange. If propeller shaft cannot be removed, proceed as follows to prevent damage to propeller shaft:
- Place a brass drift or punch on propeller shaft between one of the notches in the transfer case driv...
CLICK HERE TO GET FULL ACCESS TO 2007 Saturn Outlook DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES
DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES FOR 2007 Saturn Outlook AUTOMOBILES
Includes CV axle, universal joint, and driveline replacement, for domestic and imported 2007 Saturn Outlook cars and light trucks from 1990+.
CV AXLE SHAFT, Replace -> Front -> Install -> Rear -> Remove
Vehicle: 2007 Saturn Outlook XR 3.6 V6 GAS
Front
To prevent personal injury and/or component damage, do not allow the weight of the vehicle to load the front wheels, or attempt to operate the vehicle, when the wheel drive shaft(s) or wheel drive shaft nut(s) are removed. To do so may cause the inner bearing race to separate, resulting in damage to brake and suspension components and loss of vehicle control.
Wheel drive shaft boots, seals and clamps should be protected from sharp objects any time service is performed on or near the wheel drive shaft(s). Damage to the boot(s), the seal(s) or the clamp(s) may cause lub...
CLICK HERE TO GET FULL ACCESS TO 2007 Saturn Outlook DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES
DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES FOR 2007 Saturn Outlook AUTOMOBILES
Includes CV axle, universal joint, and driveline replacement, for domestic and imported 2007 Saturn Outlook cars and light trucks from 1990+.
CV AXLE SHAFT, Replace -> Front -> Install -> Rear -> Remove
Vehicle: 2007 Saturn Outlook XE 3.6 V6 GAS
Front
To prevent personal injury and/or component damage, do not allow the weight of the vehicle to load the front wheels, or attempt to operate the vehicle, when the wheel drive shaft(s) or wheel drive shaft nut(s) are removed. To do so may cause the inner bearing race to separate, resulting in damage to brake and suspension components and loss of vehicle control.
Wheel drive shaft boots, seals and clamps should be protected from sharp objects any time service is performed on or near the wheel drive shaft(s). Damage to the boot(s), the seal(s) or the clamp(s) may cause lub...
CLICK HERE TO GET FULL ACCESS TO 2007 Saturn Outlook DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES
DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES FOR 2007 Saturn Outlook AUTOMOBILES
Includes CV axle, universal joint, and driveline replacement, for domestic and imported 2007 Saturn Outlook cars and light trucks from 1990+.
DRIVESHAFT U-JOINT, Replace -> Assemble -> Disassemble
Vehicle: 2007 Saturn Outlook XE 3.6 V6 GAS
Never clamp propeller shaft tubing in a vise. Clamping could dent or deform the tube causing an imbalance or unsafe condition. Always clamp on one of the yokes and support the shaft horizontally. Avoid damaging the slip yoke sealing surface. Nicks may damage the bushing or cut the lip seal.
Disassemble
- Support propeller shaft in a line horizontal with table of a press.
- Mark propeller shaft in order to show which end connects to transmission and which end goes to rear axle.
- On models equipped with external snap ring retainers, proceed as follows:
- Disassemble snap rings by ...
CLICK HERE TO GET FULL ACCESS TO 2007 Saturn Outlook DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES
DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES FOR 2007 Saturn Outlook AUTOMOBILES
Includes CV axle, universal joint, and driveline replacement, for domestic and imported 2007 Saturn Outlook cars and light trucks from 1990+.
DRIVESHAFT, Replace
Vehicle: 2007 Saturn Outlook XR 3.6 V6 GAS
- Raise and support vehicle.
- Mark relationship of front propeller shaft to transfer case drive flange.
- Mark relationship of rear propeller shaft to rear differential yoke.
- Remove mounting bolts and propeller shaft bolts from rear differential drive flange.
- Support propeller shaft at rear differential.
- Remove propeller shaft bolts and washers.
- Remove propeller shaft from transfer case flange. If propeller shaft cannot be removed, proceed as follows to prevent damage to propeller shaft:
- Place a brass drift or punch on propeller shaft between one of the notches in the transfer case driv...
CLICK HERE TO GET FULL ACCESS TO 2007 Saturn Outlook DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES
DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES FOR 2007 Saturn Outlook AUTOMOBILES
Includes CV axle, universal joint, and driveline replacement, for domestic and imported 2007 Saturn Outlook cars and light trucks from 1990+.
DRIVESHAFT U-JOINT, Replace -> Assemble -> Disassemble
Vehicle: 2007 Saturn Outlook XR 3.6 V6 GAS
Never clamp propeller shaft tubing in a vise. Clamping could dent or deform the tube causing an imbalance or unsafe condition. Always clamp on one of the yokes and support the shaft horizontally. Avoid damaging the slip yoke sealing surface. Nicks may damage the bushing or cut the lip seal.
Disassemble
- Support propeller shaft in a line horizontal with table of a press.
- Mark propeller shaft in order to show which end connects to transmission and which end goes to rear axle.
- On models equipped with external snap ring retainers, proceed as follows:
- Disassemble snap rings by ...
CLICK HERE TO GET FULL ACCESS TO 2007 Saturn Outlook DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES
Shop online for auto body parts, engines, wheels, lights...
| More parts |
| Get the Complete Technical Service Bulletins! |
 Access diagrams and repair information such as wiring diagrams,
diagnosis and repair charts, manufacturer
service bulletins, and OEM Part
numbers of your 2007 Saturn Outlook vehicle.
|
| Access the Complete guide! |
