Auto Parts Search
BRAKE SERVICE PROCEDURES FOR 2000 Chevrolet Corvette AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2000 Chevrolet Corvette cars and light trucks from 1990+.
Hydraulic Brake Systems -> General Motors -> Brake System Bleed -> Bleed Sequence -> Hydraulic System Flush -> Manual -> Pressure
Vehicle: 2000 Chevrolet Corvette 5.7 V8 GAS
Manual
Pressure bleeding is recommended for all hydraulic systems. However, if a pressure bleeder is unavailable, use the following procedure. Brake fluid damages painted surfaces. Immediately clean any spilled fluid.
- Remove vacuum reserve by pumping brakes several times with engine off.
- Fill master cylinder reservoir with clean brake fluid. Do not let reservoir fall below half full during bleeding procedure.
- If required, bleed master cylinder as follows:
- Loosen master cylinder forward brake line connection until fluid flows from reservoir, then tighten brake line.
- Have assistant t...
CLICK HERE TO GET FULL ACCESS TO 2000 Chevrolet Corvette BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2000 Chevrolet Corvette AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2000 Chevrolet Corvette cars and light trucks from 1990+.
Disc Brakes -> PBR Single Piston Rear Disc Brake -> Brake Pad Service -> Installation -> Removal
Vehicle: 2000 Chevrolet Corvette 5.7 V8 GAS
Removal
- Remove 2/3 of total brake fluid capacity from master cylinder reservoir.
- Raise and support vehicle, then remove tire and wheel assembly.
- Install two wheel lug nuts to retain rotor in position.
- Position one end of a suitable C-clamp against inlet fitting bolt and other end against outboard shoe and lining.
- Tighten clamp, Fig. , until piston fully bottoms in caliper bore.
- Remove upper guide pin bolt and discard.
- Loosen lower guide pin bolt, then pivot caliper downward on lower guide pin bolt to expose shoe and lining assemblies.
- Remove shoes and linings from mounting bracket.
Ins...
CLICK HERE TO GET FULL ACCESS TO 2000 Chevrolet Corvette BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2000 Chevrolet Corvette AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2000 Chevrolet Corvette cars and light trucks from 1990+.
Power Brake Units -> Power Brake Unit Service
Vehicle: 2000 Chevrolet Corvette 5.7 V8 GAS
Hydro-boost brake boosters are...
CLICK HERE TO GET FULL ACCESS TO 2000 Chevrolet Corvette BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2000 Chevrolet Corvette AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2000 Chevrolet Corvette cars and light trucks from 1990+.
Disc Brakes -> PBR Single Piston Rear Disc Brake -> Description
Vehicle: 2000 Chevrolet Corvette 5.7 V8 GAS
This rear caliper, Fig. , consists of a single piston and an aluminum housing which is suspended in a mounting bracket through two slide pins. Hydraulic pressure, created by applying force to the brake pedal, acts equally against the piston and the bottom of the caliper bore to move the piston outward. This action slides the caliper inward, resulting in a clamping action on the brake rotor. This clamping act...
CLICK HERE TO GET FULL ACCESS TO 2000 Chevrolet Corvette BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2000 Chevrolet Corvette AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2000 Chevrolet Corvette cars and light trucks from 1990+.
Power Brake Units -> Application Chart
Vehicle: 2000 Chevrolet Corvette 5.7 V8 GAS
CLICK HERE TO GET FULL ACCESS TO 2000 Chevrolet Corvette BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2000 Chevrolet Corvette AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2000 Chevrolet Corvette cars and light trucks from 1990+.
Disc Brakes -> PBR Dual Piston Front Disc Brake -> Description
Vehicle: 2000 Chevrolet Corvette 5.7 V8 GAS
This front caliper, Fig. , consists of dual pistons and an aluminum housing which is suspended on the shoe and lining assemblies. Hydraulic pressure, created by applying force to the brake pedal, acts equally against the pistons and the bott...
CLICK HERE TO GET FULL ACCESS TO 2000 Chevrolet Corvette BRAKE SERVICE PROCEDURES
Shop online for auto body parts, engines, wheels, lights...
More parts |
Get the Complete Technical Service Bulletins! |
Access diagrams and repair information such as wiring diagrams, diagnosis and repair charts, manufacturer service bulletins, and OEM Part numbers of your 2000 Chevrolet Corvette vehicle. |
Access the Complete guide! |