Auto Parts Search
We have info for following modifications of 2003 Buick Regal
- 2003 Buick Regal GS 3.8 V6 GAS, CID:231, Fuel Injection, Aspiration:231, Engine VIN:, Desg:1
- 2003 Buick Regal LS 3.8 V6 GAS, CID:231, Fuel Injection, Aspiration:231, Engine VIN:, Desg:K
MAINTENANCE LAMP RESET PROCEDURES FOR 2003 Buick Regal AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2003 Buick Regal cars and light trucks sold in the U.S. from 1990+.
General Motors Corp./Saturn Cars -> Active Handling System Warning Lamp ->
Vehicle: 2003 Buick Regal LS 3.8 V6 GAS
This lamp should light for a approximately 6-8 seconds when the ignition is turned on as a bulb check. The lamp will also come on as the system is...
CLICK HERE TO GET FULL ACCESS TO 2003 Buick Regal MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2003 Buick Regal AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2003 Buick Regal cars and light trucks sold in the U.S. from 1990+.
General Motors Corp./Saturn Cars -> Tire Pressure Monitoring System (TPMS) Warning Indicator -> 1999-2004 Regal -> Reset
Vehicle: 2003 Buick Regal GS 3.8 V6 GAS
Reset
The Low Tire Pressure indicator will turn on when the pressure in one of the tires becomes 12 psi. lower or higher then the other three. The TPMS uses the ABS (Anti-Lock Brake System) wheel speed sensors to determine if a tire is low by a variation in wheel speed.
- Inflate all tires to vehicle manufacturer's specifications.
- Place the ignition s...
CLICK HERE TO GET FULL ACCESS TO 2003 Buick Regal MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2003 Buick Regal AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2003 Buick Regal cars and light trucks sold in the U.S. from 1990+.
General Motors Corp./Saturn Cars -> Change Oil, Change Oil Now Or Change Oil Soon Lamp & Messages -> 2000-04 Regal
Vehicle: 2003 Buick Regal GS 3.8 V6 GAS
To reset the Engine Oil Life monitor proceed as follows:
- Turn ignition on, but do not start engine.
- Fully depress and release accelerator pedal three times within five seconds. The oil life indicator will begin to flash indicating the system is resetting.
- Turn ignition Off, then s...
CLICK HERE TO GET FULL ACCESS TO 2003 Buick Regal MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2003 Buick Regal AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2003 Buick Regal cars and light trucks sold in the U.S. from 1990+.
General Motors Corp./Saturn Cars -> Anti-Lock Warning Lamp ->
Vehicle: 2003 Buick Regal GS 3.8 V6 GAS
This lamp should light when the ignition is turned On. The lamp may light for as long as 30 seconds as a bulb and system inspection. If lamp remains lit or lights while operating the vehicle, a fault condition in the anti-lock brake system is indicated. When lamp is lit, turn ignition Off, then restart engine. If l...
CLICK HERE TO GET FULL ACCESS TO 2003 Buick Regal MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2003 Buick Regal AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2003 Buick Regal cars and light trucks sold in the U.S. from 1990+.
General Motors Corp./Saturn Cars -> Check Engine Or Service Now Soon Engine Indicator Lamps (Gasoline Engines w/Electronic Engine Controls Or EFI) -> Except LeMans, Metro, Prizm, Storm & Vibe
Vehicle: 2003 Buick Regal GS 3.8 V6 GAS
The Check Engine lamp should light when the ignition is turned On. When the engine is started, the lamp should go off. If the lamp remains on for 10 seconds or constantly after the engine is started, the self diagnosis system has detected a fault condition and has stored a code in the system Electronic Control Module (ECM) or Powertrain Control Module (PCM). After diagnosis and repair, the ECM memory can be cleared of codes as follows:
On models except Cadillac with DEFI, remove the ECM/PCM fuse or disconnect the battery ground cable for approximately 30...
CLICK HERE TO GET FULL ACCESS TO 2003 Buick Regal MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2003 Buick Regal AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2003 Buick Regal cars and light trucks sold in the U.S. from 1990+.
General Motors Corp./Saturn Cars -> Check Engine Or Service Now Soon Engine Indicator Lamps (Gasoline Engines w/Electronic Engine Controls Or EFI) -> Except LeMans, Metro, Prizm, Storm & Vibe
Vehicle: 2003 Buick Regal LS 3.8 V6 GAS
The Check Engine lamp should light when the ignition is turned On. When the engine is started, the lamp should go off. If the lamp remains on for 10 seconds or constantly after the engine is started, the self diagnosis system has detected a fault condition and has stored a code in the system Electronic Control Module (ECM) or Powertrain Control Module (PCM). After diagnosis and repair, the ECM memory can be cleared of codes as follows:
On models except Cadillac with DEFI, remove the ECM/PCM fuse or disconnect the battery ground cable for approximately 30...
CLICK HERE TO GET FULL ACCESS TO 2003 Buick Regal MAINTENANCE LAMP RESET PROCEDURES
Shop online for auto body parts, engines, wheels, lights...
More parts |
Get the Complete Technical Service Bulletins! |
Access diagrams and repair information such as wiring diagrams, diagnosis and repair charts, manufacturer service bulletins, and OEM Part numbers of your 2003 Buick Regal vehicle. |
Access the Complete guide! |