Auto Parts Search
2000 Chevrolet Tracker CAR/TRUCK REPAIR PROCEDURES AND DIAGRAMS - WHAT Chevrolet REPAIR SHOPS DON'T WANT YOU TO KNOW
Learn how to repair a car or truck, install or remove parts, wire an engine, reset warning lights, replace fuel filter, fix auto body and more. Get Automotix DIY!Select Section
- Component Locations
- Wiring Diagrams
- Technical Service Bulletins
- Specifications
- A/C & Heater Service
- Brake Service
- Fuel Filter Replacement
- Driveline, U-Joint & CV Axles Replacement
- Starter & Alternator Replacement
- Maintenance Lamp Reset
- Radiator & Hose Replacement
- Serpentine Belt Service
Automotix DIY provides automotive consumers and do it yourselfers; the most comprehensive repair information about 2000 Chevrolet Tracker car and truck
repair procedures including Chevrolet engine diagrams, wiring diagrams, repair work estimating measures, technical service bulletins, auto body work
guidance, starter & alternator replacement procedures, serpentine belt replacement procedures, radiator & hose replacement procedures, tune-up &
drivability specifications, quick lube illustrations, preventive maintenance guide, engine light reset instructions, parts removal and install
procedures, fuel filter replacement directions, component location diagrams, air filter locations & replacement instructions, a/c
system specifications, and general auto service procedures. You don't have to be a car mechanic or technician to know how to fix
your Chevrolet Tracker automobile. Try the Automotix DIY solution today!
A/C & HEATER SERVICE PROCEDURES FOR 2000 Chevrolet Tracker AUTOMOBILES
Electric Cooling Fans -> Light Duty Trucks & Vans -> Description -> C, K & P Series -> Montana, Silhouette, Trans Sport & Venture
Vehicle: 2000 Chevrolet Tracker 2.0 L4 GAS
Montana, Silhouette, Trans Sport & Venture
This fan is driven by an electric motor which is attached to the radiator support. The cooling fan is controlled by the PCM, based on inputs from the coolant temperature sensor, A/C fan control switch and vehicle speed. The PCM controls the fan through a ground circuit, which energizes the fan control relay, supplying voltage to the fan motor.
The PCM grounds the circuit when coolant temperature is over 223°F or when A/C is On.
C, K & P Ser...
CLICK HERE TO GET FULL ACCESS TO 2000 Chevrolet Tracker A/C & HEATER SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2000 Chevrolet Tracker AUTOMOBILES
Hydraulic Brake Systems -> Description -> Hydraulic Control Valves -> Master Cylinder
Vehicle: 2000 Chevrolet Tracker 1.6 L4 GAS
Master Cylinder
Some vehicles use a conventional tandem master cylinder with two hydraulic pistons operating in-line. The primary piston controls the front brake system and the secondary piston controls the rear brake system.
Other models use a master cylinder that operates the same as the conventional master cylinder, but also incorporates a quick take-up feature in the rear chamber to reduce excessive pedal travel which may result from increased fluid displacement required to move the low drag caliper piston out against the rotor.
The quick take-up uses a spring-loaded ball check val...
CLICK HERE TO GET FULL ACCESS TO 2000 Chevrolet Tracker BRAKE SERVICE PROCEDURES
FUEL FILTER REPLACEMENT PROCEDURES FOR 2000 Chevrolet Tracker AUTOMOBILES
General Motors Corp./Saturn Light Trucks, SUVs & Vans -> Fuel Filter Scheduled Maintenance -> Tracker -> Normal Service -> Severe Service
Vehicle: 2000 Chevrolet Tracker 1.6 L4 GAS
Normal Service
Replace every 30,000 m...
CLICK HERE TO GET FULL ACCESS TO 2000 Chevrolet Tracker FUEL FILTER REPLACEMENT PROCEDURES
DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES FOR 2000 Chevrolet Tracker AUTOMOBILES
CV AXLE SHAFT, Replace -> Left -> Right
Vehicle: 2000 Chevrolet Tracker 1.6 L4 GAS
Left
- Raise and support vehicle.
- Remove skid plate bolts and skid plate, if equipped.
- Remove front tire and wheel assembly.
- Remove the six hub flange bolts and flange.
- Remove drive axle shaft snap ring.
- Remove drive axle shaft spindle washer from drive axle shaft.
- Use a hydraulic jack in order to support the front control arm. To prevent personal injury and/or component damage, use the proper tools to support the lower control arm when removing the coil spring. The coil spring is under extreme pressure and can become a projectile should the spring separate from the lower control ...
CLICK HERE TO GET FULL ACCESS TO 2000 Chevrolet Tracker DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES
STARTER & ALTERNATOR REPLACEMENT PROCEDURES FOR 2000 Chevrolet Tracker AUTOMOBILES
Starter, Replace
Vehicle: 2000 Chevrolet Tracker 1.6 L4 GAS
- Disconnect battery ground cable.
- Remove mounting nut and battery cable from starter solenoid.
- Remove starter solenoid electrical connector.
- Remove upper mounting nut, bolt and battery cable from starter motor.
- Rem...
CLICK HERE TO GET FULL ACCESS TO 2000 Chevrolet Tracker STARTER & ALTERNATOR REPLACEMENT PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2000 Chevrolet Tracker AUTOMOBILES
General Motors Corp./Saturn Trucks -> Check Fuel Cap Lamp ->
Vehicle: 2000 Chevrolet Tracker 1.6 L4 GAS
The Check Fuel Cap Lamp will illuminate momentarily when the ignition switch is placed in the On position as a bulb check. I...
CLICK HERE TO GET FULL ACCESS TO 2000 Chevrolet Tracker MAINTENANCE LAMP RESET PROCEDURES
RADIATOR & HOSE REPLACEMENT PROCEDURES FOR 2000 Chevrolet Tracker AUTOMOBILES
Heater Hose, Replace -> Inlet -> Outlet
Vehicle: 2000 Chevrolet Tracker 2.0 L4 GAS
Inlet
- Drain cooling system into a suitable container.
- Reposition heater core inlet hose clamp at rear of cylinder head.
- Remove hose from rear of cylinder head.
- Reposition heater hose inlet clamp at heater core.
- Remove heater inlet hose from heater core.
- Remove hose from vehicle.
- Reverse procedure to ins...
CLICK HERE TO GET FULL ACCESS TO 2000 Chevrolet Tracker RADIATOR & HOSE REPLACEMENT PROCEDURES
SERPENTINE BELT SERVICE PROCEDURES FOR 2000 Chevrolet Tracker AUTOMOBILES
Serpentine Drive Belt, Replace
Vehicle: 2000 Chevrolet Tracker 2.0 L4 GAS
- Disconnect the negative battery cable.
- Loosen the adjusting bolt and the pivot bolt, for cooling fan.
- Remove the tension on the fan belt by rotating the tension bolt counterclockwise.
- Remove the four fan nuts. Use a second wrench to hold the fan shaft. Do not damage the rad...
CLICK HERE TO GET FULL ACCESS TO 2000 Chevrolet Tracker SERPENTINE BELT SERVICE PROCEDURES
COMPONENT LOCATION DIAGRAMS FOR 2000 Chevrolet Tracker AUTOMOBILES
Component location diagrams for most 2000 Chevrolet Tracker cars and light trucks sold in the U.S. from 1990+.
 Dome Lamp Wiring Harness Diagram for 2000 Chevrolet Tracker 2.0 L4 GASComponents on diagram: |
CLICK HERE TO GET FULL ACCESS TO 2000 Chevrolet Tracker PARTS/COMPONENTS LOCATION DIAGRAMS!
WIRING DIAGRAMS FOR 2000 Chevrolet Tracker AUTOMOBILES
OEM drawn wiring diagrams for most 2000 Chevrolet Tracker cars and light trucks sold in the U.S.
 2000 Chevrolet Tracker 1.6 L4 GAS Wiring DiagramComponents on diagram: |
 2000 Chevrolet Tracker 2.0 L4 GAS Wiring DiagramComponents on diagram: |
CLICK HERE TO GET FULL ACCESS TO 2000 Chevrolet Tracker WIRING DIAGRAMS!
TECHNICAL SERVICE BULLETINS FOR 2000 Chevrolet Tracker AUTOMOBILES
OEM TSB listings for most 2000 Chevrolet Tracker cars and light trucks sold in the U.S. from 1985+.
|
Document: Revised General Motors New Vehicle Tire Warranty Program Vehicle: 2000 Chevrolet Tracker 1.6 L4 GAS Auto Systems: |
|
Document: New Website for AFIT, TPM, and VDR Updates Vehicle: 2000 Chevrolet Tracker 1.6 L4 GAS Auto Systems: |
CLICK HERE TO GET FULL ACCESS TO 2000 Chevrolet Tracker TECHNICAL SERVICE BULLETINS!
COMPONENT/PARTS SPECIFICATIONS FOR 2000 Chevrolet Tracker AUTOMOBILES
BRAKE SPECIFICATIONS: Brake drum, rotor, caliper, and related specifications for most 2000 Chevrolet Tracker cars and light trucks sold in the U.S. and Canada from 1970+.
- Brake caliper mounting bolt torque
- Brake drum runout, machining, & discard specs
- Minimum brake lining thickness.
- Brake rotor runout, parallelism, machining, discard, & finish specs
A/C SYSTEM SPECIFICATIONS: Air conditioning refrigerant capacity and type as well as lubricant capacity for most 2000 Chevrolet Tracker cars and light trucks sold in the U.S. and Canada from 1980+.
- Refrigerant capacity & type, compressor oil viscosity, total system oil capacity & compressor clutch gap
COOLING SYSTEM BLEED: Cooling system bleeder valve identification, bleeder type and bleed procedures for most domestic and imported cars and light trucks sold in the U.S. and Canada from 1986+.
PREVENTIVE MAINTENANCE: Preventive maintenance recommendations and required services for most domestic and imported cars and light trucks sold in the U.S. and Canada from 1980+. Includes severe and routine service schedules
QUICK-LUBE and ILLUSTRATIONS: Fluid recommendations, capacities, drain plug torques, tire data, and severe service recommended preventive maintenance schedules. Information covers most 2000 Chevrolet Tracker cars and light trucks sold in the U.S. and Canada from 1980+. Engine and chassis service images.
- Automatic transmission/transaxles capacities, lubricant recommendations
- Differential/final drive capacities, lube recommendations, grades, & viscosities
- Final drive fill & drain plug torques
- Number of lubrication fittings & plugs
- Power steering, brake, & clutch fluid recommendations
- Manual transmission/transaxle capacities, lube recommendations, grades, & viscosities
- Number of lubrication fittings & plugs
- Power steering, brake, & clutch fluid recommendations
- Engine oil capacities, API grade recommendations, SAE viscosity recommendations, drain plug torque
- Severe service maintenance & interval recommendations
- Tire sizes, wheel nut/bolt torque, pressures & rim sizes
- Transfer case capacities, lube recommendations, grades, & viscosities
TUNE-UP & DRIVEABILITY SPECIFICATIONS: Most tune-up specifications for most 2000 Chevrolet Tracker cars and light trucks sold in the U.S. and Canada from 1980+
- Airflow sensor electrical specifications
- Tensioning specifications for systems with automatic tensioners
- Barometric pressure sensor specs
- Battery group number and cranking performance
- Crankshaft & camshaft position sensor resistance
- Engine compression pressures
- Coolant temperature sensor specs
- Computer advance.
- Diesel fuel temperature sensor resistance.
- Distributor advance specifications
- Ignition pickup coil resistance
- Exhaust gas recirculation temperature sensor resistance
- Engine fastener torque values
- Firing order diagrams
- Fuel system pressures
- Generator (alternator) specs
- Intake air temperature sensor specs
- Ignition coil specifications
- Fuel injector resistance
- Engine idle speeds
- Knock sensor resistance
- Manifold absolute pressure sensor specs
- Mixture control solenoid resistance
- Voltage regulator specs
- Spark plug applications & gaps
- Starter motor electrical specs.
- Tensioning specifications for systems without automatic tensioners
- Throttle body temperature sensor resistance
- Ignition timing in degrees at rpm
- Transmission oil temperature sensor resistance
- Throttle position sensor specs
- Vacuum sensor valve specs
CLICK HERE TO GET FULL ACCESS TO 2000 Chevrolet Tracker SPECIFICATIONS DATA!
Shop online for auto body parts, engines, wheels, lights...
| More parts |
| Get the Complete Technical Service Bulletins! |
 Access diagrams and repair information such as wiring diagrams,
diagnosis and repair charts, manufacturer
service bulletins, and OEM Part
numbers of your 2000 Chevrolet Tracker vehicle.
|
| Access the Complete guide! |
