Auto Parts Search
2008 Nissan Rogue CAR/TRUCK REPAIR PROCEDURES AND DIAGRAMS - WHAT Nissan REPAIR SHOPS DON'T WANT YOU TO KNOW
Learn how to repair a car or truck, install or remove parts, wire an engine, reset warning lights, replace fuel filter, fix auto body and more. Get Automotix DIY!Select Section
- Component Locations
- Wiring Diagrams
- Technical Service Bulletins
- Specifications
- Driveline, U-Joint & CV Axles Replacement
- Tire Pressure Monitoring System
- Starter & Alternator Replacement
- Cabin Air Filter Locations & Replacement
- Maintenance Lamp Reset
- Radiator & Hose Replacement
- Serpentine Belt Service
DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES FOR 2008 Nissan Rogue AUTOMOBILES
CV AXLE SHAFT, Replace
Vehicle: 2008 Nissan Rogue SL 2.5 L4 GAS
Circular clips should be properly meshed with differential side gear (transaxle side). Inspect that clips are properly seated after installation and that driveshaft will not come out. Always use a new circular clip for installation. To prevent damage to CV boots use suitable cloth over boots to prevent damage to boots during removal and installation.
- Raise and support vehicle and support it with safety stands in proper locations.
- Remove wheel nuts and front tire. Before removing front axle assembly disconnect ABS wheel sensor from assembly. Move sensor away from front axle ...
CLICK HERE TO GET FULL ACCESS TO 2008 Nissan Rogue DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES
TIRE PRESSURE MONITORING SYSTEM PROCEDURES FOR 2008 Nissan Rogue AUTOMOBILES
Description
Vehicle: 2008 Nissan Rogue S 2.5 L4 GAS
The TPMS (Tire Pressure Monitor System) is controlled by the Body Control Module (BCM). The BCM receives its tire pressure signal from the remote keyless entry receiver. The remote keyless entry receiver receives i...
CLICK HERE TO GET FULL ACCESS TO 2008 Nissan Rogue TIRE PRESSURE MONITORING SYSTEM PROCEDURES
STARTER & ALTERNATOR REPLACEMENT PROCEDURES FOR 2008 Nissan Rogue AUTOMOBILES
Starter, Replace
Vehicle: 2008 Nissan Rogue S 2.5 L4 GAS
- Disconnect battery ground cable.
- Remove nut from starter cable B+ terminal and disconnect wire connector from solenoid S-terminal.
- Remove bolts securing starter an...
CLICK HERE TO GET FULL ACCESS TO 2008 Nissan Rogue STARTER & ALTERNATOR REPLACEMENT PROCEDURES
CABIN AIR FILTER LOCATIONS & REPLACEMENT PROCEDURES FOR 2008 Nissan Rogue AUTOMOBILES
Cabin Air Filter Service -> Nissan -> 2008-09 Rouge
Vehicle: 2008 Nissan Rogue SL 2.5 L4 GAS
Under normal operating conditions the cabin air filter should be replaced every 12 months or 12,000 miles. In dusty areas change the cabin air filter more often.
- Remove instrument driver's side lower cover mounting screw, Fig. .
- Pull back instrument driver's side lower cover.
- Detach the DLC (Data Link Connector) from the driver's side lower cover.
- Detach the hood release cable from the driver's side lower cover.
- Detach the harness clip and remove the driver's side lower cover.
- Disconnect accelerator pedal position sensor electrical connector, Fig. .
- Remove the accelerator pedal retaining...
CLICK HERE TO GET FULL ACCESS TO 2008 Nissan Rogue CABIN AIR FILTER LOCATIONS & REPLACEMENT PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2008 Nissan Rogue AUTOMOBILES
Nissan -> Air Bag Warning Lamp ->
Vehicle: 2008 Nissan Rogue SL 2.5 L4 GAS
When the ignition key is placed in the on or Start positions, the air bag warning lamp will illuminate for approximately 7 seconds, then turn off. This lamp cycle indica...
CLICK HERE TO GET FULL ACCESS TO 2008 Nissan Rogue MAINTENANCE LAMP RESET PROCEDURES
RADIATOR & HOSE REPLACEMENT PROCEDURES FOR 2008 Nissan Rogue AUTOMOBILES
Radiator, Replace
Vehicle: 2008 Nissan Rogue S 2.5 L4 GAS
- Remove engine under cover.
- Drain engine coolant from radiator into a suitable container.
- Remove air duct (inlet).
- Remove radiator hose (upper) and reservoir tank hose.
- Disconnect harness connector from fan motor, and move it aside.
- Remove cooling fan assembly.
- Remova...
CLICK HERE TO GET FULL ACCESS TO 2008 Nissan Rogue RADIATOR & HOSE REPLACEMENT PROCEDURES
SERPENTINE BELT SERVICE PROCEDURES FOR 2008 Nissan Rogue AUTOMOBILES
Serpentine Drive Belt, Replace
Vehicle: 2008 Nissan Rogue S 2.5 L4 GAS
- Remove right front wheel.
- Remove bolts from righthand front fender protector assembly, then remove fender protector.
- Rotate or lift belt tensioner arm clockwise, using a suitable tool to relieve tension from drive belt. Do not rotate belt tensioner ...
CLICK HERE TO GET FULL ACCESS TO 2008 Nissan Rogue SERPENTINE BELT SERVICE PROCEDURES
COMPONENT LOCATION DIAGRAMS FOR 2008 Nissan Rogue AUTOMOBILES
Component location diagrams for most 2008 Nissan Rogue cars and light trucks sold in the U.S. from 1990+.
Body Components Diagram for 2008 Nissan Rogue SL 2.5 L4 GAS Components on diagram: |
Body Components Diagram for 2008 Nissan Rogue S 2.5 L4 GAS Components on diagram: |
CLICK HERE TO GET FULL ACCESS TO 2008 Nissan Rogue PARTS/COMPONENTS LOCATION DIAGRAMS!
WIRING DIAGRAMS FOR 2008 Nissan Rogue AUTOMOBILES
OEM drawn wiring diagrams for most 2008 Nissan Rogue cars and light trucks sold in the U.S.
2008 Nissan Rogue S 2.5 L4 GAS Wiring Diagram Components on diagram: |
2008 Nissan Rogue SL 2.5 L4 GAS Wiring Diagram Components on diagram: |
CLICK HERE TO GET FULL ACCESS TO 2008 Nissan Rogue WIRING DIAGRAMS!
TECHNICAL SERVICE BULLETINS FOR 2008 Nissan Rogue AUTOMOBILES
OEM TSB listings for most 2008 Nissan Rogue cars and light trucks sold in the U.S. from 1985+.
Document: A/C SYSTEM O-RING SEAL LEAKS Vehicle: 2008 Nissan Rogue SL 2.5 L4 GAS Auto Systems: |
Document: POWER WINDOW AUTO UP INITIALIZATION Vehicle: 2008 Nissan Rogue SL 2.5 L4 GAS Auto Systems: |
CLICK HERE TO GET FULL ACCESS TO 2008 Nissan Rogue TECHNICAL SERVICE BULLETINS!
COMPONENT/PARTS SPECIFICATIONS FOR 2008 Nissan Rogue AUTOMOBILES
BRAKE SPECIFICATIONS: Brake drum, rotor, caliper, and related specifications for most 2008 Nissan Rogue cars and light trucks sold in the U.S. and Canada from 1970+.
- Brake caliper mounting bolt torque
- Brake drum runout, machining, & discard specs
- Minimum brake lining thickness.
- Brake rotor runout, parallelism, machining, discard, & finish specs
A/C SYSTEM SPECIFICATIONS: Air conditioning refrigerant capacity and type as well as lubricant capacity for most 2008 Nissan Rogue cars and light trucks sold in the U.S. and Canada from 1980+.
- Refrigerant capacity & type, compressor oil viscosity, total system oil capacity & compressor clutch gap
COOLING SYSTEM BLEED: Cooling system bleeder valve identification, bleeder type and bleed procedures for most domestic and imported cars and light trucks sold in the U.S. and Canada from 1986+.
PREVENTIVE MAINTENANCE: Preventive maintenance recommendations and required services for most domestic and imported cars and light trucks sold in the U.S. and Canada from 1980+. Includes severe and routine service schedules
QUICK-LUBE and ILLUSTRATIONS: Fluid recommendations, capacities, drain plug torques, tire data, and severe service recommended preventive maintenance schedules. Information covers most 2008 Nissan Rogue cars and light trucks sold in the U.S. and Canada from 1980+. Engine and chassis service images.
- Automatic transmission/transaxles capacities, lubricant recommendations
- Differential/final drive capacities, lube recommendations, grades, & viscosities
- Final drive fill & drain plug torques
- Number of lubrication fittings & plugs
- Power steering, brake, & clutch fluid recommendations
- Manual transmission/transaxle capacities, lube recommendations, grades, & viscosities
- Number of lubrication fittings & plugs
- Power steering, brake, & clutch fluid recommendations
- Engine oil capacities, API grade recommendations, SAE viscosity recommendations, drain plug torque
- Severe service maintenance & interval recommendations
- Tire sizes, wheel nut/bolt torque, pressures & rim sizes
- Transfer case capacities, lube recommendations, grades, & viscosities
TUNE-UP & DRIVEABILITY SPECIFICATIONS: Most tune-up specifications for most 2008 Nissan Rogue cars and light trucks sold in the U.S. and Canada from 1980+
- Airflow sensor electrical specifications
- Tensioning specifications for systems with automatic tensioners
- Barometric pressure sensor specs
- Battery group number and cranking performance
- Crankshaft & camshaft position sensor resistance
- Engine compression pressures
- Coolant temperature sensor specs
- Computer advance.
- Diesel fuel temperature sensor resistance.
- Distributor advance specifications
- Ignition pickup coil resistance
- Exhaust gas recirculation temperature sensor resistance
- Engine fastener torque values
- Firing order diagrams
- Fuel system pressures
- Generator (alternator) specs
- Intake air temperature sensor specs
- Ignition coil specifications
- Fuel injector resistance
- Engine idle speeds
- Knock sensor resistance
- Manifold absolute pressure sensor specs
- Mixture control solenoid resistance
- Voltage regulator specs
- Spark plug applications & gaps
- Starter motor electrical specs.
- Tensioning specifications for systems without automatic tensioners
- Throttle body temperature sensor resistance
- Ignition timing in degrees at rpm
- Transmission oil temperature sensor resistance
- Throttle position sensor specs
- Vacuum sensor valve specs
CLICK HERE TO GET FULL ACCESS TO 2008 Nissan Rogue SPECIFICATIONS DATA!
Shop online for auto body parts, engines, wheels, lights...
More parts |
Get the Complete Technical Service Bulletins! |
Access diagrams and repair information such as wiring diagrams, diagnosis and repair charts, manufacturer service bulletins, and OEM Part numbers of your 2008 Nissan Rogue vehicle. |
Access the Complete guide! |