1997 Ford Escort Brake Service (ONLINE REPAIR MANUALS)

Whenever new brake components are installed in the hydraulic system, it is recommended that the entire hydraulic system be thoroughly flushed with clean brake fluid.

It may sometime become necessary to flush out the system due to the presence of mineral oil, kerosene, gasoline, etc., which will cause swelling of rubber piston cups and valves and render them inoperative.

Flushing is performed at ...

Pressure bleeding is recommended for all hydraulic brake systems. Ensure all dirt and contaminants are removed from master cylinder area prior to removing reservoir cap.

To prevent air from the pressure tank getting into the lines, do not shake the tank while air is being added to the tank or after it has been pressurized. Set the tank in the required location, bring the air hose to the tank, and do not move it during the bleeding operation. The tank should be kept at least one-third full.

On vehicles equipped with disc brakes and master cylinders without proportioners or press...

If caliper does not require servicing, do not disconnect brake hose or remove caliper from vehicle. Position caliper aside with wire or tie straps to avoid damaging caliper or hose.

If excessive force must be used to remove the rotor, then it should be inspected for lateral runout before installation.

Removal

• On models with air suspension, turn service switch Off.
• On all models, raise and support vehicle, then remove wheel and tire assembly. Use care to avoid damage or interference with caliper bleeder screw fitting and brake rotor shield.
• Remove caliper anchor bracket bolts. Position...

Cougar, Sable, Taurus, Thunderbird & 1997-98 Continental, Mark VIII & Mustang

Removal

• Remove rear disc brake caliper assembly as described under " Caliper Service." Do not disconnect flexible hose unless caliper requires service. Support caliper with wire or tie strap so flexible hose is not stretched or twisted.
• Remove rear disc support bracket to wheel knuckle bolts, then the rear disc support bracket and brake shoes and linings.
• Remove two nuts, then the rotor from rear hub.

Installation

• If installing new rotor, remove protective coating from rotor with suitable carburetor cleaner.
• Lub...

Master Cylinder Overhaul

Disassemble

• Clean outside of master cylinder thoroughly. Drain brake fluid from master cylinder.
• Remove stop bolt and pressure control valves, if equipped.
• Using a screwdriver, carefully pry up on reservoir and remove it from master cylinder body.
• Remove fluid control valve, if equipped.
• Depress primary piston and remove snap ring from retaining groove at open end of bore.
• Remove primary and secondary piston assemblies from master cylinder. If secondary piston does not come out, apply air pressure to secondary outlet port to remove.

Inspection

When disassembled...

Single Piston Calipers

The caliper assembly consists of a pin sliding caliper housing, inner and outer shoe and lining assemblies and a single piston, Figs. through . The caliper slides on two pins which also act as attaching bolts between caliper and the combination anchor plate and spindle. The outer brake shoe and lining assembly is longer than the inner brake shoe and lining assembly. Inner and outer shoe and lining assemblies are attached to the caliper by spring clips riveted to the shoe surfaces. The inner shoe is attached to the caliper by installing the spring clip to the i...