Auto Parts Search
We have info for following modifications of 2001 Oldsmobile Aurora
- 2001 Oldsmobile Aurora 4.0 V8 GAS, CID:244, Fuel Injection, Aspiration:244, Engine VIN:, Desg:C
- 2001 Oldsmobile Aurora 3.5 V6 GAS, CID:214, Fuel Injection, Aspiration:214, Engine VIN:, Desg:H
BRAKE SERVICE PROCEDURES FOR 2001 Oldsmobile Aurora AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2001 Oldsmobile Aurora cars and light trucks from 1990+.
Anti-lock Brakes -> Delco/Bosch Type 5.3 -> Diagnosis & Testing -> Accessing Diagnostic Trouble Codes -> Aurora, Bonneville, LeSabre & Park Avenue -> Clearing Diagnostic Trouble Codes -> DeVille & Seville -> Diagnostic Tests -> Diagnostic Trouble Code Interpretation -> EBCM Connector Views -> Electromagnetic Interference Test -> Ignition Cycle Default -> Intermittents & Poor Connections -> Wiring Diagrams
Vehicle: 2001 Oldsmobile Aurora 4.0 V8 GAS
Accessing Diagnostic Trouble Codes
- Turn ignition switch to Off position.
- Connect suitably programmed scan tool connected to Data Link Connector (DLC), located on lefthand side of instrument panel below steering column.
- Turn ignition switch to On position.
- Select scan tool's Special Functions.
- Select and run Automated Test.
- Note Diagnostic Trouble Codes (DTCs).
Diagnostic Trouble Code Interpretation
Refer to Fig. for Diagnostic Trouble Code (DTC) identification and description.
Wiring Diagrams
Refer to "Wiring Diagrams" in "Vehicle Systems."
EBCM Connector Views
Refer to Figs. through for...
[[table data]] [[table data]]CLICK HERE TO GET FULL ACCESS TO 2001 Oldsmobile Aurora BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2001 Oldsmobile Aurora AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2001 Oldsmobile Aurora cars and light trucks from 1990+.
Hydraulic Brake Systems -> General Motors -> Description -> Brake Distribution Valve & Switch -> Brake Warning Lamp Switches -> Combination Valve -> Components -> Diagonally Split System -> Failure Warning Switch -> Fluid Level Sensor -> Front & Rear Split System -> Metering Valve -> Proportioning Or Pressure Control Valve -> Warning Lamp
Vehicle: 2001 Oldsmobile Aurora 4.0 V8 GAS
Front & Rear Split System
When the brake pedal is depressed, both the primary (front brake) and the secondary (rear brake) master cylinder pistons are moved simultaneously to exert hydraulic fluid pressure on their respective systems.
If the rear (secondary) brake system fails, initial brake pedal movement will cause the unrestricted secondary piston to bottom in the master cylinder bore. Primary piston movement will displace hydraulic fluid in the primary section of the master cylinder to actuate the front brake system.
If the front (primary) brake system fails, initial brake pedal mo...
CLICK HERE TO GET FULL ACCESS TO 2001 Oldsmobile Aurora BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2001 Oldsmobile Aurora AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2001 Oldsmobile Aurora cars and light trucks from 1990+.
Hydraulic Brake Systems -> General Motors -> Component Replacement -> Master Cylinder
Vehicle: 2001 Oldsmobile Aurora 4.0 V8 GAS
Master Cylinder
- On Vibe models, remove air filer hose clamp and hose from throttle body.
- On all models, disconnect fluid level sensor retainer and electrical connector.
- Drain master cylinder reservoir brake fluid into suita...
CLICK HERE TO GET FULL ACCESS TO 2001 Oldsmobile Aurora BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2001 Oldsmobile Aurora AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2001 Oldsmobile Aurora cars and light trucks from 1990+.
Disc Brakes -> AC-Delco Single Piston Rear Disc Brake (Type 2) -> Adjustments -> Parking Brake
Vehicle: 2001 Oldsmobile Aurora 4.0 V8 GAS
Parking Brake
- Cycle brake system as follows:
- Apply service brake with a pedal force of 175 lbs., and release.
- Fully apply parking brake using approximately 125 lbs., of force on final stroke, then release.
- Apply and release parking brake two additional times as described above.
- Inspect parking brake pedal assembly for full release by turning ignition On and observing brake warning lamp, which should be off.
- If brake warning lamp is on and parking brake appears to be fully released, operate manual pedal release lever and pull downward on front park brake cable to remove slack from pedal as...
CLICK HERE TO GET FULL ACCESS TO 2001 Oldsmobile Aurora BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2001 Oldsmobile Aurora AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2001 Oldsmobile Aurora cars and light trucks from 1990+.
Power Brake Units -> Troubleshooting -> Brakes Grab -> Hard Pedal/Brakes Inefficient -> Slow Or No Release
Vehicle: 2001 Oldsmobile Aurora 3.5 V6 GAS
Brakes Grab
- Contaminated, worn or faulty brake linings.
- Drum or brake rotor out-of-round.
- Faulty brake booster.
Hard Pedal/Brakes Inefficient
- Contaminated, glazed or faul...
CLICK HERE TO GET FULL ACCESS TO 2001 Oldsmobile Aurora BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2001 Oldsmobile Aurora AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2001 Oldsmobile Aurora cars and light trucks from 1990+.
Power Brake Units -> Adjustments -> AC-Delco Single Diaphragm Type -> AC-Delco Tandem Diaphragm Type -> Air Method -> Brake Pedal -> Gauge Method -> Pushrod -> Toyota/GM Single Diaphragm Type
Vehicle: 2001 Oldsmobile Aurora 3.5 V6 GAS
Brake Pedal
Toyota/GM Single Diaphragm Type
- With engine running and brake pedal in rest position, measure distance between face of pedal and floor mat.
- Distance should be 5.850-6.244 inches.
- If distance is not as specified, adjust pedal height as follows:
- Remove lefthand lower instrument panel trim section and air duct.
- Loosen stop lamp switch sufficiently to access pedal adjustment.
- Loosen locknut and rotate pedal pushrod as required to obtain specified pedal height. Tighten locknut.
- Adjust brake lamp switch position so plunger lightly contacts pedal stopper and brake lamps are off when pe...
CLICK HERE TO GET FULL ACCESS TO 2001 Oldsmobile Aurora BRAKE SERVICE PROCEDURES
Shop online for auto body parts, engines, wheels, lights...
More parts |
Get the Complete Technical Service Bulletins! |
Access diagrams and repair information such as wiring diagrams, diagnosis and repair charts, manufacturer service bulletins, and OEM Part numbers of your 2001 Oldsmobile Aurora vehicle. |
Access the Complete guide! |