Auto Parts Search
We have info for following modifications of 2003 Toyota RAV4
- 2003 Toyota RAV4 2.0 L4 GAS, CC:1998, Fuel Injection
- 2003 Toyota RAV4 L ELECTRIC, Engine VIN:, Desg:S
BRAKE SERVICE PROCEDURES FOR 2003 Toyota RAV4 AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2003 Toyota RAV4 cars and light trucks from 1990+.
Toyota -> Drum Brakes -> Precautions -> Audio Coded Anti-Theft System
Vehicle: 2003 Toyota RAV4 2.0 L4 GAS
Audio Coded Anti-Theft System
Some models are equipped with an audio coded anti-theft system that will disable the radio when the battery cable is disconnected. The system can be identified by the "ANTI-THEFT SYSTEM" on the cassette tape lid. Obtain 3 digit customer code for input. Reset system after service as follows:
- Obtain 3 digit audio anti-theft code.
- Depress 1 (PROG) while depressing righthand side of TUNE SEEK button, - - - will appear in tape operation display.
- To enter the first digit, depress 1 (PROG) button repeatedly until the number of times depressed equals the first digit ...
CLICK HERE TO GET FULL ACCESS TO 2003 Toyota RAV4 BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2003 Toyota RAV4 AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2003 Toyota RAV4 cars and light trucks from 1990+.
Toyota -> Hydraulic Brake Systems -> Brake System Bleed -> Brake Lines -> Master Cylinder
Vehicle: 2003 Toyota RAV4 L ELECTRIC
Master Cylinder
- Fill reservoir with fluid.
- Disconnect tubes from master cylinder. Then slowly depress brake pedal and hold.
- Block off outlet holes with fingers, and release pedal. Repeat three or four times.
Brake Lines
Bleed wheel with longest brake line first, then work your way...
CLICK HERE TO GET FULL ACCESS TO 2003 Toyota RAV4 BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2003 Toyota RAV4 AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2003 Toyota RAV4 cars and light trucks from 1990+.
Toyota -> Power Brake Units -> Adjustments -> Brake Pedal Height & Freeplay
Vehicle: 2003 Toyota RAV4 2.0 L4 GAS
Brake Pedal Height & Freeplay
Refer to Fig. for pedal height and freeplay references.
- Loosen stop light switch, then the clevis locknut.
- Adjust pedal height by turning pushrod.
- Tighten locknut an...
CLICK HERE TO GET FULL ACCESS TO 2003 Toyota RAV4 BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2003 Toyota RAV4 AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2003 Toyota RAV4 cars and light trucks from 1990+.
Toyota -> Power Brake Units -> Troubleshooting
Vehicle: 2003 Toyota RAV4 2.0 L4 GAS
Refer to Fig. for gener...
CLICK HERE TO GET FULL ACCESS TO 2003 Toyota RAV4 BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2003 Toyota RAV4 AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2003 Toyota RAV4 cars and light trucks from 1990+.
Toyota -> Hydraulic Brake Systems -> Component Service -> Assemble -> Disassemble -> Except Sienna -> Inspection -> Master Cylinder -> Overhaul -> Sienna -> Wheel Cylinders
Vehicle: 2003 Toyota RAV4 L ELECTRIC
Master Cylinder
Except Sienna
Disassemble
For the following procedures, refer to Fig. for assistance.
- Remove master cylinder boot.
- Remove setscrew and reservoir tank, then the cap and strainer from reservoir.
- Remove two grommets and place cylinder in vise.
- Push piston in and remove stopper bolt, Fig. .
- Push pistons in and remove snap ring, then No. 1 piston carefully by hand.
- Place cylinder on edges of two wooden blocks and tap on cylinder until No. 2 piston comes out.
Inspection
Clean components with compressed air. Inspect cylinder bore for rust and scoring. Also, inspect for wear or ...
CLICK HERE TO GET FULL ACCESS TO 2003 Toyota RAV4 BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2003 Toyota RAV4 AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2003 Toyota RAV4 cars and light trucks from 1990+.
Toyota -> Hydraulic Brake Systems -> Component Replacement -> Except Land Cruiser & 4Runner -> Except Sienna -> Land Cruiser & 4Runner -> Master Cylinder -> Models w/Load Sensing Proportioning Valve (LSPV) -> Models w/Proportioning & Bypass Valve (P-BV) -> Proportioning Valve -> Sienna -> Wheel Cylinders
Vehicle: 2003 Toyota RAV4 2.0 L4 GAS
Master Cylinder
Except Sienna
- Remove brake fluid with syringe.
- On RAV4 models, remove air cleaner cover with air cleaner hose.
- On all models, label and disconnect brake lines using line wrench 09751-36011, 09023-00100, or equivalent. Cap brake lines from master cylinder.
- Disconnect wire connector from brake pressure switch and then disconnect level warning switch connector, if equipped.
- Remove master cylinder to brake unit attaching nuts, then remove master cylinder, wire clamp, gasket and 3-way union, as needed.
- Reverse procedure to install. Bleed brake system.
Sienna
- Remove air c...
CLICK HERE TO GET FULL ACCESS TO 2003 Toyota RAV4 BRAKE SERVICE PROCEDURES
Shop online for auto body parts, engines, wheels, lights...
More parts |
Get the Complete Technical Service Bulletins! |
Access diagrams and repair information such as wiring diagrams, diagnosis and repair charts, manufacturer service bulletins, and OEM Part numbers of your 2003 Toyota RAV4 vehicle. |
Access the Complete guide! |