| Most Recent Recalls For CHEVROLET MONTE CARLO |
| Vehicle | Component | Manufacterer |
| 2004 CHEVROLET MONTE CARLO SERVICE BRAKES, HYDRAULIC Recall |
| 2004 CHEVROLET MONTE CARLO | SERVICE BRAKES, HYDRAULIC
Units affected: 47991 | GENERAL MOTORS CORP.
Report Date: 2004-06-23 |
| Summary: CERTAIN PASSENGER VEHICLES WERE PRODUCED WITH LOWER THAN SPECIFIED TORQUE ON BOTH FRONT BRAKE CALIPER TO STEERING KNUCKLE ATTACHMENT BOLTS. WITH IMPROPER TORQUE, THE CLAMP LOAD AT THE JOINT MAY NOT BE ADEQUATE TO PREVENT MOVEMENT BETWEEN THE CALIPER BRACKET AND KNUCKLE. |  |
|
| 2000 CHEVROLET MONTE CARLO FUEL SYSTEM, GASOLINE:DELIVERY Recall |
| 2000 CHEVROLET MONTE CARLO | FUEL SYSTEM, GASOLINE:DELIVERY
Units affected: 910873 | GENERAL MOTORS CORP.
Report Date: 2004-02-24 |
| Summary: ON CERTAIN PASSENGER VEHICLES EQUIPPED WITH 3800 V6 (L36) ENGINES AND CERTAIN DELPHI FUEL PRESSURE REGULATORS, THE REGULATORS HAVE A MUCH HIGHER THAN USUAL RATE OF FUEL LEAKS. A LEAK CAN ALLOW FUEL TO ENTER THE INTAKE MANIFOLD THROUGH A VACUUM LINE. IF THE ENGINE DOES NOT START WHEN CRANKED, THE FUEL FROM THE LEAKING REGULATOR AND A MISTIMED SPARK CAN CAUSE A BACKFIRE. | |
|
| 1997-1998 CHEVROLET MONTE CARLO STEERING:RACK AND PINION Recall |
| 1997-1998 CHEVROLET MONTE CARLO | STEERING:RACK AND PINION
Units affected: 750283 | GENERAL MOTORS CORP.
Report Date: 2003-12-11 |
| Summary: CERTAIN PASSENGER VEHICLES HAVE LOWER PINION BEARINGS IN THE POWER RACK AND PINION ASSEMBLY IN WHICH THE RETAINER TABS WERE NOT CRIMPED PROPERLY. THESE RETAINERS COULD FAIL AND PERMIT THE BALL BEARINGS TO ESCAPE. | |
|
| 2003 CHEVROLET MONTE CARLO EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL Recall |
| 2003 CHEVROLET MONTE CARLO | EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL
Units affected: 1707825 | GENERAL MOTORS CORP.
Report Date: 2003-07-15 |
| Summary: CERTAIN MINIVANS, PASSENGER AND SPORT UTILITY VEHICLES FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 225, ¬CHILD RESTRAINT ANCHORAGE SYSTEM.¬ THE OWNER¬S MANUAL DOES NOT EXPLAIN THE MEANING OF THE LOCATION SYMBOLS FOR THE CHILD RESTRAINT LOWER UNIVERSAL ANCHORAGE SYSTEM. | |
|
| 2003 CHEVROLET MONTE CARLO AIR BAGS:FRONTAL:DRIVER SIDE INFLATOR MODULE Recall |
| 2003 CHEVROLET MONTE CARLO | AIR BAGS:FRONTAL:DRIVER SIDE INFLATOR MODULE
Units affected: 130 | GENERAL MOTORS CORP.
Report Date: 2003-02-14 |
| Summary: ON CERTAIN MINI VANS, PASSENGER AND SPORT UTILITY VEHICLES, SOME OF THESE VEHICLES HAVE A DRIVER'S SIDE AIR BAG THAT MAY NOT DEPLOY AS DESIGNED. IN ADDITION, THE AIR BAG INFLATOR COULD RUPTURE. | |
|
| 1999 CHEVROLET MONTE CARLO AIR BAGS:FRONTAL Recall |
| 1999 CHEVROLET MONTE CARLO | AIR BAGS:FRONTAL
Units affected: 272 | GENERAL MOTORS CORP.
Report Date: 2002-12-09 |
| Summary: ON CERTAIN PASSENGER, SPORT UTILITY VEHICLES AND MINI VANS, SOME OF THESE VEHICLES HAVE A PASSENGER AIR BAG THAT WAS MANUFACTURED WITHOUT A CHECK VALVE PIN. AN AIR BAG WITHOUT THE CHECK VALVE PIN COULD PRODUCE INCREASED PRESSURE AT THE ONSET OF THE AIR BAG DEPLOYMENT AND REDUCED PRESSURE AFTERWARD. | |
|
| 2002-2003 CHEVROLET MONTE CARLO AIR BAGS:FRONTAL Recall |
| 2002-2003 CHEVROLET MONTE CARLO | AIR BAGS:FRONTAL
Units affected: 133221 | GENERAL MOTORS CORP.
Report Date: 2002-08-09 |
| Summary: CERTAIN PASSENGER, MINI VANS, AND SPORT UTILITY VEHICLES HAVE AN AIR BAG INFLATOR ON THE DRIVER'S SIDE THAT COULD FRACTURE AT A WELD DURING A DEPLOYMENT. | |
|
| 2001 CHEVROLET MONTE CARLO AIR BAGS Recall |
| 2001 CHEVROLET MONTE CARLO | AIR BAGS
Units affected: 580 | GENERAL MOTORS CORP.
Report Date: 2000-08-29 |
| Summary: VEHICLE DESCRIPTION: PASSENGER VEHICLES. THE AIR BAG SENSING AND DIAGNOSTIC MODULES (SDM) COULD EXPERIENCE A MEMORY ERROR RESULTING IN THE AIR BAGS NOT DEPLOYING IN A CRASH SITUATION. | |
|
| 2000-2001 CHEVROLET MONTE CARLO SEAT BELTS Recall |
| 2000-2001 CHEVROLET MONTE CARLO | SEAT BELTS
Units affected: 156305 | GENERAL MOTORS CORP.
Report Date: 2000-08-07 |
| Summary: VEHICLE DESCRIPTION: PASSENGER VEHICLES, LIGHT DUTY TRUCKS, SPORT UTILITY VEHICLES, AND MINI VANS EQUIPPED WITH TRW SEAT BELT BUCKLE ASSEMBLIES. THE BUCKLE BASE OF THESE SEAT BELT ASSEMBLIES WERE NOT PROPERLY HEAT TREATED AND THEREFORE DO NOT PASS THE LOAD BEARING REQUIREMENT OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 209, "SEAT BELT ASSEMBLIES." | |
|
| 1995 CHEVROLET MONTE CARLO SEAT BELTS:FRONT:ANCHORAGE Recall |
| 1995 CHEVROLET MONTE CARLO | SEAT BELTS:FRONT:ANCHORAGE
Units affected: 50709 | GENERAL MOTORS CORP.
Report Date: 1997-04-18 |
| Summary: THE CENTER REAR SEAT BELT ANCHOR PLATE EXHIBITS STRESS CRACKS. | |
|
