Auto Parts Search
We have info for following modifications of 1997 Mitsubishi Diamante
- 1997 Mitsubishi Diamante LS 3.5 V6 GAS, CC:3497, CID:215, Fuel Injection, Aspiration:215, Engine VIN:, Desg:P
- 1997 Mitsubishi Diamante ES 3.5 V6 GAS, CC:3497, CID:215, Fuel Injection, Aspiration:215, Engine VIN:, Desg:P
BRAKE SERVICE PROCEDURES FOR 1997 Mitsubishi Diamante AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 1997 Mitsubishi Diamante cars and light trucks from 1990+.
Disc Brakes -> Diamante & 3000GT -> Tightening Specifications
Vehicle: 1997 Mitsubishi Diamante ES 3.5 V6 GAS
CLICK HERE TO GET FULL ACCESS TO 1997 Mitsubishi Diamante BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 1997 Mitsubishi Diamante AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 1997 Mitsubishi Diamante cars and light trucks from 1990+.
Hydraulic Brake Systems -> Adjustments -> Brake Booster Pushrod
Vehicle: 1997 Mitsubishi Diamante LS 3.5 V6 GAS
Brake Booster Pushrod
- Remove master cylinder as outlined under "Component Replacement," then proceed as follows:
- Measure distance between master cylinder end face and piston, Fig. . Position a square(straight scale) against edge of master cylinder, then measure and subtract thickness of the square to determine dimension B.
- Find dimension C by measuring distance between brake booster mounting surface an...
CLICK HERE TO GET FULL ACCESS TO 1997 Mitsubishi Diamante BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 1997 Mitsubishi Diamante AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 1997 Mitsubishi Diamante cars and light trucks from 1990+.
Disc Brakes -> Diamante & 3000GT -> Caliper Service -> Front -> Inspection -> Rear -> Replacement
Vehicle: 1997 Mitsubishi Diamante ES 3.5 V6 GAS
Replacement
- Disconnect and plug brake hose.
- Remove upper and lower caliper mounting bolts.
- Remove caliper assembly; then, if required, separate from brake pads as outlined under "Brake Pad Service."
- Reverse procedure to install, noting the following:
- Measure brake drag torque as outlined under "Brake Pad Service."
- Tighten brake hose fitting to specifications.
- Bleed brake system as outlined under "Brake System Bleed."
Inspection
Front
- Raise and support vehicle and remove wheel.
- Remove brake caliper.
- Disassemble caliper assembly in numbered sequence, Figs. and , noting the following:
- Remove piston...
CLICK HERE TO GET FULL ACCESS TO 1997 Mitsubishi Diamante BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 1997 Mitsubishi Diamante AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 1997 Mitsubishi Diamante cars and light trucks from 1990+.
Power Brake Units -> Troubleshooting
Vehicle: 1997 Mitsubishi Diamante ES 3.5 V6 GAS
- Run engine for two minutes, then turn engine off. Depress brake pedal slowly several times.
- Pedal should go down farther the first time and rise gradually the second and third time, Fig. . If pedal height remains the same booster is faulty.
- With engine off, depress brake pedal several times, Fig. . There should be ...
CLICK HERE TO GET FULL ACCESS TO 1997 Mitsubishi Diamante BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 1997 Mitsubishi Diamante AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 1997 Mitsubishi Diamante cars and light trucks from 1990+.
Anti-lock Brakes -> Troubleshooting -> General Fault Diagnosis -> Transient Fault Diagnosis
Vehicle: 1997 Mitsubishi Diamante ES 3.5 V6 GAS
General Fault Diagnosis
Problems related to Anti-Lock Brake System (ABS) can generally be classified as electrical or hydraulic.
For problems in electrical system, a self-diagnostic function is built into Electronic Control Unit (ECU), allowing ABS warning lamp to illuminate as a warning to driver in event of an abnormality. In this instance, inspections can be performed with a voltmeter, Multi-Use Tester (MUT), oscilloscope or ABS warning lamp.
Problems with hydraulic system can be located in same manner as ordinary brakes. It is, however, required to determine whether problem is ...
CLICK HERE TO GET FULL ACCESS TO 1997 Mitsubishi Diamante BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 1997 Mitsubishi Diamante AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 1997 Mitsubishi Diamante cars and light trucks from 1990+.
Disc Brakes -> Diamante & 3000GT -> Brake System Bleed
Vehicle: 1997 Mitsubishi Diamante LS 3.5 V6 GAS
The hydraulic brake system must be bled if air has entered the system. Air may enter due to low fluid level, a hydraulic fluid leak, the opening of a hydraulic line or replacement of a hydraulic system component. Symptoms include loss of brake operation and/or a low or spongy brake pedal.
On models equipped with ABS, use a suitable filter when adding fluid to reservoir tank.
- Ensure master cylinder reservoir is full. Add suitable brake fluid as required, then install master cylinder cap.
- Raise and support vehicle.
- Position a drain pan under the wheel being bled.
- Have an assistant d...
CLICK HERE TO GET FULL ACCESS TO 1997 Mitsubishi Diamante BRAKE SERVICE PROCEDURES
Shop online for auto body parts, engines, wheels, lights...
More parts |
Get the Complete Technical Service Bulletins! |
Access diagrams and repair information such as wiring diagrams, diagnosis and repair charts, manufacturer service bulletins, and OEM Part numbers of your 1997 Mitsubishi Diamante vehicle. |
Access the Complete guide! |