Auto Parts Search
We have info for following modifications of 1995 GMC Sonoma
- 1995 GMC Sonoma 2.2 L4 GAS, CID:134, Fuel Injection, Aspiration:134, Engine VIN:, Desg:4
- 1995 GMC Sonoma 4.3 V6 GAS, CID:262, Fuel Injection, Aspiration:262, Engine VIN:, Desg:Z
- 1995 GMC Sonoma 4.3 V6 GAS, CID:262, Fuel Injection, Aspiration:262, Engine VIN:, Desg:W
BRAKE SERVICE PROCEDURES FOR 1995 GMC Sonoma AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 1995 GMC Sonoma cars and light trucks from 1990+.
Anti-lock Brakes -> ABS-VI Anti-Lock Brake System -> Diagnostic Chart Index
Vehicle: 1995 GMC Sonoma 4.3 V6 GAS
CLICK HERE TO GET FULL ACCESS TO 1995 GMC Sonoma BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 1995 GMC Sonoma AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 1995 GMC Sonoma cars and light trucks from 1990+.
Power Brake Units -> Bendix Brake Boosters -> General Service
Vehicle: 1995 GMC Sonoma 2.2 L4 GAS
Certain general service procedures apply, regardless of whether the brakes are vacuum or hydraulically assisted. Only top quality, clean brake fluid should be used. More seals and valves are used with power brake systems than with ordinary brakes, so an inferior brake fluid will do much more damage. For the same reason, be sure all dirt is kept out of the system. Additionally, care must be taken not to mix the fluids of the booster hydraulic system and brake hydraulic system as the fluids are not compatible.
If the power unit fails, the brakes will still operate, as the conventio...
CLICK HERE TO GET FULL ACCESS TO 1995 GMC Sonoma BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 1995 GMC Sonoma AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 1995 GMC Sonoma cars and light trucks from 1990+.
Hydraulic Brake Systems -> Adjustments -> Height Sensing Proportioning Valve
Vehicle: 1995 GMC Sonoma 2.2 L4 GAS
Height Sensing Proportioning Valve
The height sensing proportioning valve must be adjusted whenever the valve and/or linkage is disassembled or removed for service. In addition, adjustment should be checked if excessive front wheel lock-up is experienced with a lower than desired brake application rate when vehicle is at or near maximum GVWR.
- Raise and support vehicle leaving wheels on, and allow axle to hang freely.
- Remove lever retaining nut and disconnect lever from valve shaft, Fig. .
- Rotate valve shaft to permit installation of correct adjustment gauge, Fig. , ensuring that D shape...
CLICK HERE TO GET FULL ACCESS TO 1995 GMC Sonoma BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 1995 GMC Sonoma AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 1995 GMC Sonoma cars and light trucks from 1990+.
Disc Brakes -> Bendix Single Piston Sliding Caliper -> Caliper Service -> Assemble -> Disassemble -> Inspection -> Installation -> Removal
Vehicle: 1995 GMC Sonoma 4.3 V6 GAS
Removal
- Siphon 2/3 of brake fluid from master cylinder reservoir serving front disc brakes.
- Raise vehicle, support on jack stands and remove front wheels.
- Bottom caliper piston in bore. Insert a screwdriver between inboard shoe and piston, then pry piston back into bore. The piston can also be bottomed in the bore with a large C-clamp, Fig. .
- Remove support key retaining screw.
- Drive caliper support key and spring from steering knuckle with a suitable drift and hammer, Fig. .
- Lift caliper from anchor plate and off rotor, Fig. . Hang caliper from coil spring with wire. Do not allow cal...
CLICK HERE TO GET FULL ACCESS TO 1995 GMC Sonoma BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 1995 GMC Sonoma AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 1995 GMC Sonoma cars and light trucks from 1990+.
Power Brake Units -> Delco-Moraine Brake Boosters -> Power Brake Unit Service -> Assemble -> Disassemble -> Single Diaphragm Type -> Tandem (Dual) Diaphragm Type
Vehicle: 1995 GMC Sonoma 2.2 L4 GAS
Single Diaphragm Type
Disassemble
- Remove boot, silencer, vacuum check valve, grommet and front housing seal, Fig. .
- Scribe a line across front and rear housing, then mount brake booster to brake mounting fixture tool No. J 23456 or equivalent, Fig. .
- Turn fixture handle counterclockwise to unlock housings.
- Remove return spring, power piston assembly and power piston bearing from rear housing, Fig. .
- Remove reaction body retainer, piston rod, reaction retainer and filter.
- Remove power piston and pushrod assembly as follows:
- While holding the pushrod down against a hard surface, ...
CLICK HERE TO GET FULL ACCESS TO 1995 GMC Sonoma BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 1995 GMC Sonoma AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 1995 GMC Sonoma cars and light trucks from 1990+.
Disc Brakes -> Bendix Single Piston Sliding Caliper -> Tightening Specifications
Vehicle: 1995 GMC Sonoma 2.2 L4 GAS
CLICK HERE TO GET FULL ACCESS TO 1995 GMC Sonoma BRAKE SERVICE PROCEDURES
Shop online for auto body parts, engines, wheels, lights...
More parts |
Get the Complete Technical Service Bulletins! |
Access diagrams and repair information such as wiring diagrams, diagnosis and repair charts, manufacturer service bulletins, and OEM Part numbers of your 1995 GMC Sonoma vehicle. |
Access the Complete guide! |