Auto Parts Search
2009 Dodge Nitro CAR/TRUCK REPAIR PROCEDURES AND DIAGRAMS - WHAT Dodge REPAIR SHOPS DON'T WANT YOU TO KNOW
Learn how to repair a car or truck, install or remove parts, wire an engine, reset warning lights, replace fuel filter, fix auto body and more. Get Automotix DIY!Select Section
- Technical Service Bulletins
- Specifications
- Driveline, U-Joint & CV Axles Replacement
- Tire Pressure Monitoring System
- Starter & Alternator Replacement
- Maintenance Lamp Reset
- Radiator & Hose Replacement
- Serpentine Belt Service
DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES FOR 2009 Dodge Nitro AUTOMOBILES
CV AXLE SHAFT, Replace
Vehicle: 2009 Dodge Nitro SXT 3.7 V6 GAS
- With vehicle in neutral, position vehicle on hoist.
- Remove brake caliper and rotor.
- Remove nut from half shaft.
- Remove sensor from hub bearing.
- Remove stabilizer link from stabilizer bar.
- Remove tie rod end nut and remove tie rod from steering knuckle.
- Remove clevis bracket lower nut and bolt.
- Remove upper ball joint nut and separate upper control arm from steering knuckle.
- Pull out on steering knuckle and push half shaft out of hub bearing and knuckle.
- With a pry bar remove half shaft from axle.
- Reverse procedure to install, noting the following:
- Apply light coat of grease to m...
CLICK HERE TO GET FULL ACCESS TO 2009 Dodge Nitro DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES
TIRE PRESSURE MONITORING SYSTEM PROCEDURES FOR 2009 Dodge Nitro AUTOMOBILES
Component Locations
Vehicle: 2009 Dodge Nitro SLT 3.7 V6 GAS
Refer to F...
CLICK HERE TO GET FULL ACCESS TO 2009 Dodge Nitro TIRE PRESSURE MONITORING SYSTEM PROCEDURES
STARTER & ALTERNATOR REPLACEMENT PROCEDURES FOR 2009 Dodge Nitro AUTOMOBILES
Starter, Replace
Vehicle: 2009 Dodge Nitro SLT 3.7 V6 GAS
- Disconnect battery ground cable.
- Raise and support vehicle.
- On 4WD models, remove front propeller shaft.
- On all models, remove two heat shield bolts and remove starter heat shield.
- Remove solenoid nut from mounting stud.
- After nut has been removed, pull battery cable from mounting stud while removing electrical connector from solenoid terminal.
- Remov...
CLICK HERE TO GET FULL ACCESS TO 2009 Dodge Nitro STARTER & ALTERNATOR REPLACEMENT PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2009 Dodge Nitro AUTOMOBILES
Chrysler LLC Trucks -> Service 4WD System Warning Lamp ->
Vehicle: 2009 Dodge Nitro SXT 3.7 V6 GAS
This lamp should light for a approximately 2 seconds when the ignition is turned On as a bulb check. If the warning lamp...
CLICK HERE TO GET FULL ACCESS TO 2009 Dodge Nitro MAINTENANCE LAMP RESET PROCEDURES
RADIATOR & HOSE REPLACEMENT PROCEDURES FOR 2009 Dodge Nitro AUTOMOBILES
Heater Hose, Replace -> Inlet -> Outlet
Vehicle: 2009 Dodge Nitro R/T 4.0 V6 GAS
Inlet
- Drain cooling system into a suitable container.
- Reposition hose clamp at heater core and remove hose.
- Reposition hose clamp at heater inlet pipe and remove hose.
- Remove hose from vehicle.
- Reverse procedure t...
CLICK HERE TO GET FULL ACCESS TO 2009 Dodge Nitro RADIATOR & HOSE REPLACEMENT PROCEDURES
SERPENTINE BELT SERVICE PROCEDURES FOR 2009 Dodge Nitro AUTOMOBILES
Serpentine Drive Belt, Replace
Vehicle: 2009 Dodge Nitro SLT 3.7 V6 GAS
- Disconnect battery ground cable.
- Remove combination washer reservoir/coolant recovery container and move aside.
- Rotate belt tensioner until it contacts stop.
- Remove drive belt.
- Carefully return tens...
CLICK HERE TO GET FULL ACCESS TO 2009 Dodge Nitro SERPENTINE BELT SERVICE PROCEDURES
TECHNICAL SERVICE BULLETINS FOR 2009 Dodge Nitro AUTOMOBILES
OEM TSB listings for most 2009 Dodge Nitro cars and light trucks sold in the U.S. from 1985+.
Document: Hard To Fill Or Fuel Nozzle Shuts Off Repeatedly Vehicle: 2009 Dodge Nitro SXT 3.7 V6 GAS Auto Systems: |
Document: RECALL - Emissions Recall J19 California Emissions Warranty Addendum Vehicle: 2009 Dodge Nitro SXT 3.7 V6 GAS Auto Systems: |
CLICK HERE TO GET FULL ACCESS TO 2009 Dodge Nitro TECHNICAL SERVICE BULLETINS!
COMPONENT/PARTS SPECIFICATIONS FOR 2009 Dodge Nitro AUTOMOBILES
BRAKE SPECIFICATIONS: Brake drum, rotor, caliper, and related specifications for most 2009 Dodge Nitro cars and light trucks sold in the U.S. and Canada from 1970+.
- Brake caliper mounting bolt torque
- Brake drum runout, machining, & discard specs
- Minimum brake lining thickness.
- Brake rotor runout, parallelism, machining, discard, & finish specs
A/C SYSTEM SPECIFICATIONS: Air conditioning refrigerant capacity and type as well as lubricant capacity for most 2009 Dodge Nitro cars and light trucks sold in the U.S. and Canada from 1980+.
- Refrigerant capacity & type, compressor oil viscosity, total system oil capacity & compressor clutch gap
COOLING SYSTEM BLEED: Cooling system bleeder valve identification, bleeder type and bleed procedures for most domestic and imported cars and light trucks sold in the U.S. and Canada from 1986+.
PREVENTIVE MAINTENANCE: Preventive maintenance recommendations and required services for most domestic and imported cars and light trucks sold in the U.S. and Canada from 1980+. Includes severe and routine service schedules
QUICK-LUBE and ILLUSTRATIONS: Fluid recommendations, capacities, drain plug torques, tire data, and severe service recommended preventive maintenance schedules. Information covers most 2009 Dodge Nitro cars and light trucks sold in the U.S. and Canada from 1980+. Engine and chassis service images.
- Automatic transmission/transaxles capacities, lubricant recommendations
- Differential/final drive capacities, lube recommendations, grades, & viscosities
- Final drive fill & drain plug torques
- Number of lubrication fittings & plugs
- Power steering, brake, & clutch fluid recommendations
- Manual transmission/transaxle capacities, lube recommendations, grades, & viscosities
- Number of lubrication fittings & plugs
- Power steering, brake, & clutch fluid recommendations
- Engine oil capacities, API grade recommendations, SAE viscosity recommendations, drain plug torque
- Severe service maintenance & interval recommendations
- Tire sizes, wheel nut/bolt torque, pressures & rim sizes
- Transfer case capacities, lube recommendations, grades, & viscosities
TUNE-UP & DRIVEABILITY SPECIFICATIONS: Most tune-up specifications for most 2009 Dodge Nitro cars and light trucks sold in the U.S. and Canada from 1980+
- Airflow sensor electrical specifications
- Tensioning specifications for systems with automatic tensioners
- Barometric pressure sensor specs
- Battery group number and cranking performance
- Crankshaft & camshaft position sensor resistance
- Engine compression pressures
- Coolant temperature sensor specs
- Computer advance.
- Diesel fuel temperature sensor resistance.
- Distributor advance specifications
- Ignition pickup coil resistance
- Exhaust gas recirculation temperature sensor resistance
- Engine fastener torque values
- Firing order diagrams
- Fuel system pressures
- Generator (alternator) specs
- Intake air temperature sensor specs
- Ignition coil specifications
- Fuel injector resistance
- Engine idle speeds
- Knock sensor resistance
- Manifold absolute pressure sensor specs
- Mixture control solenoid resistance
- Voltage regulator specs
- Spark plug applications & gaps
- Starter motor electrical specs.
- Tensioning specifications for systems without automatic tensioners
- Throttle body temperature sensor resistance
- Ignition timing in degrees at rpm
- Transmission oil temperature sensor resistance
- Throttle position sensor specs
- Vacuum sensor valve specs
CLICK HERE TO GET FULL ACCESS TO 2009 Dodge Nitro SPECIFICATIONS DATA!
Shop online for auto body parts, engines, wheels, lights...
More parts |
Get the Complete Technical Service Bulletins! |
Access diagrams and repair information such as wiring diagrams, diagnosis and repair charts, manufacturer service bulletins, and OEM Part numbers of your 2009 Dodge Nitro vehicle. |
Access the Complete guide! |