Auto Parts Search
MAINTENANCE LAMP RESET PROCEDURES FOR 1998 Isuzu Trooper AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 1998 Isuzu Trooper cars and light trucks sold in the U.S. from 1990+.
Isuzu -> Intelligent Suspension Control (ISC) Indicator Lamp ->
Vehicle: 1998 Isuzu Trooper 3.5 V6 GAS
The Intelligent Suspension Control (ISC) indicator lamp will illuminate when the ignition switch is placed in the on position and should go off when the engine is started. If the lamp remains on or comes on while driving, a fault in the Intelligent Suspension Control is present. After diagnosis and repairs, then DTCs may be cleared as follows:
- Connect a ju...
CLICK HERE TO GET FULL ACCESS TO 1998 Isuzu Trooper MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 1998 Isuzu Trooper AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 1998 Isuzu Trooper cars and light trucks sold in the U.S. from 1990+.
Isuzu -> Traction Control System Warning Lamp ->
Vehicle: 1998 Isuzu Trooper 3.5 V6 GAS
This lamp should light for approximately 6-8 seconds when the ignition is turned on as a bulb check. If the warnin...
CLICK HERE TO GET FULL ACCESS TO 1998 Isuzu Trooper MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 1998 Isuzu Trooper AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 1998 Isuzu Trooper cars and light trucks sold in the U.S. from 1990+.
Isuzu -> Malfunction Indicator Lamp (MIL) -> 1996-98 Rodeo, Hombre & Trooper
Vehicle: 1998 Isuzu Trooper 3.5 V6 GAS
The Malfunction Indicator Lamp (MIL) looks the same as the MIL you are already familiar with (Check Engine lamp). However, OBD II requires that it illuminates under a strict set of guide lines.
Basically, the MIL is turned on when the PCM detects a DTC that will impact the vehicle emissions. The MIL will be turned on if an emissions related diagnostic test indicates a fault has occurred. It will stay on until the system or component passes the same test for three consecutive trips, with no emissions related faults. Although the MIL has been turned off, the DTC wil...
CLICK HERE TO GET FULL ACCESS TO 1998 Isuzu Trooper MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 1998 Isuzu Trooper AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 1998 Isuzu Trooper cars and light trucks sold in the U.S. from 1990+.
Isuzu -> Anti-Lock Brake System (ABS) Warning Lamp -> 1997-2002 Trooper
Vehicle: 1998 Isuzu Trooper 3.5 V6 GAS
The ABS warning lamp is used to warn of an ABS fault. The lamp input monitors the condition of the system. The lamp will be lit during engine start-up, but should go out when the self-diagnostic system determines that the system is functioning properly. If the lamp remains lit, an ABS fault is indicated. After system diagnosis and repair are complete, turn lamp off as follows:
- With ignitio...
CLICK HERE TO GET FULL ACCESS TO 1998 Isuzu Trooper MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 1998 Isuzu Trooper AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 1998 Isuzu Trooper cars and light trucks sold in the U.S. from 1990+.
Isuzu -> Change Trans Fluid Indicator ->
Vehicle: 1998 Isuzu Trooper 3.5 V6 GAS
This message will appear on the DIC (Driver Information Center) when it is time to change the transmission fluid....
CLICK HERE TO GET FULL ACCESS TO 1998 Isuzu Trooper MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 1998 Isuzu Trooper AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 1998 Isuzu Trooper cars and light trucks sold in the U.S. from 1990+.
Isuzu -> Check Trans. Indicator Lamp -> Amigo, Axiom, Rodeo, Rodeo Sport, Trooper & VehiCROSS
Vehicle: 1998 Isuzu Trooper 3.5 V6 GAS
On models equipped with automatic transmission,the Check Trans. lamp should illuminate for a few seconds after the ignition switch is placed in the on position. If the lamp is flashing, the computer controlling the transmission has detected a fault. The computer will place the transmission in the back up mode. In...
CLICK HERE TO GET FULL ACCESS TO 1998 Isuzu Trooper MAINTENANCE LAMP RESET PROCEDURES
Shop online for auto body parts, engines, wheels, lights...
More parts |
Get the Complete Technical Service Bulletins! |
Access diagrams and repair information such as wiring diagrams, diagnosis and repair charts, manufacturer service bulletins, and OEM Part numbers of your 1998 Isuzu Trooper vehicle. |
Access the Complete guide! |