Auto Parts Search
We have info for following modifications of 1995 Jaguar XJS
- 1995 Jaguar XJS 6.0 V12 GAS, CC:5994, Fuel Injection, Engine VIN:, Desg:3
- 1995 Jaguar XJS 4.0 L6 GAS, CC:3980, Fuel Injection, Engine VIN:, Desg:7
- 1995 Jaguar XJS 2+2 6.0 V12 GAS, CC:5994, Fuel Injection, Engine VIN:, Desg:3
- 1995 Jaguar XJS 2+2 4.0 L6 GAS, CC:3980, Fuel Injection, Engine VIN:, Desg:7
BRAKE SERVICE PROCEDURES FOR 1995 Jaguar XJS AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 1995 Jaguar XJS cars and light trucks from 1990+.
Anti-lock Brakes -> System Service -> ABS Control Module -> Accumulator -> Actuation Unit -> Brake System Bleed -> Component Replacement -> Fluid Intake Hose -> Motor & Pump Unit -> XJS, XJ6 & XJ12 & 1995-97 XJR
Vehicle: 1995 Jaguar XJS 6.0 V12 GAS
Brake System Bleed
Bleeding the ABS system is not a routine maintenance operation and is only required when part of the system has been disconnected or the fluid is contaminated.
During the bleeding procedure, it is important that the level of fluid in the reservoir is maintained at approximately .0787 inch below the bottom of the filler neck. Motor/pump unit cannot charge accumulator if air and not fluid, is standing on low pressure side of pump.
If motor/pump unit, fluid intake hose or hydraulic unit of ABS system has been removed or disconnected, bleed as described under "Fluid In... "
CLICK HERE TO GET FULL ACCESS TO 1995 Jaguar XJS BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 1995 Jaguar XJS AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 1995 Jaguar XJS cars and light trucks from 1990+.
Disc Brakes -> Brake Pad Service -> Front, Replace -> Rear, Replace -> XJ6 & XJ12 -> XJ6 & XJ12 & 1995-97 XJR -> XJS
Vehicle: 1995 Jaguar XJS 4.0 L6 GAS
Front, Replace
XJS
- Raise and support vehicle, then remove tire and wheel assembly.
- Remove clips (1) securing retaining pins (2), Fig. .
- Remove pins and anti-rattle springs (3), then the pads (4).
- Compress pistons into caliper bores using piston compression tool No. 64932392, or equivalent, Fig. .
- Reverse procedure to install.
XJ6 & XJ12 & 1995-97 XJR
- Raise and support vehicle, then remove tire and wheel assembly.
- Disconnect brake pad wear sensor connector.
- Remove lower guide pin bolt.
- Pivot caliper upward and remove brake pads.
- Compress piston and reverse procedure to install.
...
CLICK HERE TO GET FULL ACCESS TO 1995 Jaguar XJS BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 1995 Jaguar XJS AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 1995 Jaguar XJS cars and light trucks from 1990+.
Power Brake Units -> Power Brake Unit Service -> Inspection -> Replacement
Vehicle: 1995 Jaguar XJS 2+2 4.0 L6 GAS
Inspection
The following tests on the vacuum system should only be performed if the hydraulic system is in satisfactory condition.
- Raise and support front of vehicle. Ensure one wheel will rotate freely.
- Start engine and allow vacuum to accumulate.
- Apply brake pedal several times. Ensure wheel is free to rotate immediately after pedal is released.
- If brakes bind, booster is faulty.
- With engine running, apply brake pedal several times and check operation of pedal.
- If response is sluggish, check condition of vacuum hoses and booster unit air filter.
- Allow vacuum to build up, then...
CLICK HERE TO GET FULL ACCESS TO 1995 Jaguar XJS BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 1995 Jaguar XJS AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 1995 Jaguar XJS cars and light trucks from 1990+.
Disc Brakes -> Brake Pad Service -> Front, Replace -> Rear, Replace -> XJ6 & XJ12 -> XJ6 & XJ12 & 1995-97 XJR -> XJS
Vehicle: 1995 Jaguar XJS 2+2 4.0 L6 GAS
Front, Replace
XJS
- Raise and support vehicle, then remove tire and wheel assembly.
- Remove clips (1) securing retaining pins (2), Fig. .
- Remove pins and anti-rattle springs (3), then the pads (4).
- Compress pistons into caliper bores using piston compression tool No. 64932392, or equivalent, Fig. .
- Reverse procedure to install.
XJ6 & XJ12 & 1995-97 XJR
- Raise and support vehicle, then remove tire and wheel assembly.
- Disconnect brake pad wear sensor connector.
- Remove lower guide pin bolt.
- Pivot caliper upward and remove brake pads.
- Compress piston and reverse procedure to install.
...
CLICK HERE TO GET FULL ACCESS TO 1995 Jaguar XJS BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 1995 Jaguar XJS AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 1995 Jaguar XJS cars and light trucks from 1990+.
Disc Brakes -> Adjustments -> Parking Brake Cable -> XJ6 & XJ12 & 1995-97 XJR -> XJS
Vehicle: 1995 Jaguar XJS 4.0 L6 GAS
Parking Brake Cable
XJS
- Lift carpet adjacent to parking brake lever mounting
- Loosen lock and adjusting nuts.
- Adjust parking brake cable in vehicle so there is small amount of slack with lever off.
- Tighten cable adjuster locknut.
XJ6 & XJ12 & 1995-97 XJR
- B...
CLICK HERE TO GET FULL ACCESS TO 1995 Jaguar XJS BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 1995 Jaguar XJS AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 1995 Jaguar XJS cars and light trucks from 1990+.
Hydraulic Brake Systems -> Component Service -> Master Cylinder
Vehicle: 1995 Jaguar XJS 6.0 V12 GAS
Master Cylinder
- Remove master cylinder as previously described.
- Carefully pry out master cylinder hydraulic line adapters from sealing grommets.
- Remove sealing grommets from master cylinder by levering out using suitable screwdriver.
- Press primary piston stop pin in to relieve secondary piston stop pin pressure.
- Remove front grommet sealing housing stop pin. Maintain pressure on primary piston and remove circlip.
- Remove primary/secondary pistons and spring assemblies by tapping master cylinder open flanged end on suitable wooden block. Compressed air may have to be applied to master...
CLICK HERE TO GET FULL ACCESS TO 1995 Jaguar XJS BRAKE SERVICE PROCEDURES
Shop online for auto body parts, engines, wheels, lights...
More parts |
Get the Complete Technical Service Bulletins! |
Access diagrams and repair information such as wiring diagrams, diagnosis and repair charts, manufacturer service bulletins, and OEM Part numbers of your 1995 Jaguar XJS vehicle. |
Access the Complete guide! |