Auto Parts Search
BRAKE SERVICE PROCEDURES FOR 2001 Acura TL AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2001 Acura TL cars and light trucks from 1990+.
Disc Brakes -> Caliper Service -> Assemble & Installation -> Front -> Integra, RSX, 2.2CL, 2.3CL, 2.5TL, 3.0CL & 1997-98 3.2TL -> MDX, 3.2CL, 3.5RL & 1999-2002 3.2TL -> Rear -> Removal & Disassemble
Vehicle: 2001 Acura TL 3.2 V6 GAS
Front
Removal & Disassemble
- Raise and support front of vehicle, then remove tire and wheel assemblies.
- Remove banjo bolt and disconnect brake line. Secure hose in raised position.
- Remove pin bolt and caliper, Figs. through .
- Remove pad spring.
- Position suitable block of wood or shop rag in caliper opposite piston.
- Remove piston by applying compressed air into fluid inlet port.
- Remove piston boot and seal.
Assemble & Installation
- Clean caliper bore and piston with brake fluid, then inspect for excessive wear or damage.
- Apply suitable grease and install new piston seal in cylinder groove.
- In...
CLICK HERE TO GET FULL ACCESS TO 2001 Acura TL BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2001 Acura TL AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2001 Acura TL cars and light trucks from 1990+.
Hydraulic Brake Systems -> Brake System Bleed -> Anti-Lock Brake (ALB) System -> Conventional Brake System
Vehicle: 2001 Acura TL 3.2 V6 GAS
Conventional Brake System
- Fill master cylinder reservoir with brake fluid.
- Raise and support vehicle.
- Position drain pan under righthand rear wheel.
- Have an assistant depress brake pedal with slow, even pressure and hold it down. Do not depress brake pedal to end of master cylinder stroke.
- Open bleed valve one full turn. Watch for air bubbles in fluid and listen for air escaping from system.
- With brake pedal still depressed, close bleeder valve.
- Have an assistant pump brake pedal several times. Do not depress brake pedal fully to end of master cylinder piston stroke.
- After bleeding ...
CLICK HERE TO GET FULL ACCESS TO 2001 Acura TL BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2001 Acura TL AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2001 Acura TL cars and light trucks from 1990+.
Hydraulic Brake Systems -> Component Replacement -> Master Cylinder
Vehicle: 2001 Acura TL 3.2 V6 GAS
Master Cylinder
- Disconnect primary and secondary brake lines from master cylinder.
- On models equipped with fluid level sensor, disc...
CLICK HERE TO GET FULL ACCESS TO 2001 Acura TL BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2001 Acura TL AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2001 Acura TL cars and light trucks from 1990+.
Power Brake Units -> Diagnosis & Testing -> Check Valve Test -> Function Test -> Leak Test
Vehicle: 2001 Acura TL 3.2 V6 GAS
Function Test
- With engine stopped, depress brake pedal several times.
- Depress pedal hard and hold for 15 seconds. If pedal sinks, master cylinder, brake line or brake caliper is faulty.
- With brake pedal depressed, start engine. If pedal sinks slightly, vacuum booster is operating. If pedal height does not vary, booster or check valve is faulty.
Leak Test
- With engine running, depress brake pedal and hold, then stop engine. If pedal height does not vary with brake pedal depr...
CLICK HERE TO GET FULL ACCESS TO 2001 Acura TL BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2001 Acura TL AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2001 Acura TL cars and light trucks from 1990+.
Anti-lock Brakes -> Description
Vehicle: 2001 Acura TL 3.2 V6 GAS
The anti-lock brake system modulates pressure of brake fluid to each caliper whenever wheels are likely to be locked due to excessive braking. This prevents locking of the wheels and allows for better handling of vehicle.
The anti-lock brake control unit receives input from individual speed sensors located at each wheel and from the ABS pressure switch. The anti-lock brake control unit uses inputs to control the modulator unit, which adjusts hydraulic pressure applied to each caliper o...
CLICK HERE TO GET FULL ACCESS TO 2001 Acura TL BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2001 Acura TL AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2001 Acura TL cars and light trucks from 1990+.
Hydraulic Brake Systems -> Component Service
Vehicle: 2001 Acura TL 3.2 V6 GAS
Components are not designed to be rebuilt. If...
CLICK HERE TO GET FULL ACCESS TO 2001 Acura TL BRAKE SERVICE PROCEDURES
Shop online for auto body parts, engines, wheels, lights...
More parts |
Get the Complete Technical Service Bulletins! |
Access diagrams and repair information such as wiring diagrams, diagnosis and repair charts, manufacturer service bulletins, and OEM Part numbers of your 2001 Acura TL vehicle. |
Access the Complete guide! |