Auto Parts Search
2009 Ford Escape CAR/TRUCK REPAIR PROCEDURES AND DIAGRAMS - WHAT Ford REPAIR SHOPS DON'T WANT YOU TO KNOW
Learn how to repair a car or truck, install or remove parts, wire an engine, reset warning lights, replace fuel filter, fix auto body and more. Get Automotix DIY!Select Section
- Technical Service Bulletins
- Specifications
- Driveline, U-Joint & CV Axles Replacement
- Tire Pressure Monitoring System
- Starter & Alternator Replacement
- Cabin Air Filter Locations & Replacement
- Maintenance Lamp Reset
- Radiator & Hose Replacement
- Serpentine Belt Service
DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES FOR 2009 Ford Escape AUTOMOBILES
CV AXLE SHAFT, Replace -> Front -> Rear
Vehicle: 2009 Ford Escape Hybrid 2.5 L4 ELECTRIC/GAS
Front
- Raise and safely support the vehicle.
- Remove front wheel assembly.
- Remove front brake disc.
- Remove and discard front axle wheel hub nut.
- Remove tie rod end nut, then remove tie rod end.
- Separate the lower ball joint from the front wheel knuckle.
- Separate halfshaft from front wheel knuckle, using suitable tool.
- Remove the halfshaft.
- Reverse procedure to install, noting the following:
- Torque tie rod end nut to 41 ft. lbs.
- Torque lower ball joint pinch bolt to 52 ft. lbs.
- Torque axle hub nut to 222...
CLICK HERE TO GET FULL ACCESS TO 2009 Ford Escape DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES
TIRE PRESSURE MONITORING SYSTEM PROCEDURES FOR 2009 Ford Escape AUTOMOBILES
Relearn Procedures -> TPMS Sensor Activation -> TPMS Sensor Training
Vehicle: 2009 Ford Escape XLT 3.0 V6 GAS
TPMS Sensor Activation
To conserve battery power, the TPMS sensors will go into a sleep mode after approximately 30 minutes of inactivity. The sensors will not transmit tire pressure information while in sleep mode. The sensors must be activated to transmit the latest tire pressure information.
- Place the ignition switch in the On position.
- Position Ford TPMS activation tool, or equivalent, against the LF tire side wall 180° from the valve stem.
- The TPMS activation tool will flash a green light and sound a beep for each successful response from a TPMS sensor.
- Press the TPMS activat...
CLICK HERE TO GET FULL ACCESS TO 2009 Ford Escape TIRE PRESSURE MONITORING SYSTEM PROCEDURES
STARTER & ALTERNATOR REPLACEMENT PROCEDURES FOR 2009 Ford Escape AUTOMOBILES
Starter, Replace
Vehicle: 2009 Ford Escape XLS 2.5 L4 GAS
- With vehicle in NEUTRAL, position it on a hoist.
- Disconnect battery ground cable.
- Remove terminal cover on starter solenoid.
- Remove B-terminal nut and disconnect wire.
- Remove S-terminal nut and disconnect wire.
- Remove three st...
CLICK HERE TO GET FULL ACCESS TO 2009 Ford Escape STARTER & ALTERNATOR REPLACEMENT PROCEDURES
CABIN AIR FILTER LOCATIONS & REPLACEMENT PROCEDURES FOR 2009 Ford Escape AUTOMOBILES
Cabin Air Filter Service -> Ford Motor Co. -> 2008-09 Escape, Escape Hybrid, Mariner & Mariner Hybrid
Vehicle: 2009 Ford Escape XLT 2.5 L4 GAS
Under normal operating conditions the cabin air filter should be replaced every 15,000 miles. In dusty areas change the cabin air filter more often.
- Remove the two wiper pivot arms nuts, then remove the wiper arms, Fig. .
- Remove the lefthand and righthand cowl end cap retainers, then the end caps, Fig. .
- ...
CLICK HERE TO GET FULL ACCESS TO 2009 Ford Escape CABIN AIR FILTER LOCATIONS & REPLACEMENT PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2009 Ford Escape AUTOMOBILES
Ford Motor Co. Trucks -> Charge System Warning Indicator ->
Vehicle: 2009 Ford Escape Limited Hybrid 2.5 L4 ELECTRIC/GAS
The charge system warning indicator lamps are used to warn of no alternator output. When ignition switch contacts are closed, current flows through charge indicator and pa...
CLICK HERE TO GET FULL ACCESS TO 2009 Ford Escape MAINTENANCE LAMP RESET PROCEDURES
RADIATOR & HOSE REPLACEMENT PROCEDURES FOR 2009 Ford Escape AUTOMOBILES
Coolant Hose, Replace -> Lower -> Upper
Vehicle: 2009 Ford Escape XLT 3.0 V6 GAS
Lower
- Drain cooling system into a suitable container.
- Reposition hose clamp at radiator outlet and remove hose.
- Reposition hose clamp at coolant inlet pipe and remove hose.
- Remove hose from vehicle.
- Reverse procedure to install.
Upper
- Drain cooling system into...
CLICK HERE TO GET FULL ACCESS TO 2009 Ford Escape RADIATOR & HOSE REPLACEMENT PROCEDURES
SERPENTINE BELT SERVICE PROCEDURES FOR 2009 Ford Escape AUTOMOBILES
Serpentine Drive Belt, Replace
Vehicle: 2009 Ford Escape XLT 2.5 L4 GAS
- Disconnect battery ground cable from battery.
- Position vehicle on hoist with vehicle in NEUTRAL.
- Remove pint-type retainer, five bolts and then remove righthand splash shield.
- Rotate accessory drive belt tensioner count...
CLICK HERE TO GET FULL ACCESS TO 2009 Ford Escape SERPENTINE BELT SERVICE PROCEDURES
TECHNICAL SERVICE BULLETINS FOR 2009 Ford Escape AUTOMOBILES
OEM TSB listings for most 2009 Ford Escape cars and light trucks sold in the U.S. from 1985+.
Document: Navigation Radio - When On In CD Mode - Time Displays Twice In The FDIM Vehicle: 2009 Ford Escape Hybrid 2.5 L4 ELECTRIC/GAS Symptoms: |
Document: Satellite Radio (Non Navigation) - Inoperative With Blank Message Display and No Codes - Built between 12/3/2008 - 5/9/2009 Vehicle: 2009 Ford Escape Hybrid 2.5 L4 ELECTRIC/GAS Symptoms: |
CLICK HERE TO GET FULL ACCESS TO 2009 Ford Escape TECHNICAL SERVICE BULLETINS!
COMPONENT/PARTS SPECIFICATIONS FOR 2009 Ford Escape AUTOMOBILES
BRAKE SPECIFICATIONS: Brake drum, rotor, caliper, and related specifications for most 2009 Ford Escape cars and light trucks sold in the U.S. and Canada from 1970+.
- Brake caliper mounting bolt torque
- Brake drum runout, machining, & discard specs
- Minimum brake lining thickness.
- Brake rotor runout, parallelism, machining, discard, & finish specs
A/C SYSTEM SPECIFICATIONS: Air conditioning refrigerant capacity and type as well as lubricant capacity for most 2009 Ford Escape cars and light trucks sold in the U.S. and Canada from 1980+.
- Refrigerant capacity & type, compressor oil viscosity, total system oil capacity & compressor clutch gap
COOLING SYSTEM BLEED: Cooling system bleeder valve identification, bleeder type and bleed procedures for most domestic and imported cars and light trucks sold in the U.S. and Canada from 1986+.
PREVENTIVE MAINTENANCE: Preventive maintenance recommendations and required services for most domestic and imported cars and light trucks sold in the U.S. and Canada from 1980+. Includes severe and routine service schedules
QUICK-LUBE and ILLUSTRATIONS: Fluid recommendations, capacities, drain plug torques, tire data, and severe service recommended preventive maintenance schedules. Information covers most 2009 Ford Escape cars and light trucks sold in the U.S. and Canada from 1980+. Engine and chassis service images.
- Automatic transmission/transaxles capacities, lubricant recommendations
- Differential/final drive capacities, lube recommendations, grades, & viscosities
- Final drive fill & drain plug torques
- Number of lubrication fittings & plugs
- Power steering, brake, & clutch fluid recommendations
- Manual transmission/transaxle capacities, lube recommendations, grades, & viscosities
- Number of lubrication fittings & plugs
- Power steering, brake, & clutch fluid recommendations
- Engine oil capacities, API grade recommendations, SAE viscosity recommendations, drain plug torque
- Severe service maintenance & interval recommendations
- Tire sizes, wheel nut/bolt torque, pressures & rim sizes
- Transfer case capacities, lube recommendations, grades, & viscosities
TUNE-UP & DRIVEABILITY SPECIFICATIONS: Most tune-up specifications for most 2009 Ford Escape cars and light trucks sold in the U.S. and Canada from 1980+
- Airflow sensor electrical specifications
- Tensioning specifications for systems with automatic tensioners
- Barometric pressure sensor specs
- Battery group number and cranking performance
- Crankshaft & camshaft position sensor resistance
- Engine compression pressures
- Coolant temperature sensor specs
- Computer advance.
- Diesel fuel temperature sensor resistance.
- Distributor advance specifications
- Ignition pickup coil resistance
- Exhaust gas recirculation temperature sensor resistance
- Engine fastener torque values
- Firing order diagrams
- Fuel system pressures
- Generator (alternator) specs
- Intake air temperature sensor specs
- Ignition coil specifications
- Fuel injector resistance
- Engine idle speeds
- Knock sensor resistance
- Manifold absolute pressure sensor specs
- Mixture control solenoid resistance
- Voltage regulator specs
- Spark plug applications & gaps
- Starter motor electrical specs.
- Tensioning specifications for systems without automatic tensioners
- Throttle body temperature sensor resistance
- Ignition timing in degrees at rpm
- Transmission oil temperature sensor resistance
- Throttle position sensor specs
- Vacuum sensor valve specs
CLICK HERE TO GET FULL ACCESS TO 2009 Ford Escape SPECIFICATIONS DATA!
Shop online for auto body parts, engines, wheels, lights...
More parts |
Get the Complete Technical Service Bulletins! |
Access diagrams and repair information such as wiring diagrams, diagnosis and repair charts, manufacturer service bulletins, and OEM Part numbers of your 2009 Ford Escape vehicle. |
Access the Complete guide! |