Auto Parts Search
We have info for following modifications of 1994 Ford Aerostar
- 1994 Ford Aerostar 3.0 V6 GAS, CID:182, Fuel Injection, Aspiration:182, Engine VIN:, Desg:U
- 1994 Ford Aerostar 4.0 V6 GAS, CID:245, Fuel Injection, Aspiration:245, Engine VIN:, Desg:X
MAINTENANCE LAMP RESET PROCEDURES FOR 1994 Ford Aerostar AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 1994 Ford Aerostar cars and light trucks sold in the U.S. from 1990+.
Ford Motor Co. Trucks -> Check Engine Lamp -> 1993-97 -> Continuous Memory -> EEC -> EEC IV -> EEC V -> Except Malfunction Indicator Lamp (MIL) -> Keep Alive Memory (KAM) -> Keep Alive Memory (KAM) Reset & PCM Reset Less Electronic Tester -> Malfunction Indicator Light -> PCM Reset Using Generic Scan Tool
Vehicle: 1994 Ford Aerostar 3.0 V6 GAS
EEC
Except Malfunction Indicator Lamp (MIL)
When using NGS tool No. 007-00500, or equivalent, select Diagnostic Test Mode Results, then press CLEAR or disconnect battery ground cable. Codes will be erased from back-up memory after 24 hours.
Malfunction Indicator Light
- Activate diagnostic test mode.
- Disconnect diagnostic connector.
- Jump BL/W and GY/BL wires using suitable jumper wire.
- Wait about two seconds.
- Remove jumper wire and reconnect diagnostic connector.
- MIL will stay on, and codes will be erased.
EEC IV
Continuous Memory
This lamp should light when the ignition is turned On. After the engin...
CLICK HERE TO GET FULL ACCESS TO 1994 Ford Aerostar MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 1994 Ford Aerostar AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 1994 Ford Aerostar cars and light trucks sold in the U.S. from 1990+.
Ford Motor Co. Trucks -> Traction Control System Warning Lamp ->
Vehicle: 1994 Ford Aerostar 3.0 V6 GAS
This lamp should light for a approximately 6-8 seconds when the ignition is turned On as a bulb check. If the warni...
CLICK HERE TO GET FULL ACCESS TO 1994 Ford Aerostar MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 1994 Ford Aerostar AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 1994 Ford Aerostar cars and light trucks sold in the U.S. from 1990+.
Ford Motor Co. Trucks -> Anti-Lock Or Rear Anti-Lock Brake System Warning ->
Vehicle: 1994 Ford Aerostar 4.0 V6 GAS
Red and yellow indicator lamps are used to warn of system faults. The red lamp warns of such faults as low brake fluid level, parking brake On, system pressure differential and other system faults. The red indicator lamp will light for approximately two seconds during engine starting and should go off, unless parking brake is applied or a problem in the brake system exist. The red indicator lamp should reset after repairs to system have ...
CLICK HERE TO GET FULL ACCESS TO 1994 Ford Aerostar MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 1994 Ford Aerostar AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 1994 Ford Aerostar cars and light trucks sold in the U.S. from 1990+.
Ford Motor Co. Trucks -> Emission Maintenance Reminder Indicator ->
Vehicle: 1994 Ford Aerostar 4.0 V6 GAS
This lamp should light after approximately 60,000 miles of operation, Fig. . The amber lens lamp is located on the instrument panel and has the word Emissions, Emiss or EGR printed on it. After performing the required emission control maintenance, the module must be replaced or reset, depending on type of module used. On module equipped with reset feature, reset the module as follows:
- Turn ignition Off.
- On Aerostar models, the module is located under the instrument panel near the bulkhead connector.
- On Bronco, Explorer and F-Series, the module is attached to the instrument cluster to the left of ...
CLICK HERE TO GET FULL ACCESS TO 1994 Ford Aerostar MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 1994 Ford Aerostar AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 1994 Ford Aerostar cars and light trucks sold in the U.S. from 1990+.
Ford Motor Co. Trucks -> Severity Indicator ->
Vehicle: 1994 Ford Aerostar 3.0 V6 GAS
This indicator will display the severity color of RED when low oil pressure, charging system malfunction, engine coolant overheating or door ajar problems ar...
CLICK HERE TO GET FULL ACCESS TO 1994 Ford Aerostar MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 1994 Ford Aerostar AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 1994 Ford Aerostar cars and light trucks sold in the U.S. from 1990+.
Ford Motor Co. Trucks -> Low Oil Level Warning Indicator ->
Vehicle: 1994 Ford Aerostar 3.0 V6 GAS
This system is used to indicate a low engine oil level condition. The lamp should light during engine starting. If oil level is sufficient, the lamp should go off when engine is operating. If oil level is low the...
CLICK HERE TO GET FULL ACCESS TO 1994 Ford Aerostar MAINTENANCE LAMP RESET PROCEDURES
Shop online for auto body parts, engines, wheels, lights...
More parts |
Get the Complete Technical Service Bulletins! |
Access diagrams and repair information such as wiring diagrams, diagnosis and repair charts, manufacturer service bulletins, and OEM Part numbers of your 1994 Ford Aerostar vehicle. |
Access the Complete guide! |