Auto Parts Search
Automotix DIY provides automotive consumers and do it yourselfers; the most comprehensive repair information about 1998 Mazda Protege car and truck
repair procedures including Mazda engine diagrams, wiring diagrams, repair work estimating measures, technical service bulletins, auto body work
guidance, starter & alternator replacement procedures, serpentine belt replacement procedures, radiator & hose replacement procedures, tune-up &
drivability specifications, quick lube illustrations, preventive maintenance guide, engine light reset instructions, parts removal and install
procedures, fuel filter replacement directions, component location diagrams, air filter locations & replacement instructions, a/c
system specifications, and general auto service procedures. You don't have to be a car mechanic or technician to know how to fix
your 1998 Mazda Protege automobile. Try the Automotix DIY solution today!
We have info for following modifications of 1998 Mazda Protege
- 1998 Mazda Protege DX 1.5 L4 GAS, CC:1489, Fuel Injection
- 1998 Mazda Protege ES 1.8 L4 GAS, CC:1839, Fuel Injection
- 1998 Mazda Protege LX 1.5 L4 GAS, CC:1489, Fuel Injection
BRAKE SERVICE PROCEDURES FOR 1998 Mazda Protege AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 1998 Mazda Protege cars and light trucks from 1990+.
Hydraulic Brake Systems -> Brake System Bleed -> B-Series -> Except B-Series & Tribute -> Manual -> Pressure -> Tribute
Vehicle: 1998 Mazda Protege ES 1.8 L4 GAS
Except B-Series & Tribute
- Raise and support vehicle with jack stands.
- Fill reservoir with brake fluid, ensure reservoir is at least half full at all times during bleeding procedure.
- After removing bleeder cap, connect one end of transparent vinyl tube to bleeder and place other end in a clean, clear container that is half full with brake fluid.
- One person should depress pedal a few times, then hold the pedal depressed.
- A second person should loosen the bleeder screw and drain fluid, then retighten screw to specifications.
- Repeat steps 4 and 5 until there are no more air bubbles see...
CLICK HERE TO GET FULL ACCESS TO 1998 Mazda Protege BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 1998 Mazda Protege AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 1998 Mazda Protege cars and light trucks from 1990+.
Anti-lock Brakes -> Component Testing -> 1997 -> 1998-2001 -> 1999-2001 -> ABS Control Module -> ABS Control Unit -> ABS Hydraulic Unit -> ABS Motor -> ABS Motor & Harness -> ABS Motor & Harness To ABS Control Module -> ABS Relay -> ABS Warning Light -> B-Series -> Clearance Inspection -> Control Unit -> Fail-Safe Relay -> Hydraulic System -> Hydraulic Unit -> Miata -> Millenia & Protege -> Motor Relay -> MPV -> MX-6 & 626 -> Pressure Differential Switch -> Rear Axle Speed Sensor -> Rotor Inspection -> Solenoid Valve -> Solenoid Valve & Valve Relay -> Valve Relay -> Voltage Inspection -> Wheel Speed Sensor
Vehicle: 1998 Mazda Protege DX 1.5 L4 GAS
B-Series
ABS Control Module
1999-2001
Refer to Figs. through , for component testing procedures.
ABS Warning Light
If warning light is inoperative at all times, proceed as follows:
- Inspect warning light bulb; replace as required.
- Inspect No. 10 15A fuse; replace as required.
Hydraulic Unit
1997
Disconnect hydraulic unit connector and measure resistance between terminals 1 and 3 at unit. Resistance should be 18-26 K ohms. If not, replace hydraulic unit.
Rear Axle Speed Sensor
1997
- Raise and support vehicle.
- Remove differential cover and measure clearance between rear axle speed sensor and s...
CLICK HERE TO GET FULL ACCESS TO 1998 Mazda Protege BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 1998 Mazda Protege AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 1998 Mazda Protege cars and light trucks from 1990+.
Anti-lock Brakes -> Component Testing -> 1997 -> 1998-2001 -> 1999-2001 -> ABS Control Module -> ABS Control Unit -> ABS Hydraulic Unit -> ABS Motor -> ABS Motor & Harness -> ABS Motor & Harness To ABS Control Module -> ABS Relay -> ABS Warning Light -> B-Series -> Clearance Inspection -> Control Unit -> Fail-Safe Relay -> Hydraulic System -> Hydraulic Unit -> Miata -> Millenia & Protege -> Motor Relay -> MPV -> MX-6 & 626 -> Pressure Differential Switch -> Rear Axle Speed Sensor -> Rotor Inspection -> Solenoid Valve -> Solenoid Valve & Valve Relay -> Valve Relay -> Voltage Inspection -> Wheel Speed Sensor
Vehicle: 1998 Mazda Protege LX 1.5 L4 GAS
B-Series
ABS Control Module
1999-2001
Refer to Figs. through , for component testing procedures.
ABS Warning Light
If warning light is inoperative at all times, proceed as follows:
- Inspect warning light bulb; replace as required.
- Inspect No. 10 15A fuse; replace as required.
Hydraulic Unit
1997
Disconnect hydraulic unit connector and measure resistance between terminals 1 and 3 at unit. Resistance should be 18-26 K ohms. If not, replace hydraulic unit.
Rear Axle Speed Sensor
1997
- Raise and support vehicle.
- Remove differential cover and measure clearance between rear axle speed sensor and s...
CLICK HERE TO GET FULL ACCESS TO 1998 Mazda Protege BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 1998 Mazda Protege AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 1998 Mazda Protege cars and light trucks from 1990+.
Anti-lock Brakes -> Diagnosis & Testing -> 1997-98 -> 1999-2001 -> 4WABS -> Accessing Diagnostic Trouble Codes -> B-Series -> B-Series & Tribute -> Clearing Diagnostic Trouble Codes -> Diagnostic Tests -> Diagnostic Trouble Code Interpretation -> Except B-Series & Tribute -> Four Wheel ABS (4WABS) -> Miata -> Millenia -> MPV -> MPV, 626 & Tribute -> MX-6 & 626 -> Protege -> RABS -> Rear ABS (RABS) -> Tribute
Vehicle: 1998 Mazda Protege DX 1.5 L4 GAS
Accessing Diagnostic Trouble Codes
Except B-Series & Tribute
- Connect New Generation Star (NGS), or equivalent, to data link connector and battery, Figs. and .
- On models except for B-Series and 626, set tool No. 49 T088 003, or equivalent to ABS.
- On all models, select " VEHICLE & ENGINE SELECTION" on NGS display and then select vehicle model, engine type and model year.
- Select "DIAGNOSTIC DATA LINK" on NGS display.
- Select "ANTI LOCK BRAKE MODULE" on NGS display.
- Select "DIAGNOSTIC TEST MODE" on NGS display.
- If a diagnostic trouble code is displayed, refer to " Diagnostic Trouble Code Interpr... "
CLICK HERE TO GET FULL ACCESS TO 1998 Mazda Protege BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 1998 Mazda Protege AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 1998 Mazda Protege cars and light trucks from 1990+.
Hydraulic Brake Systems -> Troubleshooting
Vehicle: 1998 Mazda Protege DX 1.5 L4 GAS
Refer to Fig. , for assistanc...
CLICK HERE TO GET FULL ACCESS TO 1998 Mazda Protege BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 1998 Mazda Protege AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 1998 Mazda Protege cars and light trucks from 1990+.
Hydraulic Brake Systems -> Diagnosis & Testing -> Brake Fluid Level Sensor -> Proportioning Valve
Vehicle: 1998 Mazda Protege LX 1.5 L4 GAS
Proportioning Valve
- Connect pressure testing equipment as outlined in, Figs. through , then bleed air from brake system as outlined under " Brake System Bleed."
- Depress pedal until master cylinder pressure measures A, then record rear brake pressure (A').
- Depress pedal with additional force until master cylinder pressure measures A, then record rear brake pressure again (B').
- If pressures are...
CLICK HERE TO GET FULL ACCESS TO 1998 Mazda Protege BRAKE SERVICE PROCEDURES
Shop online for auto body parts, engines, wheels, lights...
| More parts |
| Get the Complete Technical Service Bulletins! |
 Access diagrams and repair information such as wiring diagrams,
diagnosis and repair charts, manufacturer
service bulletins, and OEM Part
numbers of your 1998 Mazda Protege vehicle.
|
| Access the Complete guide! |
