Auto Parts Search
1993 Land Rover Defender 110 CAR/TRUCK REPAIR PROCEDURES AND DIAGRAMS - WHAT Land Rover REPAIR SHOPS DON'T WANT YOU TO KNOW
Learn how to repair a car or truck, install or remove parts, wire an engine, reset warning lights, replace fuel filter, fix auto body and more. Get Automotix DIY!Select Section
- Technical Service Bulletins
- Specifications
- A/C & Heater Service
- Fuel Filter Replacement
- Driveline, U-Joint & CV Axles Replacement
- Starter & Alternator Replacement
- Maintenance Lamp Reset
- Radiator & Hose Replacement
- Serpentine Belt Service
A/C & HEATER SERVICE PROCEDURES FOR 1993 Land Rover Defender 110 AUTOMOBILES
Imported Cars & Light Trucks & Vans -> 1993-95 -> Exercise System
Vehicle: 1993 Land Rover Defender 110 3.9 V8 GAS
An important fact most car owners ignore is that A/C systems must be used periodically. Car manufacturers caution that when the air conditioner is not used regularly, particularly during cold months, it should be turned on for a few minutes once every two or three weeks while the engine is running. This keeps the system in good operating condition.
Checking out the system for the effects of disuse before the onset of summer is one of the most important aspects of A/C system servicing.
First clean out the condenser core, mounted in all cases at the front of the cars...
CLICK HERE TO GET FULL ACCESS TO 1993 Land Rover Defender 110 A/C & HEATER SERVICE PROCEDURES
FUEL FILTER REPLACEMENT PROCEDURES FOR 1993 Land Rover Defender 110 AUTOMOBILES
Land Rover -> Component Locations -> Defender & Range Rover
Vehicle: 1993 Land Rover Defender 110 3.9 V8 GAS
Refer to...
CLICK HERE TO GET FULL ACCESS TO 1993 Land Rover Defender 110 FUEL FILTER REPLACEMENT PROCEDURES
DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES FOR 1993 Land Rover Defender 110 AUTOMOBILES
DRIVESHAFT U-JOINT, Replace -> Assemble -> Disassemble
Vehicle: 1993 Land Rover Defender 110 3.9 V8 GAS
Disassemble
Caution: To ensure correct assembly and reduce possibility of imbalance, (before removing propeller shaft joint). Mark position of spider pin lubricator relative to journal yoke ears.
- Remove driveshaft from vehicle.
- Thoroughly examine universal joint for signs of damage or wear. Replace if necessary.
- Clean universal joint bearing cups and circlips.
- Remove circlips, and grease nipple.
- Tap yokes to eject bearing cups.
- Remove bearing cups and spider.
- Repeat instructions one to five for opposite end of propeller shaft if necessary.
- Clean yokes and bearing cup location...
CLICK HERE TO GET FULL ACCESS TO 1993 Land Rover Defender 110 DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES
STARTER & ALTERNATOR REPLACEMENT PROCEDURES FOR 1993 Land Rover Defender 110 AUTOMOBILES
Alternator, Replace
Vehicle: 1993 Land Rover Defender 110 3.9 V8 GAS
- Disconnect battery ground cable from battery.
- Remove drive belt.
- Remove alternator mounting bolts.
- Remove alternator from mounting bracket to gain access to electrical connections.
- Remove protective cover from electrical connections.
- Remove two nuts securing lea...
CLICK HERE TO GET FULL ACCESS TO 1993 Land Rover Defender 110 STARTER & ALTERNATOR REPLACEMENT PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 1993 Land Rover Defender 110 AUTOMOBILES
Land Rover -> Air Bag Warning Lamp ->
Vehicle: 1993 Land Rover Defender 110 3.9 V8 GAS
If the Air Bag warning lamp lights and stays on, diagnosis and ...
CLICK HERE TO GET FULL ACCESS TO 1993 Land Rover Defender 110 MAINTENANCE LAMP RESET PROCEDURES
RADIATOR & HOSE REPLACEMENT PROCEDURES FOR 1993 Land Rover Defender 110 AUTOMOBILES
Radiator, Replace
Vehicle: 1993 Land Rover Defender 110 3.9 V8 GAS
- Drain cooling system into suitable container.
- Disconnect radiator top hoses.
- Remove fan cowl and fan blade assembly.
- Disconnect four transmission and engine oil cooler connections to radiator end tan...
CLICK HERE TO GET FULL ACCESS TO 1993 Land Rover Defender 110 RADIATOR & HOSE REPLACEMENT PROCEDURES
SERPENTINE BELT SERVICE PROCEDURES FOR 1993 Land Rover Defender 110 AUTOMOBILES
Serpentine Drive Belt, Replace -> Installation -> Removal
Vehicle: 1993 Land Rover Defender 110 3.9 V8 GAS
Removal
- Remove upper fan cowl.
- Relieve drive belt tension by turning belt tensioner clockwise.
- Remove belt from alternator pulley, then release tensioner pulley.
- Remove drive belt. If reusing belt, mark direction of rotation on belt.
Installation
- Clean drive belt pu...
CLICK HERE TO GET FULL ACCESS TO 1993 Land Rover Defender 110 SERPENTINE BELT SERVICE PROCEDURES
TECHNICAL SERVICE BULLETINS FOR 1993 Land Rover Defender 110 AUTOMOBILES
OEM TSB listings for most 1993 Land Rover Defender 110 cars and light trucks sold in the U.S. from 1985+.
Document: WINDSHIELD WIPER NOISE, JUDDER OR STREAKING - CLEANING PROCEDURE Vehicle: 1993 Land Rover Defender 110 3.9 V8 GAS Symptoms: |
Document: Speaker Vibration or Rattle Noise Diagnosis Vehicle: 1993 Land Rover Defender 110 3.9 V8 GAS Symptoms: |
CLICK HERE TO GET FULL ACCESS TO 1993 Land Rover Defender 110 TECHNICAL SERVICE BULLETINS!
COMPONENT/PARTS SPECIFICATIONS FOR 1993 Land Rover Defender 110 AUTOMOBILES
BRAKE SPECIFICATIONS: Brake drum, rotor, caliper, and related specifications for most 1993 Land Rover Defender 110 cars and light trucks sold in the U.S. and Canada from 1970+.
- Brake caliper mounting bolt torque
- Brake drum runout, machining, & discard specs
- Minimum brake lining thickness.
- Brake rotor runout, parallelism, machining, discard, & finish specs
A/C SYSTEM SPECIFICATIONS: Air conditioning refrigerant capacity and type as well as lubricant capacity for most 1993 Land Rover Defender 110 cars and light trucks sold in the U.S. and Canada from 1980+.
- Refrigerant capacity & type, compressor oil viscosity, total system oil capacity & compressor clutch gap
COOLING SYSTEM BLEED: Cooling system bleeder valve identification, bleeder type and bleed procedures for most domestic and imported cars and light trucks sold in the U.S. and Canada from 1986+.
PREVENTIVE MAINTENANCE: Preventive maintenance recommendations and required services for most domestic and imported cars and light trucks sold in the U.S. and Canada from 1980+. Includes severe and routine service schedules
QUICK-LUBE and ILLUSTRATIONS: Fluid recommendations, capacities, drain plug torques, tire data, and severe service recommended preventive maintenance schedules. Information covers most 1993 Land Rover Defender 110 cars and light trucks sold in the U.S. and Canada from 1980+. Engine and chassis service images.
- Automatic transmission/transaxles capacities, lubricant recommendations
- Differential/final drive capacities, lube recommendations, grades, & viscosities
- Final drive fill & drain plug torques
- Number of lubrication fittings & plugs
- Power steering, brake, & clutch fluid recommendations
- Manual transmission/transaxle capacities, lube recommendations, grades, & viscosities
- Number of lubrication fittings & plugs
- Power steering, brake, & clutch fluid recommendations
- Engine oil capacities, API grade recommendations, SAE viscosity recommendations, drain plug torque
- Severe service maintenance & interval recommendations
- Tire sizes, wheel nut/bolt torque, pressures & rim sizes
- Transfer case capacities, lube recommendations, grades, & viscosities
TUNE-UP & DRIVEABILITY SPECIFICATIONS: Most tune-up specifications for most 1993 Land Rover Defender 110 cars and light trucks sold in the U.S. and Canada from 1980+
- Airflow sensor electrical specifications
- Tensioning specifications for systems with automatic tensioners
- Barometric pressure sensor specs
- Battery group number and cranking performance
- Crankshaft & camshaft position sensor resistance
- Engine compression pressures
- Coolant temperature sensor specs
- Computer advance.
- Diesel fuel temperature sensor resistance.
- Distributor advance specifications
- Ignition pickup coil resistance
- Exhaust gas recirculation temperature sensor resistance
- Engine fastener torque values
- Firing order diagrams
- Fuel system pressures
- Generator (alternator) specs
- Intake air temperature sensor specs
- Ignition coil specifications
- Fuel injector resistance
- Engine idle speeds
- Knock sensor resistance
- Manifold absolute pressure sensor specs
- Mixture control solenoid resistance
- Voltage regulator specs
- Spark plug applications & gaps
- Starter motor electrical specs.
- Tensioning specifications for systems without automatic tensioners
- Throttle body temperature sensor resistance
- Ignition timing in degrees at rpm
- Transmission oil temperature sensor resistance
- Throttle position sensor specs
- Vacuum sensor valve specs
CLICK HERE TO GET FULL ACCESS TO 1993 Land Rover Defender 110 SPECIFICATIONS DATA!
Shop online for auto body parts, engines, wheels, lights...
More parts |
Get the Complete Technical Service Bulletins! |
Access diagrams and repair information such as wiring diagrams, diagnosis and repair charts, manufacturer service bulletins, and OEM Part numbers of your 1993 Land Rover Defender 110 vehicle. |
Access the Complete guide! |