Auto Parts Search
We have info for following modifications of 1993 Jeep Wrangler
- 1993 Jeep Wrangler 2.5 L4 GAS, CID:150, Fuel Injection, Aspiration:150, Engine VIN:, Desg:P
- 1993 Jeep Wrangler 4.0 L6 GAS, CID:242, Fuel Injection, Aspiration:242, Engine VIN:, Desg:S
- 1993 Jeep Wrangler S 2.5 L4 GAS, CID:150, Fuel Injection, Aspiration:150, Engine VIN:, Desg:P
- 1993 Jeep Wrangler Sahara 4.0 L6 GAS, CID:242, Fuel Injection, Aspiration:242, Engine VIN:, Desg:S
- 1993 Jeep Wrangler Renegade 4.0 L6 GAS, CID:242, Fuel Injection, Aspiration:242, Engine VIN:, Desg:S
BRAKE SERVICE PROCEDURES FOR 1993 Jeep Wrangler AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 1993 Jeep Wrangler cars and light trucks from 1990+.
Disc Brakes -> Cherokee, Comanche, Grand Cherokee & Wrangler -> Brake Pad Service -> Front -> Installation -> Rear -> Removal
Vehicle: 1993 Jeep Wrangler 4.0 L6 GAS
Removal
Front
- Unfasten caliper as outlined under "Caliper Service." It is not necessary to disconnect brake hose from caliper. Support caliper at all times to prevent brake hose damage.
- Remove outboard brake pad from anchor plate while holding anti-rattle clip.
- Remove inboard brake pad and anti-rattle clip or retaining spring.
- Clean caliper interior using clean shop cloths. Do not use compressed air, as damage to dust boot may result.
Rear
- Unfasten caliper as outlined under "Caliper Service." It is not necessary to disconnect brake hose from caliper. Support caliper at all ...
CLICK HERE TO GET FULL ACCESS TO 1993 Jeep Wrangler BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 1993 Jeep Wrangler AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 1993 Jeep Wrangler cars and light trucks from 1990+.
Disc Brakes -> Cherokee, Comanche, Grand Cherokee & Wrangler -> Precautions -> Bleeding Brakes -> Brake Disc Service -> Brake Lines & Linings -> Brake Roughness -> Caliper Inspection -> General Precautions
Vehicle: 1993 Jeep Wrangler S 2.5 L4 GAS
Brake Lines & Linings
Remove one of the front wheels and inspect the brake disc, caliper and linings. The wheel bearings should be inspected at this time and repacked if necessary.
Do not get any oil or grease on the linings. It is recommended that both front wheel sets be replaced whenever a respective pad is worn or damaged. Inspect and, if necessary, replace rear brake linings also.
If the caliper is cracked or fluid leakage through the casting is evident, it must be replaced as a unit.
Brake Roughness
The most common cause of brake chatter on disc brakes is a variation in thickness o...
CLICK HERE TO GET FULL ACCESS TO 1993 Jeep Wrangler BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 1993 Jeep Wrangler AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 1993 Jeep Wrangler cars and light trucks from 1990+.
Drum Brakes -> Jeep -> Precautions
Vehicle: 1993 Jeep Wrangler Sahara 4.0 L6 GAS
When working on or around brake assemblies, care must be taken to prevent breathing asbestos dust, as many manufacturers incorporate asbestos fibers in the production of brake linings. During routine service operations, the amount of asbestos dust from brake lining wear is at a low level due to a chemical breakdown during use, and a few precautions will minimize exposure. Do not sand or grind brake linings unless suitable local exhaust ventilation equipment is used to prevent excessive asbestos exposure.
- We...
CLICK HERE TO GET FULL ACCESS TO 1993 Jeep Wrangler BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 1993 Jeep Wrangler AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 1993 Jeep Wrangler cars and light trucks from 1990+.
Hydraulic Brake Systems -> Brake System Bleed -> Caravan, Town & Country & Voyager -> Chrysler -> Except Caravan, Town & Country & Voyager -> Jeep -> Manual Bleeding -> Master Cylinder -> Pressure Bleeding
Vehicle: 1993 Jeep Wrangler Sahara 4.0 L6 GAS
Chrysler
Except Caravan, Town & Country & Voyager
Manual Bleeding
- On models equipped with Rear Wheel Anti-Lock brakes (RWAL), connect one end of a suitable hose to bleeder valve on RWAL hydraulic valve and submerge other end in a glass container partially filled with clean brake fluid.
- Pump brake pedal several times, then hold pedal down firmly.
- With pedal firmly depressed, open bleeder valve until pedal fades to floor, then close bleeder valve.
- Repeat procedure until a continuous flow of brake fluid is released from bleeder valve. Ensure a fluid level is maintained in master cylin...
CLICK HERE TO GET FULL ACCESS TO 1993 Jeep Wrangler BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 1993 Jeep Wrangler AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 1993 Jeep Wrangler cars and light trucks from 1990+.
Disc Brakes -> Cherokee, Comanche, Grand Cherokee & Wrangler -> Brake Pad Service -> Front -> Installation -> Rear -> Removal
Vehicle: 1993 Jeep Wrangler Renegade 4.0 L6 GAS
Removal
Front
- Unfasten caliper as outlined under "Caliper Service." It is not necessary to disconnect brake hose from caliper. Support caliper at all times to prevent brake hose damage.
- Remove outboard brake pad from anchor plate while holding anti-rattle clip.
- Remove inboard brake pad and anti-rattle clip or retaining spring.
- Clean caliper interior using clean shop cloths. Do not use compressed air, as damage to dust boot may result.
Rear
- Unfasten caliper as outlined under "Caliper Service." It is not necessary to disconnect brake hose from caliper. Support caliper at all ...
CLICK HERE TO GET FULL ACCESS TO 1993 Jeep Wrangler BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 1993 Jeep Wrangler AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 1993 Jeep Wrangler cars and light trucks from 1990+.
Hydraulic Brake Systems -> Component Replacement -> 1992-95 -> 1996 -> Caravan, Town & Country & Voyager -> Cherokee & Comanche -> Chrysler -> Except Cherokee & Comanche -> Full Size Truck, Van/Wagon & Dakota Less RWAL -> Full Size Truck, Van/Wagon & Dakota w/RWAL -> Jeep -> Less Aluminum Master Cylinder -> Master Cylinder -> Ram 50 -> With Aluminum Master Cylinder & Manual Brakes -> With Aluminum Master Cylinder & Power Brakes
Vehicle: 1993 Jeep Wrangler Renegade 4.0 L6 GAS
Master Cylinder
Chrysler
Caravan, Town & Country & Voyager
1992-95
- Disconnect and plug brake tubes from master cylinder. Cap master cylinder ports.
- Remove master cylinder attaching nuts.
- Remove master cylinder from power brake unit.
- Reverse procedure to install. Master cylinder should be bench bled before installation, using bleeding tubes tool No. C-4546, or equivalent.
1996
- With engine not running, pump brake pedal four or five times to deplete vacuum in power booster.
- Thoroughly clean all surfaces of filler neck, brake fluid reservoir and area where master cylinder assembly attac...
CLICK HERE TO GET FULL ACCESS TO 1993 Jeep Wrangler BRAKE SERVICE PROCEDURES
Shop online for auto body parts, engines, wheels, lights...
More parts |
Get the Complete Technical Service Bulletins! |
Access diagrams and repair information such as wiring diagrams, diagnosis and repair charts, manufacturer service bulletins, and OEM Part numbers of your 1993 Jeep Wrangler vehicle. |
Access the Complete guide! |