Auto Parts Search
2005 Nissan Murano CAR/TRUCK REPAIR PROCEDURES AND DIAGRAMS - WHAT Nissan REPAIR SHOPS DON'T WANT YOU TO KNOW
Learn how to repair a car or truck, install or remove parts, wire an engine, reset warning lights, replace fuel filter, fix auto body and more. Get Automotix DIY!Select Section
- Component Locations
- Wiring Diagrams
- Technical Service Bulletins
- Specifications
- Brake Service
- Fuel Filter Replacement
- Driveline, U-Joint & CV Axles Replacement
- Tire Pressure Monitoring System
- Starter & Alternator Replacement
- Cabin Air Filter Locations & Replacement
- Maintenance Lamp Reset
- Radiator & Hose Replacement
- Serpentine Belt Service
BRAKE SERVICE PROCEDURES FOR 2005 Nissan Murano AUTOMOBILES
Nissan -> Power Brake Units -> Power Brake Unit Service
Vehicle: 2005 Nissan Murano SL 3.5 V6 GAS
These units cannot be ov...
CLICK HERE TO GET FULL ACCESS TO 2005 Nissan Murano BRAKE SERVICE PROCEDURES
FUEL FILTER REPLACEMENT PROCEDURES FOR 2005 Nissan Murano AUTOMOBILES
Nissan/Datsun -> Fuel Filter Replacement -> 2003-06 Murano, 350Z & 2002-06 Altima -> Fuel System Pressure Relief -> Removal & Installation
Vehicle: 2005 Nissan Murano SL 3.5 V6 GAS
Fuel System Pressure Relief
- Remove the fuel pump fuse from the fuse panel.
- Start and run the engine until it stalls.
- After the engine stalls, crank two or three times to ensure all fuel pressure is relieved.
- Turn the ignition Off, then install the fuel pump fuse.
Removal & Installation
Do not smoke or allow an open flame of any type when working on or near any fuel system related components. The highly flammable vapor mixtures may ignite, resulting in serious personal injury.
Prior to disconnecting fuel lines, the fuel system pressure must be relieved to prevent a...
CLICK HERE TO GET FULL ACCESS TO 2005 Nissan Murano FUEL FILTER REPLACEMENT PROCEDURES
DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES FOR 2005 Nissan Murano AUTOMOBILES
CV AXLE SHAFT, Replace -> Front -> Left Side -> Right Side
Vehicle: 2005 Nissan Murano SL 3.5 V6 GAS
Front
Left Side
- Raise and support vehicle and support it with safety stands in proper locations.
- Remove wheel nuts and front tire.
- Remove ABS wheel sensor from steering knuckle.
- Remove cotter pin and wheel bearing locknut. Discard old cotter pin and install new one upon installation
- Remove brake hose lock plate and remove hose from strut assembly.
- Remove strut assembly and steering knuckle bolt and nut.
- Remove driveshaft from steering knuckle. When removing driveshaft do not apply an excessive angle to driveshaft joint. Be careful not to excessively extend slide joint.
- Remove dr...
CLICK HERE TO GET FULL ACCESS TO 2005 Nissan Murano DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES
TIRE PRESSURE MONITORING SYSTEM PROCEDURES FOR 2005 Nissan Murano AUTOMOBILES
Description
Vehicle: 2005 Nissan Murano SL 3.5 V6 GAS
The TPMS (Tire Pressure Monitor System) is controlled by the Body Control Module (BCM). The BCM receives its tire pressure signal from the remote keyless entry receiver. The remote keyless entry receiver receives i...
CLICK HERE TO GET FULL ACCESS TO 2005 Nissan Murano TIRE PRESSURE MONITORING SYSTEM PROCEDURES
STARTER & ALTERNATOR REPLACEMENT PROCEDURES FOR 2005 Nissan Murano AUTOMOBILES
Starter, Replace
Vehicle: 2005 Nissan Murano SL 3.5 V6 GAS
- Disconnect battery ground cable.
- Raise and support vehicle.
- Remove engine front and rear undercovers.
- Disconnect electrical connectors from starter motor.
- Loosen transmission fluid cooler tube c...
CLICK HERE TO GET FULL ACCESS TO 2005 Nissan Murano STARTER & ALTERNATOR REPLACEMENT PROCEDURES
CABIN AIR FILTER LOCATIONS & REPLACEMENT PROCEDURES FOR 2005 Nissan Murano AUTOMOBILES
Cabin Air Filter Service -> Nissan -> 2003-07 Murano
Vehicle: 2005 Nissan Murano SE 3.5 V6 GAS
Under normal operating conditions the cabin air filter should be replaced every 12 months or 15,000 miles. In dusty areas change the cabin air filter more often.
- Open the glove compartment.
- Remove the two glove compartment striker retaining screws, Fig. .
- Remove the two glove compartment retaining screws, then disengage the retaining clip and pawl.
- Lift the glove compartment and lower panel from the instrument panel, then...
CLICK HERE TO GET FULL ACCESS TO 2005 Nissan Murano CABIN AIR FILTER LOCATIONS & REPLACEMENT PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2005 Nissan Murano AUTOMOBILES
Nissan -> Automatic Transmission (AT) Check Engine Lamp ->
Vehicle: 2005 Nissan Murano SL 3.5 V6 GAS
The Automatic Transmission (AT) Check lamp will be illuminated for approximately 2 seconds when the ignition switch is placed in the on position as a bulb check and then go Off. If it remains lit or comes on at any other time, a malfunction in the a...
CLICK HERE TO GET FULL ACCESS TO 2005 Nissan Murano MAINTENANCE LAMP RESET PROCEDURES
RADIATOR & HOSE REPLACEMENT PROCEDURES FOR 2005 Nissan Murano AUTOMOBILES
Coolant Hose, Replace -> Lower -> Upper
Vehicle: 2005 Nissan Murano SE 3.5 V6 GAS
Lower
- Disconnect battery ground cable.
- Drain cooling system into a suitable container by loosening drain plug of radiator.
- Reposition hose clamp at radiator outlet.
- Remove hose from radiator.
- Reposition hose clamp at thermostat housing.
- Remove hose from thermostat housing.
- Remove hose from vehicle.
- Reverse proc...
CLICK HERE TO GET FULL ACCESS TO 2005 Nissan Murano RADIATOR & HOSE REPLACEMENT PROCEDURES
SERPENTINE BELT SERVICE PROCEDURES FOR 2005 Nissan Murano AUTOMOBILES
Serpentine Drive Belt, Replace
Vehicle: 2005 Nissan Murano SE 3.5 V6 GAS
- Rotate or lift the belt tensioner arm, using a suitable tool to relieve tension from dr...
CLICK HERE TO GET FULL ACCESS TO 2005 Nissan Murano SERPENTINE BELT SERVICE PROCEDURES
COMPONENT LOCATION DIAGRAMS FOR 2005 Nissan Murano AUTOMOBILES
Component location diagrams for most 2005 Nissan Murano cars and light trucks sold in the U.S. from 1990+.
Shift Lock System Electrical Parts Locations Diagram for 2005 Nissan Murano SE 3.5 V6 GAS Components on diagram: |
Component Parts And Harness Connector Locations Diagram for 2005 Nissan Murano SL 3.5 V6 GAS Components on diagram: |
CLICK HERE TO GET FULL ACCESS TO 2005 Nissan Murano PARTS/COMPONENTS LOCATION DIAGRAMS!
WIRING DIAGRAMS FOR 2005 Nissan Murano AUTOMOBILES
OEM drawn wiring diagrams for most 2005 Nissan Murano cars and light trucks sold in the U.S.
2005 Nissan Murano S 3.5 V6 GAS Wiring Diagram Components on diagram: |
2005 Nissan Murano SE 3.5 V6 GAS Wiring Diagram Components on diagram: |
CLICK HERE TO GET FULL ACCESS TO 2005 Nissan Murano WIRING DIAGRAMS!
TECHNICAL SERVICE BULLETINS FOR 2005 Nissan Murano AUTOMOBILES
OEM TSB listings for most 2005 Nissan Murano cars and light trucks sold in the U.S. from 1985+.
Document: A/C SYSTEM O-RING SEAL LEAKS Vehicle: 2005 Nissan Murano S 3.5 V6 GAS Auto Systems: |
Document: SUNROOF INOPERATIVE Vehicle: 2005 Nissan Murano S 3.5 V6 GAS |
CLICK HERE TO GET FULL ACCESS TO 2005 Nissan Murano TECHNICAL SERVICE BULLETINS!
COMPONENT/PARTS SPECIFICATIONS FOR 2005 Nissan Murano AUTOMOBILES
BRAKE SPECIFICATIONS: Brake drum, rotor, caliper, and related specifications for most 2005 Nissan Murano cars and light trucks sold in the U.S. and Canada from 1970+.
- Brake caliper mounting bolt torque
- Brake drum runout, machining, & discard specs
- Minimum brake lining thickness.
- Brake rotor runout, parallelism, machining, discard, & finish specs
A/C SYSTEM SPECIFICATIONS: Air conditioning refrigerant capacity and type as well as lubricant capacity for most 2005 Nissan Murano cars and light trucks sold in the U.S. and Canada from 1980+.
- Refrigerant capacity & type, compressor oil viscosity, total system oil capacity & compressor clutch gap
COOLING SYSTEM BLEED: Cooling system bleeder valve identification, bleeder type and bleed procedures for most domestic and imported cars and light trucks sold in the U.S. and Canada from 1986+.
PREVENTIVE MAINTENANCE: Preventive maintenance recommendations and required services for most domestic and imported cars and light trucks sold in the U.S. and Canada from 1980+. Includes severe and routine service schedules
QUICK-LUBE and ILLUSTRATIONS: Fluid recommendations, capacities, drain plug torques, tire data, and severe service recommended preventive maintenance schedules. Information covers most 2005 Nissan Murano cars and light trucks sold in the U.S. and Canada from 1980+. Engine and chassis service images.
- Automatic transmission/transaxles capacities, lubricant recommendations
- Differential/final drive capacities, lube recommendations, grades, & viscosities
- Final drive fill & drain plug torques
- Number of lubrication fittings & plugs
- Power steering, brake, & clutch fluid recommendations
- Manual transmission/transaxle capacities, lube recommendations, grades, & viscosities
- Number of lubrication fittings & plugs
- Power steering, brake, & clutch fluid recommendations
- Engine oil capacities, API grade recommendations, SAE viscosity recommendations, drain plug torque
- Severe service maintenance & interval recommendations
- Tire sizes, wheel nut/bolt torque, pressures & rim sizes
- Transfer case capacities, lube recommendations, grades, & viscosities
TUNE-UP & DRIVEABILITY SPECIFICATIONS: Most tune-up specifications for most 2005 Nissan Murano cars and light trucks sold in the U.S. and Canada from 1980+
- Airflow sensor electrical specifications
- Tensioning specifications for systems with automatic tensioners
- Barometric pressure sensor specs
- Battery group number and cranking performance
- Crankshaft & camshaft position sensor resistance
- Engine compression pressures
- Coolant temperature sensor specs
- Computer advance.
- Diesel fuel temperature sensor resistance.
- Distributor advance specifications
- Ignition pickup coil resistance
- Exhaust gas recirculation temperature sensor resistance
- Engine fastener torque values
- Firing order diagrams
- Fuel system pressures
- Generator (alternator) specs
- Intake air temperature sensor specs
- Ignition coil specifications
- Fuel injector resistance
- Engine idle speeds
- Knock sensor resistance
- Manifold absolute pressure sensor specs
- Mixture control solenoid resistance
- Voltage regulator specs
- Spark plug applications & gaps
- Starter motor electrical specs.
- Tensioning specifications for systems without automatic tensioners
- Throttle body temperature sensor resistance
- Ignition timing in degrees at rpm
- Transmission oil temperature sensor resistance
- Throttle position sensor specs
- Vacuum sensor valve specs
CLICK HERE TO GET FULL ACCESS TO 2005 Nissan Murano SPECIFICATIONS DATA!
Shop online for auto body parts, engines, wheels, lights...
More parts |
Get the Complete Technical Service Bulletins! |
Access diagrams and repair information such as wiring diagrams, diagnosis and repair charts, manufacturer service bulletins, and OEM Part numbers of your 2005 Nissan Murano vehicle. |
Access the Complete guide! |