Auto Parts Search
Automotix DIY provides automotive consumers and do it yourselfers; the most comprehensive repair information about 2008 Acura RDX car and truck
repair procedures including Acura engine diagrams, wiring diagrams, repair work estimating measures, technical service bulletins, auto body work
guidance, starter & alternator replacement procedures, serpentine belt replacement procedures, radiator & hose replacement procedures, tune-up &
drivability specifications, quick lube illustrations, preventive maintenance guide, engine light reset instructions, parts removal and install
procedures, fuel filter replacement directions, component location diagrams, air filter locations & replacement instructions, a/c
system specifications, and general auto service procedures. You don't have to be a car mechanic or technician to know how to fix
your 2008 Acura RDX automobile. Try the Automotix DIY solution today!
MAINTENANCE LAMP RESET PROCEDURES FOR 2008 Acura RDX AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2008 Acura RDX cars and light trucks sold in the U.S. from 1990+.
Acura -> Automatic Transmission (A/T) Fluid Temperature Indicator -> 2007-09 RDX
Vehicle: 2008 Acura RDX 2.3 L4 GAS
The A/T fluid temperature lamp will turn on when ignition switch is placed in on position and should turn off after a few seconds. If lamp illuminates while driving, the vehicle should be pulled off th...
CLICK HERE TO GET FULL ACCESS TO 2008 Acura RDX MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2008 Acura RDX AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2008 Acura RDX cars and light trucks sold in the U.S. from 1990+.
Acura -> Air Bag Warning Lamp ->
Vehicle: 2008 Acura RDX 2.3 L4 GAS
The air bag warning lamp will light for a few seconds when the ignition switch is placed in the on position as a bulb check. I...
CLICK HERE TO GET FULL ACCESS TO 2008 Acura RDX MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2008 Acura RDX AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2008 Acura RDX cars and light trucks sold in the U.S. from 1990+.
Acura -> Vehicle Stability Assist (VSA) System Warning Lamp -> 2007-09 RDX
Vehicle: 2008 Acura RDX 2.3 L4 GAS
The VSA warning lamp is used to warn of a system fault. The lamp monitors the condition of the anti-lock brake system. It will be lit during engine start-up, but should go off when the self-diagnostic system determines that the system is operating properly. If the lamp remains lit, a fault in the anti-lock brake system is indicated. Even though the system is operating properly, the activation indicator may come on if the VSA switch has been manually turned O...
CLICK HERE TO GET FULL ACCESS TO 2008 Acura RDX MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2008 Acura RDX AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2008 Acura RDX cars and light trucks sold in the U.S. from 1990+.
Acura -> Tire Pressure Monitoring System (TPMS) Warning Indicator -> 2007-09 RDX -> Less Scan Tool -> Relearn -> Reset -> With Scan Tool
Vehicle: 2008 Acura RDX 2.3 L4 GAS
Reset
The low tire pressure warning indicator will illuminate briefly as a bulb check when the ignition switch is placed in the on position. This system uses radio frequency pressure sensors which monitor pressure in all 4 tires. If low tire pressure is detected, the low tire pressure warning lamp will illuminate along with the appropriate tire indicator shown on the multi-information display. Adjusting tire to recommended pressure will turn lamp Off.
If the low tire pressure warning indicator begins to flash for approximately one minute and then stays On, a problem in the Tire Pressu...
CLICK HERE TO GET FULL ACCESS TO 2008 Acura RDX MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2008 Acura RDX AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2008 Acura RDX cars and light trucks sold in the U.S. from 1990+.
Acura -> Side Air Bag off Lamp ->
Vehicle: 2008 Acura RDX 2.3 L4 GAS
This indicator should light for a few seconds when the ignition switch placed in the on position and then go Off. The lamp is used a an alert that the passenger side air bag has been automatically shut off. The passenger side air bag w...
CLICK HERE TO GET FULL ACCESS TO 2008 Acura RDX MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2008 Acura RDX AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2008 Acura RDX cars and light trucks sold in the U.S. from 1990+.
Acura -> Check Engine/Malfunction Indicator (MIL)/PGM-FI Warning Indicator Lamp -> 2007-09 RDX
Vehicle: 2008 Acura RDX 2.3 L4 GAS
The Check Engine/PGM-FI Warning Indicator Lamp should be illuminated for a few seconds after the ignition switch is placed in the on position as a bulb check and then the lamp should go off. If the lamp remains lit, a problem in the Programmed Fuel Injection (PGM-FI) system is indicated and a diagnostic trouble code is stored in the Electronic Control Unit (ECU) memory. After diagnosis and repair, clear the ECU memory of diagnostic trouble codes.
After diagnosis and repair, clear the ECU memory of diagnostic trouble codes. With ignition switch in ...
CLICK HERE TO GET FULL ACCESS TO 2008 Acura RDX MAINTENANCE LAMP RESET PROCEDURES
Shop online for auto body parts, engines, wheels, lights...
| More parts |
| Get the Complete Technical Service Bulletins! |
 Access diagrams and repair information such as wiring diagrams,
diagnosis and repair charts, manufacturer
service bulletins, and OEM Part
numbers of your 2008 Acura RDX vehicle.
|
| Access the Complete guide! |
