2002 Saturn VUE Brake Service (ONLINE REPAIR MANUALS)

Aztek & Rendezvous

• Remove coolant reservoir, then relieve fuel system pressure as outlined under. "Precautions."
• Remove cruise control cable from module, then disconnect electrical connector from cruise control module.
• Remove cruise control module from bracket, then the front end sheet metal diagonal brace.
• Remove PCM cover from air cleaner housing, then the PCM and set aside.
• Remove air cleaner intake duct, then bolts from air cleaner assembly and housing.
• Remove fuel lines from pipes and vapor line, then disconnect fluid level sensor switch from brake master cylinder.
• Disc...

Brake Lines & Linings

Remove one of the front wheels and inspect the brake disc, caliper and linings.

Do not allow any oil or grease on the linings. It is recommended that linings be replaced in sets when worn or damaged.

If the caliper is cracked or fluid leakage through the casting is evident, it must be replaced as a unit.

Brake Roughness

The most common cause of brake chatter on disc brakes is a variation in thickness of the disc. If roughness or vibration is encountered during highway operation or if pedal pumping is experienced at low speeds, the disc may have excessive thickness v...

Master Cylinder

Some vehicles use a conventional tandem master cylinder with two hydraulic pistons operating in-line. The primary piston controls the front brake system and the secondary piston controls the rear brake system.

Other models use a master cylinder that operates the same as the conventional master cylinder, but also incorporates a quick take-up feature in the rear chamber to reduce excessive pedal travel which may result from increased fluid displacement required to move the low drag caliper piston out against the rotor.

The quick take-up uses a spring-loaded ball check val...

In order to properly service power brake systems, a thorough understanding of the power assist system is required. These systems provide a mechanical assist, acting to increase the force applied to the master cylinder piston by the driver while decreasing the effort required to obtain acceptable stopping performance.

Hydraulic assist units incorporate a basic open center spool valve, hydraulic cylinder and an accumulator assembly in a common housing. When the brake pedal is depressed, the hydraulic piston moves forward closing off fluid relief passages, the spool valve applies fluid ...

Aztek & Rendezvous

• Remove coolant reservoir, then relieve fuel system pressure as outlined under. "Precautions."
• Remove cruise control cable from module, then disconnect electrical connector from cruise control module.
• Remove cruise control module from bracket, then the front end sheet metal diagonal brace.
• Remove PCM cover from air cleaner housing, then the PCM and set aside.
• Remove air cleaner intake duct, then bolts from air cleaner assembly and housing.
• Remove fuel lines from pipes and vapor line, then disconnect fluid level sensor switch from brake master cylinder.
• Disc...

Certain general service procedures apply, regardless of whether the brakes are vacuum or hydraulically assisted. Only top quality, clean brake fluid should be used. More seals and valves are used with power brake systems than with ordinary brakes, so an inferior brake fluid will do much more damage. For the same reason, ensure all dirt is kept out of the system. Additionally, on models with hydraulic assist brakes, care must be taken not to mix the fluids of the booster hydraulic system and brake hydraulic system as the fluids are not compatible.

If the power unit fails, the brak...