Auto Parts Search
We have info for following modifications of 2007 Ford Escape
- 2007 Ford Escape Hybrid 2.3 L4 ELECTRIC/GAS, CID:140, Fuel Injection, Aspiration:140, Engine VIN:, Desg:H
- 2007 Ford Escape XLT 2.3 L4 GAS, CID:140, Fuel Injection, Aspiration:140, Engine VIN:, Desg:Z
- 2007 Ford Escape XLT 3.0 V6 GAS, CID:183, Fuel Injection, Aspiration:183, Engine VIN:, Desg:1
- 2007 Ford Escape XLS 2.3 L4 GAS, CID:140, Fuel Injection, Aspiration:140, Engine VIN:, Desg:Z
- 2007 Ford Escape Limited 3.0 V6 GAS, CID:183, Fuel Injection, Aspiration:183, Engine VIN:, Desg:1
BRAKE SERVICE PROCEDURES FOR 2007 Ford Escape AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2007 Ford Escape cars and light trucks from 1990+.
Anti-Lock Brakes -> Escape & Mariner -> Diagnosis & Testing -> Accessing Diagnostic Trouble Codes -> Clearing Diagnostic Trouble Codes -> Diagnostic Tests -> Diagnostic Trouble Code Interpretation -> Inspection & Verification -> Pinpoint Tests
Vehicle: 2007 Ford Escape XLT 2.3 L4 GAS
Accessing Diagnostic Trouble Codes
Connect a suitably programmed scan tool and Vehicle Communication Module (VCM) with appropriate adapters, or equivalents, to the Data Link Connector (DCL) located in the passenger compartment beneath the instrument panel. Follow tool manufacturer's instructions for accessing Diagnostic Trouble Codes (DTC).
Diagnostic Trouble Code Interpretation
Refer to Figs. and for diagnostic trouble code interpretation.
Diagnostic Tests
Inspection & Verification
Verify concern by applying brakes under different conditions. Inspect for obvious sign...
[[table data]]CLICK HERE TO GET FULL ACCESS TO 2007 Ford Escape BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2007 Ford Escape AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2007 Ford Escape cars and light trucks from 1990+.
Anti-Lock Brakes -> Escape & Mariner -> Description -> Regenerative Braking System -> System Operation
Vehicle: 2007 Ford Escape Limited 3.0 V6 GAS
System Operation
The anti-lock brake system (ABS) module, with or without stability assist, simultaneously manages the anti-lock braking, traction control and engine control systems to maintain vehicle control during deceleration and acceleration. The ABS accomplishes this by communicating with the other modules over the high speed controller area network (HS-CAN) bus.
When the ignition switch is in the RUN position, the module carries out a preliminary electrical check and, at approximately 20 km/h (12 mph), the hydraulic pump motor is turned on for approximately one half-second. An...
CLICK HERE TO GET FULL ACCESS TO 2007 Ford Escape BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2007 Ford Escape AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2007 Ford Escape cars and light trucks from 1990+.
Disc Brakes -> Caliper Service -> Assemble -> Cleaning & Inspection -> Disassemble -> E-150, E-250, E-350 & E-450 -> E-150, E-250, E-350 & E-550 -> E-450 -> E-550 -> E-Series -> Edge & MKX -> Escape & Mariner -> Expedition & Navigator -> Expedition, F-Super Duty, Motorhome & Navigator -> Explorer & Mountaineer -> Explorer Sport/Sport Trac -> Explorer, Explorer Sport/Sport Trac, Mountaineer & Ranger -> F-150 & Mark LT -> F-Super Duty & Motorhome -> Freestar & Monterey -> Front -> Inspection -> Installation -> Overhaul -> Ranger -> Rear -> Removal -> Replacement
Vehicle: 2007 Ford Escape Limited 3.0 V6 GAS
Replacement
Edge & MKX
- Syphon and discard a portion of brake fluid from master cylinder.
- Raise and support vehicle, then remove wheel and tire assembly.
- Position frame side of C-clamp on inboard side of disc brake caliper. Do not place clamp frame over front brake hose.
- Position screw side of C-clamp on outboard brake shoe and lining, then tighten C-clamp until there is enough clearance to remove caliper.
- Remove front brake hose flow bolt, then disconnect and plug front brake hose. Discard copper washers.
- Remove two caliper slide pins.
- Slide brake shoe and lining out of front disc brake...
CLICK HERE TO GET FULL ACCESS TO 2007 Ford Escape BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2007 Ford Escape AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2007 Ford Escape cars and light trucks from 1990+.
Disc Brakes -> Brake Pad Service
Vehicle: 2007 Ford Escape XLT 3.0 V6 GAS
- Remove and discard a portion of brake fluid from master cylinder.
- Raise and support vehicle, then remove wheel and tire assembly.
- Unclip speed sensor wiring from brake ho...
CLICK HERE TO GET FULL ACCESS TO 2007 Ford Escape BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2007 Ford Escape AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2007 Ford Escape cars and light trucks from 1990+.
Hydraulic Brake Systems -> Diagnosis & Testing
Vehicle: 2007 Ford Escape Hybrid 2.3 L4 ELECTRIC/GAS
Refer to Figs. and f...
CLICK HERE TO GET FULL ACCESS TO 2007 Ford Escape BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2007 Ford Escape AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2007 Ford Escape cars and light trucks from 1990+.
Hydraulic Brake Systems -> Description -> Bendix Hydro-Boost Brake Booster -> Bendix Hydro-Max Brake Booster -> Combination Valve -> Height Sensing Proportioning Valve -> Hydraulic Control Unit (HCU) -> Hydraulic Control Valves -> Integral Bypass Proportioning Valve -> Master Cylinder
Vehicle: 2007 Ford Escape XLT 3.0 V6 GAS
Master Cylinder
The master cylinder consists primarily of a hydraulic cylinder, primary and secondary hydraulic pistons and a single or dual chamber fluid reservoir. The front brakes are connected to the primary outlet port(s) and are actuated by the primary piston assembly. The rear brakes are connected to the secondary outlet port and are actuated by the secondary piston assembly.
Hydraulic Control Valves
Combination Valve
This multi-function hydraulic control unit consists primarily of a pressure differential valve, brake lamp warning switch and a proportioning valve. A pressure diff...
CLICK HERE TO GET FULL ACCESS TO 2007 Ford Escape BRAKE SERVICE PROCEDURES
Shop online for auto body parts, engines, wheels, lights...
More parts |
Get the Complete Technical Service Bulletins! |
Access diagrams and repair information such as wiring diagrams, diagnosis and repair charts, manufacturer service bulletins, and OEM Part numbers of your 2007 Ford Escape vehicle. |
Access the Complete guide! |