Auto Parts Search
We have info for following modifications of 2006 Buick Rendezvous
- 2006 Buick Rendezvous CXL 3.6 V6 GAS, CID:217, Fuel Injection, Aspiration:217, Engine VIN:, Desg:7
- 2006 Buick Rendezvous CXL 3.5 V6 GAS, CID:213, Fuel Injection, Aspiration:213, Engine VIN:, Desg:L
- 2006 Buick Rendezvous CX 3.6 V6 GAS, CID:217, Fuel Injection, Aspiration:217, Engine VIN:, Desg:7
- 2006 Buick Rendezvous CX 3.5 V6 GAS, CID:213, Fuel Injection, Aspiration:213, Engine VIN:, Desg:L
BRAKE SERVICE PROCEDURES FOR 2006 Buick Rendezvous AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2006 Buick Rendezvous cars and light trucks from 1990+.
Disc Brakes -> Delco Single Piston Sliding Caliper -> Troubleshooting -> Brake Rattle -> Brake Roughness Or Chatter; Pedal Pumping -> Caliper Brake Fluid Leak -> Excessive Pedal Effort -> Excessive Pedal Travel -> Heavy Brake Drag -> No Braking Effect When Brake Pedal Is Depressed -> Pull, Uneven Or Grabbing Brakes -> Rear Brakes Locking On Application
Vehicle: 2006 Buick Rendezvous CX 3.5 V6 GAS
Excessive Pedal Travel
- Worn brake linings.
- Disc pads knock back after cornering or rough road travel.
- Piston and linings not properly seated or positioned.
- Insufficient fluid in system.
- Loose wheel bearing adjustment.
- Damaged or worn caliper piston seal.
- Improper booster pushrod adjustment.
- Pads out of flat more than .005 inch.
- Rear brake automatic adjusters inoperative.
- Improperly ground rear brake shoes.
Brake Roughness Or Chatter; Pedal Pumping
- Excessive lateral runout of rotor.
- Rotor excessively out of parallel.
Excessive Pedal Effort
- Frozen or seized pistons.
- Brake fluid, oil or grease on ...
CLICK HERE TO GET FULL ACCESS TO 2006 Buick Rendezvous BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2006 Buick Rendezvous AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2006 Buick Rendezvous cars and light trucks from 1990+.
Hydraulic Brake Systems -> Component Service -> Assemble -> Bendix Master Cylinder -> Delco Master Cylinder -> Disassemble -> Tracker Master Cylinder -> Wheel Cylinder
Vehicle: 2006 Buick Rendezvous CXL 3.5 V6 GAS
Delco Master Cylinder
When performing the following procedures, refer to Figs. and , noting that the composite reservoir may vary in design.
Disassemble
- Remove master cylinder from vehicle.
- Remove reservoir cover and diaphragm. Discard old brake fluid in reservoir.
- Inspect cover and diaphragm. Replace if cut, cracked or deformed.
- Remove fluid level switch and proportioning valve assembly, if equipped.
- Depress primary piston and remove lock ring.
- Plug primary fluid outlet (outlet nearest to cowl when master cylinder is installed), then apply compressed air into secondary fluid outlet ...
CLICK HERE TO GET FULL ACCESS TO 2006 Buick Rendezvous BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2006 Buick Rendezvous AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2006 Buick Rendezvous cars and light trucks from 1990+.
Disc Brakes -> Delco Single Piston Sliding Caliper -> Brake Pad Service -> Installation -> Removal
Vehicle: 2006 Buick Rendezvous CX 3.6 V6 GAS
Removal
- Remove caliper as outlined under .
- Remove inboard pad with retainer spring.
- Remove outboard pad and position caliper on front suspension so brake hose will not support weight of caliper.
- Remove two sleeves from inboard ears of caliper.
- Remove four rubber bushings from grooves in each of caliper ears.
Installation
- Lubricate new sleeves, rubber bushings, bushing grooves and mounting bolt ends with lubricant part No. 19010909, or equivalent.
- Install new bushings and sleeves in caliper ...
CLICK HERE TO GET FULL ACCESS TO 2006 Buick Rendezvous BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2006 Buick Rendezvous AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2006 Buick Rendezvous cars and light trucks from 1990+.
Power Brake Units -> Delco Brake Booster -> Brake System Bleed -> Hydraulic System Flush -> Manual Bleed -> Master Cylinder Bleed -> Parking Brake Bleed -> Pressure Bleed
Vehicle: 2006 Buick Rendezvous CXL 3.5 V6 GAS
Manual Bleed
- If vehicle is equipped with power brakes, remove vacuum reserve by applying brakes several times with engine off.
- Fill master cylinder reservoirs with suitable brake fluid. Ensure to always keep master cylinder reservoirs at least half full during entire bleeding procedure.
- If master cylinder is suspected to have air in bore, it must be bled first. To bleed master cylinder, proceed as follows:
- Disconnect forward brake pipe connection at master cylinder.
- Allow brake fluid to fill master cylinder bore until it begins to flow from forward pipe connector port.
- Connect and ...
CLICK HERE TO GET FULL ACCESS TO 2006 Buick Rendezvous BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2006 Buick Rendezvous AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2006 Buick Rendezvous cars and light trucks from 1990+.
Disc Brakes -> Delco Single Piston Sliding Caliper -> Precautions -> Brake Disc Service -> Brake Lines & Linings -> Brake Roughness -> General
Vehicle: 2006 Buick Rendezvous CX 3.5 V6 GAS
Brake Lines & Linings
Remove one of the front wheels and inspect the brake disc, caliper and linings.
Do not allow any oil or grease on the linings. It is recommended that linings be replaced in sets when worn or damaged.
If the caliper is cracked or fluid leakage through the casting is evident, it must be replaced as a unit.
Brake Roughness
The most common cause of brake chatter on disc brakes is a variation in thickness of the disc. If roughness or vibration is encountered during highway operation or if pedal pumping is experienced at low speeds, the disc may have excessive thickness v...
CLICK HERE TO GET FULL ACCESS TO 2006 Buick Rendezvous BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2006 Buick Rendezvous AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2006 Buick Rendezvous cars and light trucks from 1990+.
Power Brake Units -> Delco Brake Booster -> Power Brake Unit, Replace -> Astro, Avalanche, Escalade EXT, Safari, Sierra, Silverado & SSR -> Aztek & Rendezvous -> Blazer, Bravada, Envoy, Jimmy, Rainier & Trailblazer -> Canyon, Colorado, Sonoma & S10 -> Equinox & Torrent -> Escalade, HHR, Suburban, Tahoe & Yukon -> Express & Savana -> Hummer H2 -> Hummer H3 -> Montana, Silhouette & Venture -> Relay, Terraza, SV6 & Uplander -> SRX -> Vue
Vehicle: 2006 Buick Rendezvous CXL 3.5 V6 GAS
Aztek & Rendezvous
- Remove coolant reservoir, then relieve fuel system pressure as follows:
- Loosen fuel filler cap to discharge tank pressure.
- Connect fuel pressure gauge tool No. J-34730-1A, or equivalent, to fuel pressure connection. Wrap shop towel around connection while connecting fuel pressure gauge in order to avoid fuel spillage.
- Install bleed hose into an approved container and open valve in order to bleed fuel system pressure.
- Drain any fuel remaining in fuel pressure gauge into suitable container.
- Remove cruise control cable from module, then disconnect electrical ...
CLICK HERE TO GET FULL ACCESS TO 2006 Buick Rendezvous BRAKE SERVICE PROCEDURES
Shop online for auto body parts, engines, wheels, lights...
More parts |
Get the Complete Technical Service Bulletins! |
Access diagrams and repair information such as wiring diagrams, diagnosis and repair charts, manufacturer service bulletins, and OEM Part numbers of your 2006 Buick Rendezvous vehicle. |
Access the Complete guide! |