Rebuilt Engine Information >> International 200 Engine Repair N' Installation Guide
| Popular International 200 Engine Repair Articles |
|
| INTERCHANGEABILITY OF CRANKS, CAMS & TIMING GEARS |
| Caution On Interchangeability Of Crankshafts,
Camshafts & Timing Gears On
International DV-462, DV-550, DV-462, & DV-550B Engines
Note: The above engine models...... |
| CYLINDER HEAD BOLT SPECIFICATIONS |
| Torque Specifications For Detroit Diesel Allison
Series 92 Cylinder Head Bolts
Care must be taken that the correct torque specification is used
when torquing cylinder head bolts on the Series 92 engine...... |
| REV. MAIN BEARING BOLT TORQUE PROCEDURE ON 71 SER. |
| Revised Main Bearing Cap Bolt Tightening Procedure For
Series 71 Detroit Diesel Allison Engines
Detroit Diesel Allison has revised the method of tightening
Series 71 man bearing cap bolts...... |
| PISTON RING END GAP SPECIFICATIONS |
| Piston Ring End Gap
Navistar 6.9L & 7.3L Diesel Engine
Navistar International has been using an increased piston ring gap on the second compression ring...... |
| REVISED TOP COMPRESSION RING |
| Revised Top Compression Ring On
Navistar DT-466 Engines
In order to reduce engine emissions and crankcase blow by,
Navistar International has revised the top compression ring on
1990 DT/DTA-466 engines...... |
| TESTING ENGINE BLOCKS AND CYLINDER HEADS |
| Heated Water Recommended For Test Tank
When pressure testing engine blocks, cylinder heads, oil cooler
cores, etc., it is recommended that the water temperature in the
test tank be brought up to 180^ - 200^ to simulate...... |
| THREAD REPAIR INFORMATION |
| Thread Repair Information On
General Motors Aluminum Engine Components
The AERA Technical Committee offers the following information regarding a thread repair process on...... |
| INSTALLATION OF ALUMINUM GEARS |
| Caution On Press Fitting Of Aluminum Timing Gears
When heating aluminum timing gears prior to press fitting on camshafts, caution should be exercised that the gears are not heated above 200^ Fahrenheit...... |
| REVISED CYLINDER HEAD GASKET ON 3406B ENGINES |
| Revised Cylinder Head Gasket On
Caterpillar 3406B Diesel Engines
Caterpillar Tractor has released an improved cylinder head gasket for all 3406B truck engines...... |
| FLYWHEEL SPECIFICATIONS |
| Flywheel Specifications For Allis Chalmers Tractors
The following chart of flywheel specifications may be referred to when surfacing or machining flywheels on Allis Chalmers agricultural tractors...... |
 |
