Auto Parts Search
2009 Audi Q7 CAR/TRUCK REPAIR PROCEDURES AND DIAGRAMS - WHAT Audi REPAIR SHOPS DON'T WANT YOU TO KNOW
Learn how to repair a car or truck, install or remove parts, wire an engine, reset warning lights, replace fuel filter, fix auto body and more. Get Automotix DIY!Select Section
- Technical Service Bulletins
- Specifications
- Driveline, U-Joint & CV Axles Replacement
- Tire Pressure Monitoring System
- Starter & Alternator Replacement
- Cabin Air Filter Locations & Replacement
- Maintenance Lamp Reset
- Radiator & Hose Replacement
- Serpentine Belt Service
DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES FOR 2009 Audi Q7 AUTOMOBILES
DRIVESHAFT, Replace -> Front -> Rear
Vehicle: 2009 Audi Q7 Premium 4.2 V8 GAS
- Raise and support vehicle.
- Remove rear section of exhaust system at clamp(s).
- Pry off rear attachments of drive shaft heat shield.
- Remove securing bolts for center bearing When removing securing bolts, support drive shaft by hand. Do not bend drive shaft.
- Remove heat shield. Continue supporting drive shaft.
- Screw in securing bolts for center bearing again hand-tight.
- Remove drive shaft heat shield from transmission.
- Check for a factory marking (colored dot) on drive shaft and on drive shaft flange on final drive at rear. If no colored dot is present, mark position of drive shaft fl...
CLICK HERE TO GET FULL ACCESS TO 2009 Audi Q7 DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES
TIRE PRESSURE MONITORING SYSTEM PROCEDURES FOR 2009 Audi Q7 AUTOMOBILES
Reset Procedures
Vehicle: 2009 Audi Q7 Premium 4.2 V8 GAS
- Check and the adjust tire pressure to the manufacturer's specifications.
- Press the Reset button located on the windshield wiper control lever until DISPLAY TYPE appears on the instrument cluster.
- Press button on end of the windshield wiper control lever to select SET option.
- Press the Reset button on the windshield wiper control lever.
- Press button on end of the wi...
CLICK HERE TO GET FULL ACCESS TO 2009 Audi Q7 TIRE PRESSURE MONITORING SYSTEM PROCEDURES
STARTER & ALTERNATOR REPLACEMENT PROCEDURES FOR 2009 Audi Q7 AUTOMOBILES
Starter, Replace
Vehicle: 2009 Audi Q7 3.6 V6 GAS
- Disconnect battery ground cable at battery.
- Remove front and rear noise insulation.
- Remove catalytic converter bolts.
- Remove nuts and bolts then B+ line bracket and catalytic converters.
- Remove heat shield on starter.
- Remove protective caps from solenoid.
- Remov...
CLICK HERE TO GET FULL ACCESS TO 2009 Audi Q7 STARTER & ALTERNATOR REPLACEMENT PROCEDURES
CABIN AIR FILTER LOCATIONS & REPLACEMENT PROCEDURES FOR 2009 Audi Q7 AUTOMOBILES
Cabin Air Filter Service -> Audi -> 2007-09 Q7
Vehicle: 2009 Audi Q7 3.6 V6 GAS
The cabin air filter should be replaced at 15,000 miles, then every 20,000 miles.
- Remove the instrument panel trim from under the glove compartment.
- From under the right side of the instrument panel, remove the cabin air filter cover, Fig. .
- Rem...
CLICK HERE TO GET FULL ACCESS TO 2009 Audi Q7 CABIN AIR FILTER LOCATIONS & REPLACEMENT PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2009 Audi Q7 AUTOMOBILES
Audi -> Auto-Check Indicator System ->
Vehicle: 2009 Audi Q7 3.6 V6 GAS
The auto-check system will monitor certain vehicle systems when the ignition switch is placed in the On position and vehicle is operated. When all monitored systems are functioning properly, the system display will indicate "OK" for a few seconds after the ignition switch is placed in the On position.
This system monitors brake fluid level and hydraulic pressure, engine oil pressure, coolant temperature and level, brake pad wear, headlamps and tail lamps, battery voltage, washer fluid level and fuel level.
When the auto-check yellow or r...
CLICK HERE TO GET FULL ACCESS TO 2009 Audi Q7 MAINTENANCE LAMP RESET PROCEDURES
RADIATOR & HOSE REPLACEMENT PROCEDURES FOR 2009 Audi Q7 AUTOMOBILES
Heater Hose, Replace -> Inlet -> Outlet
Vehicle: 2009 Audi Q7 Premium 3.6 V6 GAS
Inlet
- Drain coolant into a suitable container.
- Reposition hose clamp at heater core and remove hose.
- Reposition hose clamp at after run coolant pump and remove hose.
- Remove hose from vehicle.
- Reverse proce...
CLICK HERE TO GET FULL ACCESS TO 2009 Audi Q7 RADIATOR & HOSE REPLACEMENT PROCEDURES
SERPENTINE BELT SERVICE PROCEDURES FOR 2009 Audi Q7 AUTOMOBILES
Serpentine Drive Belt, Replace
Vehicle: 2009 Audi Q7 3.6 V6 GAS
- Mark direction of rotation of drive belt with chalk or felt pen, if belt is to be reused.
- Screw a suitable M8x50 hex head ...
CLICK HERE TO GET FULL ACCESS TO 2009 Audi Q7 SERPENTINE BELT SERVICE PROCEDURES
TECHNICAL SERVICE BULLETINS FOR 2009 Audi Q7 AUTOMOBILES
OEM TSB listings for most 2009 Audi Q7 cars and light trucks sold in the U.S. from 1985+.
Document: AUDI TIRE PRESSURE MONITORING SYSTEMS OVERVIEW - REVISED Vehicle: 2009 Audi Q7 Premium 4.2 V8 GAS Auto Systems: |
Document: AIRBAG / PYROTECHNIC SAFETY BELT DEPLOYMENT INQUIRIES - REVISED Vehicle: 2009 Audi Q7 Premium 4.2 V8 GAS Auto Systems: |
CLICK HERE TO GET FULL ACCESS TO 2009 Audi Q7 TECHNICAL SERVICE BULLETINS!
COMPONENT/PARTS SPECIFICATIONS FOR 2009 Audi Q7 AUTOMOBILES
BRAKE SPECIFICATIONS: Brake drum, rotor, caliper, and related specifications for most 2009 Audi Q7 cars and light trucks sold in the U.S. and Canada from 1970+.
- Brake caliper mounting bolt torque
- Brake drum runout, machining, & discard specs
- Minimum brake lining thickness.
- Brake rotor runout, parallelism, machining, discard, & finish specs
A/C SYSTEM SPECIFICATIONS: Air conditioning refrigerant capacity and type as well as lubricant capacity for most 2009 Audi Q7 cars and light trucks sold in the U.S. and Canada from 1980+.
- Refrigerant capacity & type, compressor oil viscosity, total system oil capacity & compressor clutch gap
COOLING SYSTEM BLEED: Cooling system bleeder valve identification, bleeder type and bleed procedures for most domestic and imported cars and light trucks sold in the U.S. and Canada from 1986+.
PREVENTIVE MAINTENANCE: Preventive maintenance recommendations and required services for most domestic and imported cars and light trucks sold in the U.S. and Canada from 1980+. Includes severe and routine service schedules
QUICK-LUBE and ILLUSTRATIONS: Fluid recommendations, capacities, drain plug torques, tire data, and severe service recommended preventive maintenance schedules. Information covers most 2009 Audi Q7 cars and light trucks sold in the U.S. and Canada from 1980+. Engine and chassis service images.
- Automatic transmission/transaxles capacities, lubricant recommendations
- Differential/final drive capacities, lube recommendations, grades, & viscosities
- Final drive fill & drain plug torques
- Number of lubrication fittings & plugs
- Power steering, brake, & clutch fluid recommendations
- Manual transmission/transaxle capacities, lube recommendations, grades, & viscosities
- Number of lubrication fittings & plugs
- Power steering, brake, & clutch fluid recommendations
- Engine oil capacities, API grade recommendations, SAE viscosity recommendations, drain plug torque
- Severe service maintenance & interval recommendations
- Tire sizes, wheel nut/bolt torque, pressures & rim sizes
- Transfer case capacities, lube recommendations, grades, & viscosities
TUNE-UP & DRIVEABILITY SPECIFICATIONS: Most tune-up specifications for most 2009 Audi Q7 cars and light trucks sold in the U.S. and Canada from 1980+
- Airflow sensor electrical specifications
- Tensioning specifications for systems with automatic tensioners
- Barometric pressure sensor specs
- Battery group number and cranking performance
- Crankshaft & camshaft position sensor resistance
- Engine compression pressures
- Coolant temperature sensor specs
- Computer advance.
- Diesel fuel temperature sensor resistance.
- Distributor advance specifications
- Ignition pickup coil resistance
- Exhaust gas recirculation temperature sensor resistance
- Engine fastener torque values
- Firing order diagrams
- Fuel system pressures
- Generator (alternator) specs
- Intake air temperature sensor specs
- Ignition coil specifications
- Fuel injector resistance
- Engine idle speeds
- Knock sensor resistance
- Manifold absolute pressure sensor specs
- Mixture control solenoid resistance
- Voltage regulator specs
- Spark plug applications & gaps
- Starter motor electrical specs.
- Tensioning specifications for systems without automatic tensioners
- Throttle body temperature sensor resistance
- Ignition timing in degrees at rpm
- Transmission oil temperature sensor resistance
- Throttle position sensor specs
- Vacuum sensor valve specs
CLICK HERE TO GET FULL ACCESS TO 2009 Audi Q7 SPECIFICATIONS DATA!
Shop online for auto body parts, engines, wheels, lights...
More parts |
Get the Complete Technical Service Bulletins! |
Access diagrams and repair information such as wiring diagrams, diagnosis and repair charts, manufacturer service bulletins, and OEM Part numbers of your 2009 Audi Q7 vehicle. |
Access the Complete guide! |