1995 Jeep Grand Cherokee Brake Service (ONLINE REPAIR MANUALS)

When working on or around brake assemblies, care must be taken to prevent breathing asbestos dust, as many manufacturers incorporate asbestos fibers in the production of brake linings. During routine service operations, the amount of asbestos dust from brake lining wear is at a low level due to a chemical breakdown during use, and a few precautions will minimize exposure. Do not sand or grind brake linings unless suitable local exhaust ventilation equipment is used to prevent excessive asbestos exposure.

• We...

When working on or around brake assemblies, care must be taken to prevent breathing asbestos dust, as many manufacturers incorporate asbestos fibers in the production of brake linings. During routine service operations, the amount of asbestos dust from brake lining wear is at a low level due to a chemical breakdown during use, and a few precautions will minimize exposure. Do not sand or grind brake linings unless suitable local exhaust ventilation equipment is used to prevent excessive asbestos exposure.

• We...

The only serviceable power brake booster components are the vacuum hose and the check valve. The power brake booster must be serviced as an assembly. If diagnosis indicates a power brake booster fault, the unit must be replaced as an assembly.

Replacement

Full Size Pickups & Vans

1992

Transverse Mount

• Disconnect vacuum hose from power booster.
• Remove master cylinder to booster attaching nuts, then the master cylinder.
• Remove booster pushrod to pivot attaching bolts.
• Remove power booster attaching nuts, then the power booster assembly.
• Reverse procedure to install.

Inline Mount

• Dis...

These self contained vacuum hydraulic power braking units are of the vacuum suspended type. They use engine intake manifold vacuum or a vacuum pump, along with atmospheric pressure, for their power, eliminating the need for a vacuum reservoir. A mechanically operated control valve, with integral vacuum power diaphragms, controls degree of brake application or release depending on amount of foot pressure applied t...

Accessing Diagnostic Trouble Codes

• Connect DRB scan tool to data link connector, then place ignition switch in On position. Note the following:
• On 1992-95 models, refer to Figs. through for data link connector locations.
• On 1996 models, data link connector is located beneath lefthand side of instrument panel, near steering column.
• On all models, at DRB screen prompts, select "System / Anti-Lock Brakes / Teves," then read and record module information and any diagnostic trouble codes that are output.
• Refer to "Diagnostic Trouble Code Interpretation" to determine proper corrective ac...

The disc brake is of the floating caliper, single piston design. The caliper, Figs. and , is fixed by two mounting bolts located in the caliper support bracket, and is positioned over the rotor. It slides on two mounting pins which maintain caliper position relative to rotor and caliper anchor plate. A...