Auto Parts Search
We have info for following modifications of 1994 Toyota Celica
- 1994 Toyota Celica GT 2.2 L4 GAS, CC:2164, Fuel Injection, Engine VIN:, Desg:S
- 1994 Toyota Celica ST 1.8 L4 GAS, CC:1762, Fuel Injection, Engine VIN:, Desg:A
- 1994 Toyota Celica 1.8 L4 GAS, CC:1762, Fuel Injection, Engine VIN:, Desg:A
MAINTENANCE LAMP RESET PROCEDURES FOR 1994 Toyota Celica AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 1994 Toyota Celica cars and light trucks sold in the U.S. from 1990+.
Toyota -> Malfunction Indicator Lamp (MIL) ->
Vehicle: 1994 Toyota Celica ST 1.8 L4 GAS
On some models equipped with OBD II, the MIL will also illuminate if the fuel tank filler cap is not properly tightened. Tighten fuel tank filler cap until it clicks.
The MIL should light when the ignition switch is placed in the On position without starting the engine. When the engine is started, the lamp should go out. If it remains lit, a fault has been detected by the diagnostic system and has logged a diagnostic trouble code. If the fault does not occur again within three trips, the lamp will go out but a diagnostic tro...
CLICK HERE TO GET FULL ACCESS TO 1994 Toyota Celica MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 1994 Toyota Celica AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 1994 Toyota Celica cars and light trucks sold in the U.S. from 1990+.
Toyota -> Anti-Lock Brake System (ABS)/Vehicle Stability Control (VSC) System Warning Lamp -> 1990-99 Celica
Vehicle: 1994 Toyota Celica 1.8 L4 GAS
The anti-lock warning lamp is used to warn of a system fault. The lamp will be lit during engine start-up, but should go out when the self-diagnostic system verifies proper anti-lock operation. If the lamp remains lit, a fault in the anti-lock brake system is indicated. After system diagnosis and repair are complete, the lamp can be reset using the following procedures:
- Place ignition swit...
CLICK HERE TO GET FULL ACCESS TO 1994 Toyota Celica MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 1994 Toyota Celica AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 1994 Toyota Celica cars and light trucks sold in the U.S. from 1990+.
Toyota -> Automatic Transmission Oil Temperature Warning Lamp ->
Vehicle: 1994 Toyota Celica 1.8 L4 GAS
This lamp will be illuminated when automatic transmission or transfer case fluid temperature exceeds 302°F. If the lamp lights, allow vehicle to operate at idle speed until fluid temperature falls below 248°F; t...
CLICK HERE TO GET FULL ACCESS TO 1994 Toyota Celica MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 1994 Toyota Celica AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 1994 Toyota Celica cars and light trucks sold in the U.S. from 1990+.
Toyota -> Air Bag Warning Lamp -> 1990-2002 Celica
Vehicle: 1994 Toyota Celica 1.8 L4 GAS
The air bag system warning lamp is used to warn of a system fault. The lamp will light during engine start-up, but should go out when the self-diagnostic system determines that no faults are present. If the lamp remains lit, a fault in the air bag system is indicated. The air bag system must be diagnosed and repaired, then the following procedures can be used to reset the warning lamp.
- Connect service wires to check conn...
CLICK HERE TO GET FULL ACCESS TO 1994 Toyota Celica MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 1994 Toyota Celica AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 1994 Toyota Celica cars and light trucks sold in the U.S. from 1990+.
Toyota -> Low Oil Level Warning Indicator ->
Vehicle: 1994 Toyota Celica ST 1.8 L4 GAS
This lamp lights to indicate that the engine oil level is below a specified level. The lamp will be illuminated during engine start-up. If...
CLICK HERE TO GET FULL ACCESS TO 1994 Toyota Celica MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 1994 Toyota Celica AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 1994 Toyota Celica cars and light trucks sold in the U.S. from 1990+.
Toyota -> Malfunction Indicator Lamp (MIL) ->
Vehicle: 1994 Toyota Celica GT 2.2 L4 GAS
On some models equipped with OBD II, the MIL will also illuminate if the fuel tank filler cap is not properly tightened. Tighten fuel tank filler cap until it clicks.
The MIL should light when the ignition switch is placed in the On position without starting the engine. When the engine is started, the lamp should go out. If it remains lit, a fault has been detected by the diagnostic system and has logged a diagnostic trouble code. If the fault does not occur again within three trips, the lamp will go out but a diagnostic tro...
CLICK HERE TO GET FULL ACCESS TO 1994 Toyota Celica MAINTENANCE LAMP RESET PROCEDURES
Shop online for auto body parts, engines, wheels, lights...
More parts |
Get the Complete Technical Service Bulletins! |
Access diagrams and repair information such as wiring diagrams, diagnosis and repair charts, manufacturer service bulletins, and OEM Part numbers of your 1994 Toyota Celica vehicle. |
Access the Complete guide! |