MACK DMM SERIES PROBLEMS | SAFETY RECALLS & DEFECTS

MACK DMM SERIES PROBLEMS | SAFETY RECALLS & DEFECTS

Access the National Highway Traffic Safety database of MACK DMM SERIES recalls and defective parts found on MACK DMM SERIES automobiles. The National Highway Traffic Safety administration is authorized to order the MACK DMM SERIES manufacturers to recall and repair vehicles or parts of motor vehicle equipment when its investigation indicates that they contain serious safety defects in their design, structure, body, or performance.

Select Your Vehicle Year (Change Vehicle)

1988

1987

1981

1980

Most Recent Recalls For MACK DMM SERIES

Vehicle	Component	Manufacterer
1987-1988 MACK DMM SERIES STEERING:HYDRAULIC POWER ASSIST:HOSE, PIPING, AND CONNECTIONS Recall
1987-1988 MACK DMM SERIES	STEERING:HYDRAULIC POWER ASSIST:HOSE, PIPING, AND CONNECTIONS Units affected: 3127	MACK TRUCKS, INCORPORATED Report Date: 1989-03-03
Summary: AN INCORRECT HIGH PRESSURE POWER STEERING HOSE MAY HAVE BEEN INSTALLED.
1988 MACK DMM SERIES SUSPENSION:REAR:SPRINGS Recall
1988 MACK DMM SERIES	SUSPENSION:REAR:SPRINGS Units affected: 152	MACK TRUCKS, INCORPORATED Report Date: 1989-03-03
Summary: DOWELS MAY HAVE BEEN OMITTED DURING SPRING CAP INSTALLATION; THIS WOULD PUT SHEAR LOAD ON THE FOUR (4) SPRING CAP BOLTS.
1988 MACK DMM SERIES ENGINE AND ENGINE COOLING:ENGINE Recall
1988 MACK DMM SERIES	ENGINE AND ENGINE COOLING:ENGINE Units affected: 408	MACK TRUCKS, INCORPORATED Report Date: 1988-10-18
Summary: CERTAIN ENGINE SUPPORT CASTINGS WERE PRODUCED WITH FAULTY METALLURGY AND COULD FAIL.
1988 MACK DMM SERIES STEERING:LINKAGES Recall
1988 MACK DMM SERIES	STEERING:LINKAGES Units affected: 6400	MACK TRUCKS, INCORPORATED Report Date: 1988-07-27
Summary: SOME OF THE NUTS/BOLTS USED TO FASTEN THE STEERING PITMAN ARM MAY LOOSEN.
1988 MACK DMM SERIES POWER TRAIN:DRIVELINE:CENTER SUPPORT BEARING Recall
1988 MACK DMM SERIES	POWER TRAIN:DRIVELINE:CENTER SUPPORT BEARING Units affected: 203	MACK TRUCKS, INCORPORATED Report Date: 1988-05-23
Summary: CLAMP PLATES USED BETWEEN THE DRIVE SHAFT AND CARRIER YOKES MAY CRACK AND COULD BREAK DUE TO IMPROPER HEAT TREATMENT.
1980-1981 MACK DMM SERIES SEAT BELTS Recall
1980-1981 MACK DMM SERIES	SEAT BELTS Units affected: 22	MACK TRUCKS, INCORPORATED Report Date: 1981-07-08
Summary: THE INVOLVED TRUCKS DO NOT COMPLY WITH FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 208, "OCCUPANT CRASH PROTECTION", IN THAT THE EXTENDED RIDER"S SEAT WAS NOT EQUIPPED WITH A SEAT BELT AS REQUIRED.