Auto Parts Search
BRAKE SERVICE PROCEDURES FOR 2005 Acura TL AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2005 Acura TL cars and light trucks from 1990+.
Acura -> Power Brake Units -> Diagnosis & Testing -> Check Valve Test -> Function Test -> Leak Test
Vehicle: 2005 Acura TL 3.2 V6 GAS
Function Test
- With engine stopped, deplete vacuum reservoir by depressing brake pedal several times.
- Depress pedal hard and hold for 15 seconds. If pedal sinks, either of the following may exist:
- Master cylinder is bypassing internally.
- Master cylinder, lines, modulator proportioning valve or caliper are leaking.
- With brake pedal depressed, start engine. Not the following:
- If pedal sinks slightly, vacuum booster is operating normally.
- If pedal height does not vary, booster or check valve is faulty.
- With engine running, depress brake pedal lightly to keep automatic transaxle from cre...
CLICK HERE TO GET FULL ACCESS TO 2005 Acura TL BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2005 Acura TL AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2005 Acura TL cars and light trucks from 1990+.
Acura -> Power Brake Units -> Power Brake Unit Service -> Replace
Vehicle: 2005 Acura TL 3.2 V6 GAS
Replace
Do not disassemble brake booster. If replacement is required, replace entire booster.
- Remove master cylinder as outlined under.
- Disconnect brake booster vacuum hose.
- On RL models, remove engine wire harness from brackets and position it aside.
- On TSX models, remove cover, mounting bolt and underhood fuse/relay box.
- On TL and TSX models, remove air cleaner.
- On 3.2CL and 3.2TL models, proceed as follows:
- Remove fuel feed line bracket.
- Remove starter cable clamps.
- Remove windshield wiper intermittent relay bracket.
- On all models, remove lock, cotter and clevis pins. Do not di...
CLICK HERE TO GET FULL ACCESS TO 2005 Acura TL BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2005 Acura TL AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2005 Acura TL cars and light trucks from 1990+.
Acura -> Hydraulic Brake Systems -> Component Service
Vehicle: 2005 Acura TL 3.2 V6 GAS
Components are not designed to be rebui...
CLICK HERE TO GET FULL ACCESS TO 2005 Acura TL BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2005 Acura TL AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2005 Acura TL cars and light trucks from 1990+.
Acura -> Power Brake Units -> Adjustments -> Brake Pedal Height -> Pushrod Clearance
Vehicle: 2005 Acura TL 3.2 V6 GAS
Brake Pedal Height
- Disconnect brake switch connector.
- Loosen brake switch locknut and back switch off until no longer touches brake pedal.
- Turn up floor mat and measure pedal height from lefthand center of pedal pad
- Loosen locknut and turn pushrod to specified height, Fig. .
- Torque locknut to 11 ft. lbs.
- On 3.2CL, 3.2TL and 3.2RL models, turn in brake light switch until plunger is fully depressed. Back switch off 1/4 turn to .01 inch clearance. Tighten locknut.
- On RL, RSX, TL, TSX and MDX models, turn in brake light switch until plunger is fully depressed. Turn switch 45º clockwise to lock...
CLICK HERE TO GET FULL ACCESS TO 2005 Acura TL BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2005 Acura TL AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2005 Acura TL cars and light trucks from 1990+.
Acura -> Hydraulic Brake Systems -> Precautions -> Radio Coded Theft Protection System
Vehicle: 2005 Acura TL 3.2 V6 GAS
Radio Coded Theft Protection System
Anti-theft radios have a coded theft protection circuit. The security code number must be obtained before disconnecting battery, removing radio fuse or ...
CLICK HERE TO GET FULL ACCESS TO 2005 Acura TL BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2005 Acura TL AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2005 Acura TL cars and light trucks from 1990+.
Acura -> Hydraulic Brake Systems -> Brake System Bleed -> Anti-Lock Brake System (ABS) -> Conventional Brake System
Vehicle: 2005 Acura TL 3.2 V6 GAS
Conventional Brake System
- Fill master cylinder reservoir with brake fluid.
- Raise and support vehicle.
- Position drain pan under lefthand front wheel.
- Have an assistant depress brake pedal with slow, even pressure and hold it down. Only press pedal halfway to floor. Do not depress brake pedal to end of master cylinder stroke.
- Open bleed valve one full turn. Watch for air bubbles in fluid and listen for air escaping from system.
- With brake pedal still depressed, close bleeder valve.
- Have an assistant pump brake pedal several times. Do not depress brake pedal fully to end of master cyli...
CLICK HERE TO GET FULL ACCESS TO 2005 Acura TL BRAKE SERVICE PROCEDURES
Shop online for auto body parts, engines, wheels, lights...
More parts |
Get the Complete Technical Service Bulletins! |
Access diagrams and repair information such as wiring diagrams, diagnosis and repair charts, manufacturer service bulletins, and OEM Part numbers of your 2005 Acura TL vehicle. |
Access the Complete guide! |