Auto Parts Search
DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES FOR 2007 Lincoln Mark LT AUTOMOBILES
Includes CV axle, universal joint, and driveline replacement, for domestic and imported 2007 Lincoln Mark LT cars and light trucks from 1990+.
CV AXLE SHAFT, Replace -> Front
Vehicle: 2007 Lincoln Mark LT 5.4 V8 GAS
Front
- With vehicle in NEUTRAL, position on a hoist.
- Remove the front wheel and tire assembly.
- Remove dust cap and nut from axle halfshaft.
- Remove upper ball joint nut and separate ball joint from steering knuckle.
- Remove wheel end retaining bolts from CV shaft.
- Remove CV shaft flange retaining bolts.
- Remove CV shaft from vehicle.
- Rev...
CLICK HERE TO GET FULL ACCESS TO 2007 Lincoln Mark LT DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES
DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES FOR 2007 Lincoln Mark LT AUTOMOBILES
Includes CV axle, universal joint, and driveline replacement, for domestic and imported 2007 Lincoln Mark LT cars and light trucks from 1990+.
DRIVESHAFT U-JOINT, Replace -> Assemble -> Disassemble -> Double Cardan -> Single Cardan, Flange Yoke -> Single Cardan, Slip Yoke
Vehicle: 2007 Lincoln Mark LT 5.4 V8 GAS
Single Cardan, Slip Yoke
Disassemble
Do not, under any circumstance, clamp the shaft in the jaws of a vise or similar holding fixture. Denting or localizing fracture can result, causing shaft failure during vehicle operation. Place the shaft on a suitable workbench. Do not damage the tube. If components are not marked and installed incorrectly, driveline imbalance can occur.
- Index-mark the shaft components.
- Remove and discard all four snap rings.
- Clamp bearing cup removal tool No. 205-086 or equivalent in a vise.
- If necessary, use a pair of pliers to remove a bearing cup t...
CLICK HERE TO GET FULL ACCESS TO 2007 Lincoln Mark LT DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES
DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES FOR 2007 Lincoln Mark LT AUTOMOBILES
Includes CV axle, universal joint, and driveline replacement, for domestic and imported 2007 Lincoln Mark LT cars and light trucks from 1990+.
DRIVESHAFT, Replace -> Front -> One Piece Driveshaft -> Rear -> Three Piece Driveshaft -> Two Piece Driveshaft
Vehicle: 2007 Lincoln Mark LT 5.4 V8 GAS
Front
- Raise and support the vehicle.
- Index-mark front driveshaft to front axle flange and at transfer case flange.
- Remove and discard bolts and U-joint retainers.
- Remove and discard four flange bolts.
- Compress and separate front driveshaft from front axle, then separate driveshaft from transfer case. Wrap electrical tape around the bearing cups to prevent them from falling off the U-joint spider.
- Reverse procedure to install, noting the following:
- Torque flange bolts to 76 ft. lbs.
- Torque U-joint retainer bolts to 26 ft. lbs., if equipped.
Rear
One Piece Driveshaft
- Raise and support ve...
CLICK HERE TO GET FULL ACCESS TO 2007 Lincoln Mark LT DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES
Shop online for auto body parts, engines, wheels, lights...
More parts |
Get the Complete Technical Service Bulletins! |
Access diagrams and repair information such as wiring diagrams, diagnosis and repair charts, manufacturer service bulletins, and OEM Part numbers of your 2007 Lincoln Mark LT vehicle. |
Access the Complete guide! |