Auto Parts Search
We have info for following modifications of 2000 Honda Prelude
- 2000 Honda Prelude 2.2 L4 GAS, CC:2156, Fuel Injection
- 2000 Honda Prelude SH 2.2 L4 GAS, CC:2156, Fuel Injection
BRAKE SERVICE PROCEDURES FOR 2000 Honda Prelude AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2000 Honda Prelude cars and light trucks from 1990+.
Anti-lock Brakes -> System Service -> 1997-2000 -> 1997-2001 -> 2002 -> Accord -> Accord & Odyssey -> Accumulator -> Accumulator Disposal -> Brake Fluid Change -> Brake System Bleed -> Civic -> Civic & CR-V -> Component Replacement -> Control Unit -> CR-V -> del Sol -> del Sol & Prelude -> Front -> Front Speed Sensor -> Modulator -> Odyssey -> Prelude -> Pulser & Sensor Gap Measurement -> Rear -> Rear Speed Sensor -> S2000 -> System Pressure Relief
Vehicle: 2000 Honda Prelude 2.2 L4 GAS
System Pressure Relief
Accord & Odyssey
- Remove bleeder cap from maintenance bleeder on modulator unit, then attach a suitable wrench to bleeder.
- Connect a rubber tube to bleeder and place other end in a container, Fig. .
- While holding tube in hand, loosen maintenance bleeder 1/8- 1/4 turn and collect fluid in container. Do not loosen bleeder too much; brake fluid is under high pressure and can burst out.
- Tighten maintenance bleeder to specification.
del Sol
- Drain brake fluid from master cylinder and modulator reservoir thoroughly as outlined under "Brake Fluid Change."
- Using bleeder t-wre...
CLICK HERE TO GET FULL ACCESS TO 2000 Honda Prelude BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2000 Honda Prelude AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2000 Honda Prelude cars and light trucks from 1990+.
Hydraulic Brake Systems -> Component Replacement -> Master Cylinder, Replace
Vehicle: 2000 Honda Prelude SH 2.2 L4 GAS
Master Cylinder, Replace
- Remove master cylinder reservoir cap, then suck fluid from reservoir with a suitable syringe.
- Disconnect brake lines from master cylinder, then all necessary electrical connectors.
- Remove master cylinder to brake booster retaining nuts.
- Remov...
CLICK HERE TO GET FULL ACCESS TO 2000 Honda Prelude BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2000 Honda Prelude AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2000 Honda Prelude cars and light trucks from 1990+.
Disc Brakes -> Caliper Service -> Assemble -> Disassemble -> Front -> Overhaul -> Rear -> Replace
Vehicle: 2000 Honda Prelude 2.2 L4 GAS
Front
Replace
Ensure dirt or other foreign matter is not allowed to contaminate brake fluid. Do not mix different types of brake fluid, as they might not be compatible.
- Refer to Figs. through when replacing calipers.
- Raise and support front of vehicle, then remove wheel and tire assemblies.
- Remove banjo bolt and disconnect brake hose from caliper.
- Remove caliper bolts, then the caliper.
- Reverse procedure to install.
Overhaul
Disassemble
- Refer toFigs. through when overhauling calipers.
- Remove caliper assembly from vehicle as outlined under " Brake Pad Service."
- Remove pad spring from calip...
CLICK HERE TO GET FULL ACCESS TO 2000 Honda Prelude BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2000 Honda Prelude AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2000 Honda Prelude cars and light trucks from 1990+.
Anti-lock Brakes -> Diagnosis & Testing -> 1997 -> 1997 Accord -> 1997-2000 -> 1997-2000 Civic -> 1997-2001 -> 1997-2001 CR-V -> 1997-98 -> 1997-98 Odyssey -> 1998-2002 -> 1998-2002 Accord -> 1999-2002 -> 1999-2002 Odyssey -> 2001-02 -> 2001-02 Civic -> 2002 -> 2002 CR-V -> Accessing Diagnostic Trouble Codes -> Accord -> Accord & Odyssey -> Accord & S2000 -> Civic -> Clearing Diagnostic Trouble Codes -> CR-V -> del Sol -> Diagnostic Tests -> Diagnostic Trouble Code Interpretation -> Function Test -> Modulator Function Inspection -> Odyssey -> Prelude -> S2000 -> Solenoid Leak Test -> System Tests -> Wheel Sensor Signal Confirmation -> Wiring Diagrams
Vehicle: 2000 Honda Prelude SH 2.2 L4 GAS
Accessing Diagnostic Trouble Codes
Accord
1997
- Connect SCS service connector to service check connector under glove compartment, Fig. .
- Turn ignition switch on, but do not start engine.
- Record blinking frequency of ABS indicator light. Blinking frequency indicates diagnostic trouble code. Memory of diagnostic trouble code is erased if connector is disconnected from ABS control unit.
1998-2002
- Connect PGM tester to 16-pin DLC located behind driver's side kick panel with ignition switch off.
- Select "SCS" on the display, then press "Yes" at "Service Check Signal" mode.
- Turn ignition switch to...
CLICK HERE TO GET FULL ACCESS TO 2000 Honda Prelude BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2000 Honda Prelude AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2000 Honda Prelude cars and light trucks from 1990+.
Drum Brakes -> Parking Drum Brake Shoe, Replace -> CR-V & Odyssey
Vehicle: 2000 Honda Prelude SH 2.2 L4 GAS
CR-V & Odyssey
- Raise and support vehicle, then remove rear wheels.
- Release parking brake, then remove rear brake caliper and brake disc/drum as outlined under "Disc Brakes."
- Disconnect and remove upper return springs, Figs. and .
- Remove retainers and tension pins.
- Disconnect rod spring and remove connecting rod.
- Remove lower return spring, adjuster assembly and forward brake shoe.
- Disconnect parking brake cable from parking brake lever, then remove rear br...
CLICK HERE TO GET FULL ACCESS TO 2000 Honda Prelude BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2000 Honda Prelude AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2000 Honda Prelude cars and light trucks from 1990+.
Disc Brakes -> Caliper Service -> Assemble -> Disassemble -> Front -> Overhaul -> Rear -> Replace
Vehicle: 2000 Honda Prelude SH 2.2 L4 GAS
Front
Replace
Ensure dirt or other foreign matter is not allowed to contaminate brake fluid. Do not mix different types of brake fluid, as they might not be compatible.
- Refer to Figs. through when replacing calipers.
- Raise and support front of vehicle, then remove wheel and tire assemblies.
- Remove banjo bolt and disconnect brake hose from caliper.
- Remove caliper bolts, then the caliper.
- Reverse procedure to install.
Overhaul
Disassemble
- Refer toFigs. through when overhauling calipers.
- Remove caliper assembly from vehicle as outlined under " Brake Pad Service."
- Remove pad spring from calip...
CLICK HERE TO GET FULL ACCESS TO 2000 Honda Prelude BRAKE SERVICE PROCEDURES
Shop online for auto body parts, engines, wheels, lights...
More parts |
Get the Complete Technical Service Bulletins! |
Access diagrams and repair information such as wiring diagrams, diagnosis and repair charts, manufacturer service bulletins, and OEM Part numbers of your 2000 Honda Prelude vehicle. |
Access the Complete guide! |