1991 Chevrolet C1500 Pickup Brake Service (ONLINE REPAIR MANUALS)

The Bendix single piston sliding caliper disc brake is standard equipment on some truck applications, while on other trucks it is used only in Hydro-Boost power brake applications with both front disc brakes and 4 wheel disc brakes. On 4 wheel disc brakes, the front and rear systems are identical.

T...

EXCEPT TRACKER, 1990-91 C & K SERIES w/NON-SERVO BRAKES

• Lubricate parking brake lever fulcrum with suitable brake lube, then attach lever to brake shoe. Ensure lever operates smoothly.
• Connect brake shoes with adjusting screw spring, then position adjusting screw. Ensure adjusting screw star wheel does not contact adjusting screw spring after installation, and also ensure RH thread adjusting screw is installed on left side of vehicle and LH thread adjusting screw is installed on right side of vehicle. When brake shoe installation is completed, ensure star wheel lines up with adjustin...

BRAKE DRUMS

Any time the brake drums are removed for brake service, the braking surface diameter should be checked with a suitable brake drum micrometer at several points to determine if they are within the safe oversize limit stamped on the brake drum outer surface. If the braking surface diameter exceeds specifications, the drum must be replaced. If the braking surface diameter is within specifications, drums should be cleaned and inspected for cracks, scores, deep grooves, taper, out of round and heat spotting. If drums are cracked or heat spotted, they must be replaced. Gr...

REMOVAL

• Remove caliper assembly as outlined above.
• Remove inboard pad with retainer spring. Dislodge outboard pad and position caliper on the front suspension so the brake hose will not support the weight of the caliper.
• Remove two sleeves from inboard ears of the caliper.
• Remove four rubber bushings from the grooves in each of the caliper ears.

INSTALLATION

• Lubricate new sleeves, rubber bushings, bushing grooves and mounting bolt ends with Delco Silicone Lube or equivalent.
• Install new bushings and sleeves in caliper ears. Position the sleeve so that the end toward the pad is flush...

REMOVAL

• Siphon enough brake fluid out of the master cylinder to bring fluid level to^1-3 full to avoid fluid overflow when the caliper piston is pushed back into its bore.
• Raise and support vehicle, remove front wheels.
• Using a C-clamp, as illustrated in Fig. , push piston back into its bore.
• Remove two mounting bolts and lift caliper away from disc.

DISASSEMBLE

• Disconnect hose from the caliper being careful not to lose copper washers.
• Remove caliper as outlined above.
• Drain brake fluid from caliper.
• Pad caliper interior with clean shop towels and apply compressed air to remove piston, Fi...

Diagnose power brakes systems as if two separate systems exist. Check for faults in the regular brake system first. If no problem exists in the regular brake system, diagnosis the power brake circuit is necessary. For a quick check of proper power unit operation, press the brake pedal firmly and then start the engine. The pedal should fall away slightly and less pressure should be needed to maintain the pedal in any position. On vacuum suspended power units, air will rush into the air intake when the brakes are applied.

To perform another check, remove the stop light switch, ...