| Most Recent Recalls For INFINITI I35 |
| Vehicle | Component | Manufacterer |
| 2002-2003 INFINITI I35 ENGINE AND ENGINE COOLING Recall |
| 2002-2003 INFINITI I35 | ENGINE AND ENGINE COOLING
Units affected: 630000 | NISSAN NORTH AMERICA, INC.
Report Date: 2003-11-17 |
| Summary: ON CERTAIN PASSENGER VEHICLES, THE CIRCUIT BOARD FOR THE CRANK POSITION SENSOR OR CAM POSITION SENSOR MAY HAVE AN IMPROPER SOLDER JOINT DUE TO SOLDER DEFORMATION CAUSED BY HEAT STRESS ACCELERATED BY THE EXISTENCE OF FLUX RESIDUE DURING THE SOLDERING PROCESS. |  |
|
| 2001-2002 INFINITI I35 SUSPENSION:FRONT:CONTROL ARM:LOWER ARM Recall |
| 2001-2002 INFINITI I35 | SUSPENSION:FRONT:CONTROL ARM:LOWER ARM
Units affected: 90500 | NISSAN NORTH AMERICA, INC.
Report Date: 2002-05-30 |
| Summary: ON CERTAIN PASSENGER VEHICLES, THE PIN AT THE END OF THE FRONT SUSPENSION TRANSVERSE LINK (LOWER CONTROL ARM) COULD BREAK WHERE IT IS MOUNTED TO THE FRAME. | |
|
| 2002 INFINITI I35 VEHICLE SPEED CONTROL Recall |
| 2002 INFINITI I35 | VEHICLE SPEED CONTROL
Units affected: 39000 | NISSAN NORTH AMERICA, INC.
Report Date: 2002-02-12 |
| Summary: ON CERTAIN PASSENGER VEHICLES EQUIPPED WITH AN ELECTRONIC THROTTLE CONTROL SYSTEM, THE STOPPER FOR THE ACCELERATOR PEDAL WILL PREVENT EXCESSIVE MOVEMENT OF THE ACCELERATOR POSITION SENSOR. IF THE DRIVER APPLIES OVERLY EXCESSIVE FORCE TO THE ACCELERATOR PEDAL WHILE AT THE SAME TIME PUSHING IT TO THE RIGHT, THE PEDAL CAN "OVER TRAVEL" DUE TO THE DESIGN OF THE PEDAL STOPPER. | |
|
