Infiniti Engine >> VALVE CROSSHEAD CLEARANCE

Infiniti Engine >> VALVE CROSSHEAD CLEARANCE

Valve Crosshead To Rocker Lever Clearance On
NH, NT & V-1710 Series Cummins Engines

Valve crosshead nose to rocker lever clearance on the subject engines must be checked during engine rebuild and at any time valve crossheads are replaced on engines using crossheads No. 123416 & 3000326. A minimum of .020 (.51 mm) clearance must be present as illustrated in Fig. 1, on the cylinder being checked with valves completely closed and crosshead in the upmost position. After installing rocker lever assemblies, check crosshead to rocker lever clearance as follows:

1. Turn crankshaft slowly in direction of rotation until the valves are closed on the cylinder being checked. With rocker lever held firmly against the stellite pad of the crosshead, a .020 (.51 mm) wire type feeler gauge must pass between the crosshead nose and the lower beam section of the rocker lever.

2. If the feeler gauge does not pass through:

a. Remove the rocker lever and/or crosshead and grind the nose of the crosshead or rocker lever beam in the area circled in Fig. 1 until enough clearance is obtained.

b. If the rocker is ground, grinding should cover the complete area illustrated in Fig. 2 in a continuous arc. Do NOT grind just the contact area.

Caution: A sharp depression in this area will cause a stress riser and eventual failure of the lever. Grind only enough material to achieve the required clearance. If grinding enters the oil passage, the rocker lever must be junked.

c. Grind sharp edges smooth.




The AERA Technical Committee

---

Looking for replacement Infiniti engines? Visit our online Rebuilt Engines Store. Need to fix your Infiniti engine? Access here the comprehensive online repair guide for your Infiniti engine. Click Here to find a used Infiniti engine.