Auto Parts Search
Automotix DIY provides automotive consumers and do it yourselfers; the most comprehensive repair information about 2006 Jeep Commander car and truck
repair procedures including Jeep engine diagrams, wiring diagrams, repair work estimating measures, technical service bulletins, auto body work
guidance, starter & alternator replacement procedures, serpentine belt replacement procedures, radiator & hose replacement procedures, tune-up &
drivability specifications, quick lube illustrations, preventive maintenance guide, engine light reset instructions, parts removal and install
procedures, fuel filter replacement directions, component location diagrams, air filter locations & replacement instructions, a/c
system specifications, and general auto service procedures. You don't have to be a car mechanic or technician to know how to fix
your 2006 Jeep Commander automobile. Try the Automotix DIY solution today!
We have info for following modifications of 2006 Jeep Commander
- 2006 Jeep Commander 4.7 V8 GAS, CID:285, Fuel Injection, Aspiration:285, Engine VIN:, Desg:N
- 2006 Jeep Commander 3.7 V6 GAS, CID:226, Fuel Injection, Aspiration:226, Engine VIN:, Desg:K
- 2006 Jeep Commander Limited 4.7 V8 GAS, CID:285, Fuel Injection, Aspiration:285, Engine VIN:, Desg:N
- 2006 Jeep Commander Limited 5.7 V8 GAS, CID:345, Fuel Injection, Aspiration:345, Engine VIN:, Desg:2
BRAKE SERVICE PROCEDURES FOR 2006 Jeep Commander AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2006 Jeep Commander cars and light trucks from 1990+.
Disc Brakes -> Precautions -> Brake Bleed -> Brake Disc Service -> Brake Lines & Linings -> Brake Roughness -> Caliper Inspection -> General Precautions
Vehicle: 2006 Jeep Commander 4.7 V8 GAS
Brake Lines & Linings
Remove one of the front wheels and inspect the brake disc, caliper and linings. The wheel bearings should be inspected at this time and repacked if required.
Do not get any oil or grease on the linings. It is recommended that both front wheel sets be replaced whenever a respective pad is worn or damaged. Inspect and, if required, replace rear brake linings also.
If the caliper is cracked or fluid leakage through the casting is evident, it must be replaced as a unit.
Brake Roughness
The most common cause of brake chatter on disc brakes is a variation in thickness of ...
CLICK HERE TO GET FULL ACCESS TO 2006 Jeep Commander BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2006 Jeep Commander AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2006 Jeep Commander cars and light trucks from 1990+.
Disc Brakes -> Brake Pad Service -> Caravan, Town & Country & Voyager -> Commander -> Dakota & Durango -> Front -> Full Size Pickup -> Grand Cherokee, Liberty & Wrangler -> Inspection -> Installation -> Pacifica -> PT Cruiser -> Rear -> Removal -> Sprinter
Vehicle: 2006 Jeep Commander 4.7 V8 GAS
Caravan, Town & Country & Voyager
Front
Removal
- Raise and support vehicle.
- Remove front wheel and tire assemblies.
- Remove two caliper-to-knuckle attaching bolts, then remove caliper by sliding away from adapter and lifting off rotor, Fig. . Support caliper firmly to prevent weight of caliper from damaging flexible hose.
- Remove outboard pad by prying pad retaining clip over raised area of caliper, then sliding pad down and off of caliper.
- Pull inboard pad away from caliper piston, until springs release from piston.
Installation
- Inspect piston seal for leaks and for ruptures in piston du...
CLICK HERE TO GET FULL ACCESS TO 2006 Jeep Commander BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2006 Jeep Commander AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2006 Jeep Commander cars and light trucks from 1990+.
Anti-Lock Brakes -> Jeep -> Diagnosis & Testing -> 2002-04 -> 2005 -> 2005-06 -> 2006 -> Accessing Diagnostic Trouble Codes -> Clearing Diagnostic Trouble Codes -> Commander -> Connector Pin Identification -> Diagnostic Tests -> Diagnostic Trouble Code Interpretation -> Grand Cherokee -> Liberty -> Wrangler
Vehicle: 2006 Jeep Commander Limited 5.7 V8 GAS
Accessing Diagnostic Trouble Codes
Connect a suitably programmed scan tool to Data Link Connector (DLC) and follow manufacturer's instructions.
Diagnostic Trouble Code Interpretation
Commander
[[table data]]Grand Cherokee
2002-04
[[table data]]2005-06
[[table data]]Liberty
2002-04
[[table data]]2005
[[table data]]2006
[[table data]]Wrangler
[[table data]]Connector Pin Identifica...
[[table data]] [[table data]] [[table data]] [[table data]] [[table data]] [[table data]] [[table data]]CLICK HERE TO GET FULL ACCESS TO 2006 Jeep Commander BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2006 Jeep Commander AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2006 Jeep Commander cars and light trucks from 1990+.
Anti-Lock Brakes -> Jeep -> System Service -> 2002-04 -> 2002-04 Grand Cherokee -> 2002-05 -> 2002-05 Liberty -> 2005-06 -> 2005-06 Commander, Grand Cherokee & 2006 Liberty -> 2006 -> Anti-Lock Brake Module (ABM)/Hydraulic Control Unit (HCU) -> Brake System Bleed -> Commander -> Commander, Grand Cherokee & Liberty -> Component Replacement -> Controller Anti-Lock Brake (CAB) Module/Hydraulic Control Unit (HCU) -> Front Wheel Sensor -> Grand Cherokee -> Hydraulic Control Unit (HCU) -> Liberty -> Manual/Base System -> Master Cylinder Bleed -> Pressure Bleed -> Rear Wheel Sensor -> Wrangler
Vehicle: 2006 Jeep Commander Limited 4.7 V8 GAS
Brake System Bleed
ABS system bleeding requires conventional bleeding methods plus use of the scan tool. The procedure involves performing a base brake bleeding, followed by use of the scan tool to cycle and bleed the HCU pump and solenoids. A second base brake bleeding procedure is then required to remove any air remaining in the system.
Manual/Base System
- Remove reservoir filler caps and fill reservoir with proper brake fluid.
- If calipers or wheel cylinders were overhauled, open all caliper and wheel cylinder bleed screws.
- Close each bleed screw as fluid starts to drip from them.
- Fil...
CLICK HERE TO GET FULL ACCESS TO 2006 Jeep Commander BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2006 Jeep Commander AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2006 Jeep Commander cars and light trucks from 1990+.
Disc Brakes -> Brake System Bleed -> Manual -> Master Cylinder -> Pressure
Vehicle: 2006 Jeep Commander Limited 5.7 V8 GAS
Manual
- Remove reservoir filler caps and fill reservoir with proper brake fluid.
- If calipers or wheel cylinders were overhauled, open all caliper and wheel cylinder bleed screws.
- Close each bleed screw as fluid starts to drip from them.
- Fill master cylinder reservoir once more before proceeding.
- Attach one end of bleed hose to bleed screw and insert opposite end in glass container partially filled with brake fluid, Fig. . Ensure bleed hose is immersed in fluid.
- Open up bleeder, then have an assistant press down brake pedal.
- Once brake pedal is down, close bleeder. Repeat bleeding unt...
CLICK HERE TO GET FULL ACCESS TO 2006 Jeep Commander BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2006 Jeep Commander AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2006 Jeep Commander cars and light trucks from 1990+.
Anti-Lock Brakes -> Jeep -> System Service -> 2002-04 -> 2002-04 Grand Cherokee -> 2002-05 -> 2002-05 Liberty -> 2005-06 -> 2005-06 Commander, Grand Cherokee & 2006 Liberty -> 2006 -> Anti-Lock Brake Module (ABM)/Hydraulic Control Unit (HCU) -> Brake System Bleed -> Commander -> Commander, Grand Cherokee & Liberty -> Component Replacement -> Controller Anti-Lock Brake (CAB) Module/Hydraulic Control Unit (HCU) -> Front Wheel Sensor -> Grand Cherokee -> Hydraulic Control Unit (HCU) -> Liberty -> Manual/Base System -> Master Cylinder Bleed -> Pressure Bleed -> Rear Wheel Sensor -> Wrangler
Vehicle: 2006 Jeep Commander 4.7 V8 GAS
Brake System Bleed
ABS system bleeding requires conventional bleeding methods plus use of the scan tool. The procedure involves performing a base brake bleeding, followed by use of the scan tool to cycle and bleed the HCU pump and solenoids. A second base brake bleeding procedure is then required to remove any air remaining in the system.
Manual/Base System
- Remove reservoir filler caps and fill reservoir with proper brake fluid.
- If calipers or wheel cylinders were overhauled, open all caliper and wheel cylinder bleed screws.
- Close each bleed screw as fluid starts to drip from them.
- Fil...
CLICK HERE TO GET FULL ACCESS TO 2006 Jeep Commander BRAKE SERVICE PROCEDURES
Shop online for auto body parts, engines, wheels, lights...
| More parts |
| Get the Complete Technical Service Bulletins! |
 Access diagrams and repair information such as wiring diagrams,
diagnosis and repair charts, manufacturer
service bulletins, and OEM Part
numbers of your 2006 Jeep Commander vehicle.
|
| Access the Complete guide! |
