Auto Parts Search
Automotix DIY provides automotive consumers and do it yourselfers; the most comprehensive repair information about 2008 Ford Escape car and truck
repair procedures including Ford engine diagrams, wiring diagrams, repair work estimating measures, technical service bulletins, auto body work
guidance, starter & alternator replacement procedures, serpentine belt replacement procedures, radiator & hose replacement procedures, tune-up &
drivability specifications, quick lube illustrations, preventive maintenance guide, engine light reset instructions, parts removal and install
procedures, fuel filter replacement directions, component location diagrams, air filter locations & replacement instructions, a/c
system specifications, and general auto service procedures. You don't have to be a car mechanic or technician to know how to fix
your 2008 Ford Escape automobile. Try the Automotix DIY solution today!
We have info for following modifications of 2008 Ford Escape
- 2008 Ford Escape Hybrid 2.3 L4 ELECTRIC/GAS, CID:140, Fuel Injection, Aspiration:140, Engine VIN:, Desg:H
- 2008 Ford Escape XLT 2.3 L4 GAS, CID:140, Fuel Injection, Aspiration:140, Engine VIN:, Desg:Z
- 2008 Ford Escape XLT 3.0 V6 GAS, CID:183, Fuel Injection, Aspiration:183, Engine VIN:, Desg:1
- 2008 Ford Escape XLS 2.3 L4 GAS, CID:140, Fuel Injection, Aspiration:140, Engine VIN:, Desg:Z
- 2008 Ford Escape Limited 3.0 V6 GAS, CID:183, Fuel Injection, Aspiration:183, Engine VIN:, Desg:1
STARTER & ALTERNATOR REPLACEMENT PROCEDURES FOR 2008 Ford Escape AUTOMOBILES
Includes starter and alternator replacement procedures for domestic and imported 2008 Ford Escape cars and light trucks from 1990+.
Alternator, Replace
Vehicle: 2008 Ford Escape XLT 2.3 L4 GAS
- Position vehicle on lift.
- Disconnect battery ground cable.
- Raise and support vehicle.
- Remove bolts from righthand lower splash shield.
- Rotate accessory drive belt tensioner clockwise and position accessory drive belt aside.
- Press locking tab to release alternator lower air duct from alternator and remove lower air duct.
- Remove battery harness locators from alternator shield.
- Remove heated oxygen sensor wiring harness from lower part of alternator shield.
- Disconnect alternator electrical connectors.
- Position alternator B+ protective cover aside, remove B+ terminal nut and position B+ ...
CLICK HERE TO GET FULL ACCESS TO 2008 Ford Escape STARTER & ALTERNATOR REPLACEMENT PROCEDURES
STARTER & ALTERNATOR REPLACEMENT PROCEDURES FOR 2008 Ford Escape AUTOMOBILES
Includes starter and alternator replacement procedures for domestic and imported 2008 Ford Escape cars and light trucks from 1990+.
Alternator, Replace
Vehicle: 2008 Ford Escape XLT 3.0 V6 GAS
- Disconnect battery ground cable.
- Loosen band clamp and remove air filter element, tray and inlet snorkel.
- Remove bolts, disconnect wiring harness, remove upper radiator hose then remove cooling fan assembly.
- Rotate accessory drive belt tensioner counterclockwise and position accessory drive belt aside.
- Disconnect alternator electrical connectors.
- Position alternator B+ protective cover aside, remove B+ termi...
CLICK HERE TO GET FULL ACCESS TO 2008 Ford Escape STARTER & ALTERNATOR REPLACEMENT PROCEDURES
STARTER & ALTERNATOR REPLACEMENT PROCEDURES FOR 2008 Ford Escape AUTOMOBILES
Includes starter and alternator replacement procedures for domestic and imported 2008 Ford Escape cars and light trucks from 1990+.
Starter, Replace
Vehicle: 2008 Ford Escape Limited 3.0 V6 GAS
Always disconnect battery ground cable at the battery before disconnecting starter motor battery terminal lead. If a tool is shorted at the starter motor battery terminal, the tool can quickly heat enough to cause a skin burn. Failure to follow this instruction may result in serious personal injury.
- Disconnect battery ground cable.
- Loosen band clamp and remove air filter element, tray and inlet snorkel.
- Disconnect transmission shift cable and adjustment lock from transmission manual control lever.
- Disconnect transmission shift cable rotating slide snap and position aside transmissi...
CLICK HERE TO GET FULL ACCESS TO 2008 Ford Escape STARTER & ALTERNATOR REPLACEMENT PROCEDURES
STARTER & ALTERNATOR REPLACEMENT PROCEDURES FOR 2008 Ford Escape AUTOMOBILES
Includes starter and alternator replacement procedures for domestic and imported 2008 Ford Escape cars and light trucks from 1990+.
Starter, Replace
Vehicle: 2008 Ford Escape XLT 2.3 L4 GAS
Always disconnect battery ground cable at the battery before disconnecting starter motor battery terminal lead. If a tool is shorted at the starter motor battery terminal, the tool can quickly heat enough to cause a skin burn. Failure to follow this instruction may result in serious personal injury.
- Position vehicle on lift.
- Disconnect battery ground cable.
- Raise and support vehicle.
- Remove pin retainer and bolts from lefthand lower splash shield.
- Remove starter motor solenoid wire nut.
- Remove starter motor solenoid terminal cover.A protective cap or boot is provided over the battery...
CLICK HERE TO GET FULL ACCESS TO 2008 Ford Escape STARTER & ALTERNATOR REPLACEMENT PROCEDURES
STARTER & ALTERNATOR REPLACEMENT PROCEDURES FOR 2008 Ford Escape AUTOMOBILES
Includes starter and alternator replacement procedures for domestic and imported 2008 Ford Escape cars and light trucks from 1990+.
Alternator, Replace
Vehicle: 2008 Ford Escape Hybrid 2.3 L4 ELECTRIC/GAS
- Position vehicle on lift.
- Disconnect battery ground cable.
- Raise and support vehicle.
- Remove bolts from righthand lower splash shield.
- Rotate accessory drive belt tensioner clockwise and position accessory drive belt aside.
- Press locking tab to release alternator lower air duct from alternator and remove lower air duct.
- Remove battery harness locators from alternator shield.
- Remove heated oxygen sensor wiring harness from lower part of alternator shield.
- Disconnect alternator electrical connectors.
- Position alternator B+ protective cover aside, remove B+ terminal nut and position B+ ...
CLICK HERE TO GET FULL ACCESS TO 2008 Ford Escape STARTER & ALTERNATOR REPLACEMENT PROCEDURES
STARTER & ALTERNATOR REPLACEMENT PROCEDURES FOR 2008 Ford Escape AUTOMOBILES
Includes starter and alternator replacement procedures for domestic and imported 2008 Ford Escape cars and light trucks from 1990+.
Starter, Replace
Vehicle: 2008 Ford Escape XLS 2.3 L4 GAS
Always disconnect battery ground cable at the battery before disconnecting starter motor battery terminal lead. If a tool is shorted at the starter motor battery terminal, the tool can quickly heat enough to cause a skin burn. Failure to follow this instruction may result in serious personal injury.
- Position vehicle on lift.
- Disconnect battery ground cable.
- Raise and support vehicle.
- Remove pin retainer and bolts from lefthand lower splash shield.
- Remove starter motor solenoid wire nut.
- Remove starter motor solenoid terminal cover.A protective cap or boot is provided over the battery...
CLICK HERE TO GET FULL ACCESS TO 2008 Ford Escape STARTER & ALTERNATOR REPLACEMENT PROCEDURES
Shop online for auto body parts, engines, wheels, lights...
| More parts |
| Get the Complete Technical Service Bulletins! |
 Access diagrams and repair information such as wiring diagrams,
diagnosis and repair charts, manufacturer
service bulletins, and OEM Part
numbers of your 2008 Ford Escape vehicle.
|
| Access the Complete guide! |
