Auto Parts Search
2006 Nissan Murano CAR/TRUCK REPAIR PROCEDURES AND DIAGRAMS - WHAT Nissan REPAIR SHOPS DON'T WANT YOU TO KNOW
Learn how to repair a car or truck, install or remove parts, wire an engine, reset warning lights, replace fuel filter, fix auto body and more. Get Automotix DIY!Select Section
- Component Locations
- Wiring Diagrams
- Technical Service Bulletins
- Specifications
- Fuel Filter Replacement
- Driveline, U-Joint & CV Axles Replacement
- Tire Pressure Monitoring System
- Starter & Alternator Replacement
- Cabin Air Filter Locations & Replacement
- Maintenance Lamp Reset
- Radiator & Hose Replacement
- Serpentine Belt Service
FUEL FILTER REPLACEMENT PROCEDURES FOR 2006 Nissan Murano AUTOMOBILES
Nissan/Datsun -> Component Locations -> 2003-06 Murano & 350Z, 2002-06 Altima, 2000-06 Maxima & Sentra
Vehicle: 2006 Nissan Murano SE 3.5 V6 GAS
CLICK HERE TO GET FULL ACCESS TO 2006 Nissan Murano FUEL FILTER REPLACEMENT PROCEDURES
DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES FOR 2006 Nissan Murano AUTOMOBILES
CV AXLE SHAFT, Replace -> Left Side -> Right Side
Vehicle: 2006 Nissan Murano SL 3.5 V6 GAS
Left Side
- Raise and support vehicle and support it with safety stands in proper locations.
- Remove wheel nuts and front tire.
- Remove ABS wheel sensor from steering knuckle.
- Remove cotter pin and wheel bearing locknut. Discard old cotter pin and install new one upon installation
- Remove brake hose lock plate and remove hose from strut assembly.
- Remove strut assembly and steering knuckle bolt and nut.
- Remove driveshaft from steering knuckle. When removing driveshaft do not apply an excessive angle to driveshaft joint. Be careful not to excessively extend slide joint.
- Remove drivesh...
CLICK HERE TO GET FULL ACCESS TO 2006 Nissan Murano DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES
TIRE PRESSURE MONITORING SYSTEM PROCEDURES FOR 2006 Nissan Murano AUTOMOBILES
Relearn Procedures -> Activation -> ID Registration -> Less Activation Tool -> With Activation Tool
Vehicle: 2006 Nissan Murano S 3.5 V6 GAS
Activation
The activation procedure must be performed after replacing or rotating tire and wheels, replacing tire pressure sensor or BCM.
- With Nissan sensor activation tool J-45295, or equivalent, pushed against the LF sensor, press and hold the activation tool button 5 seconds, Fig.
- With the ignition switch On, as the low tire pressure warning lamp blinks, Fig. , the respective sensor then must be initialized.
- Check that the turn signal lamps blink twice when the transmitter wake-up procedure for all wheels is completed.
- After completing activation all sensors, check that the lo...
CLICK HERE TO GET FULL ACCESS TO 2006 Nissan Murano TIRE PRESSURE MONITORING SYSTEM PROCEDURES
STARTER & ALTERNATOR REPLACEMENT PROCEDURES FOR 2006 Nissan Murano AUTOMOBILES
Alternator, Replace
Vehicle: 2006 Nissan Murano SL 3.5 V6 GAS
- Disconnect battery cables.
- Raise vehicle on suitable lift.
- Remove bolts for righthand engine front undercover then remove undercover.
- Drain engine coolant by loosening drain plug on bottom of radiator. Never drain coolant when engine is hot to avoid being scalded . Drain coolant from radiator into a clean suitable container.
- Remove bolt securing air cleaner and duct assembly.
- Remove battery frame nuts and bracket securing battery then remove battery.
- Remove bolts securing battery tray.
- Disconnect hose clamp for upper radiator hose at radiator side.
- Disconnect hose clamp for lower ra...
CLICK HERE TO GET FULL ACCESS TO 2006 Nissan Murano STARTER & ALTERNATOR REPLACEMENT PROCEDURES
CABIN AIR FILTER LOCATIONS & REPLACEMENT PROCEDURES FOR 2006 Nissan Murano AUTOMOBILES
Cabin Air Filter Service -> Nissan -> 2003-07 Murano
Vehicle: 2006 Nissan Murano SL 3.5 V6 GAS
Under normal operating conditions the cabin air filter should be replaced every 12 months or 15,000 miles. In dusty areas change the cabin air filter more often.
- Open the glove compartment.
- Remove the two glove compartment striker retaining screws, Fig. .
- Remove the two glove compartment retaining screws, then disengage the retaining clip and pawl.
- Lift the glove compartment and lower panel from the instrument panel, then...
CLICK HERE TO GET FULL ACCESS TO 2006 Nissan Murano CABIN AIR FILTER LOCATIONS & REPLACEMENT PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2006 Nissan Murano AUTOMOBILES
Nissan -> Traction Control/Slip Indicator Lamp ->
Vehicle: 2006 Nissan Murano S 3.5 V6 GAS
Drive wheel slippage is detected by the four wheel rotating signal. When wheel slip becomes excessive, the Traction Control System (TCS) operates causing the SLIP indicator lamp to illuminate. When the TCS off switch is used to cancel TCS function, the ...
CLICK HERE TO GET FULL ACCESS TO 2006 Nissan Murano MAINTENANCE LAMP RESET PROCEDURES
RADIATOR & HOSE REPLACEMENT PROCEDURES FOR 2006 Nissan Murano AUTOMOBILES
Coolant Hose, Replace -> Lower -> Upper
Vehicle: 2006 Nissan Murano SL 3.5 V6 GAS
Lower
- Disconnect battery ground cable.
- Drain cooling system into a suitable container by loosening drain plug of radiator.
- Reposition hose clamp at radiator outlet.
- Remove hose from radiator.
- Reposition hose clamp at thermostat housing.
- Remove hose from thermostat housing.
- Remove hose from vehicle.
- Reverse pr...
CLICK HERE TO GET FULL ACCESS TO 2006 Nissan Murano RADIATOR & HOSE REPLACEMENT PROCEDURES
SERPENTINE BELT SERVICE PROCEDURES FOR 2006 Nissan Murano AUTOMOBILES
Serpentine Drive Belt, Replace
Vehicle: 2006 Nissan Murano SE 3.5 V6 GAS
- Rotate or lift the belt tensioner arm, using a suitable tool to relieve tension from dr...
CLICK HERE TO GET FULL ACCESS TO 2006 Nissan Murano SERPENTINE BELT SERVICE PROCEDURES
COMPONENT LOCATION DIAGRAMS FOR 2006 Nissan Murano AUTOMOBILES
Component location diagrams for most 2006 Nissan Murano cars and light trucks sold in the U.S. from 1990+.
Shift Lock System Electrical Parts Locations Diagram for 2006 Nissan Murano S 3.5 V6 GAS Components on diagram: |
Passenger Compartment Diagram for 2006 Nissan Murano SL 3.5 V6 GAS Components on diagram: |
CLICK HERE TO GET FULL ACCESS TO 2006 Nissan Murano PARTS/COMPONENTS LOCATION DIAGRAMS!
WIRING DIAGRAMS FOR 2006 Nissan Murano AUTOMOBILES
OEM drawn wiring diagrams for most 2006 Nissan Murano cars and light trucks sold in the U.S.
2006 Nissan Murano S 3.5 V6 GAS Wiring Diagram Components on diagram: |
2006 Nissan Murano S 3.5 V6 GAS Wiring Diagram Components on diagram: |
CLICK HERE TO GET FULL ACCESS TO 2006 Nissan Murano WIRING DIAGRAMS!
TECHNICAL SERVICE BULLETINS FOR 2006 Nissan Murano AUTOMOBILES
OEM TSB listings for most 2006 Nissan Murano cars and light trucks sold in the U.S. from 1985+.
Document: A/C SYSTEM O-RING SEAL LEAKS Vehicle: 2006 Nissan Murano S 3.5 V6 GAS Auto Systems: |
Document: SUNROOF INOPERATIVE Vehicle: 2006 Nissan Murano S 3.5 V6 GAS |
CLICK HERE TO GET FULL ACCESS TO 2006 Nissan Murano TECHNICAL SERVICE BULLETINS!
COMPONENT/PARTS SPECIFICATIONS FOR 2006 Nissan Murano AUTOMOBILES
BRAKE SPECIFICATIONS: Brake drum, rotor, caliper, and related specifications for most 2006 Nissan Murano cars and light trucks sold in the U.S. and Canada from 1970+.
- Brake caliper mounting bolt torque
- Brake drum runout, machining, & discard specs
- Minimum brake lining thickness.
- Brake rotor runout, parallelism, machining, discard, & finish specs
A/C SYSTEM SPECIFICATIONS: Air conditioning refrigerant capacity and type as well as lubricant capacity for most 2006 Nissan Murano cars and light trucks sold in the U.S. and Canada from 1980+.
- Refrigerant capacity & type, compressor oil viscosity, total system oil capacity & compressor clutch gap
COOLING SYSTEM BLEED: Cooling system bleeder valve identification, bleeder type and bleed procedures for most domestic and imported cars and light trucks sold in the U.S. and Canada from 1986+.
PREVENTIVE MAINTENANCE: Preventive maintenance recommendations and required services for most domestic and imported cars and light trucks sold in the U.S. and Canada from 1980+. Includes severe and routine service schedules
QUICK-LUBE and ILLUSTRATIONS: Fluid recommendations, capacities, drain plug torques, tire data, and severe service recommended preventive maintenance schedules. Information covers most 2006 Nissan Murano cars and light trucks sold in the U.S. and Canada from 1980+. Engine and chassis service images.
- Automatic transmission/transaxles capacities, lubricant recommendations
- Differential/final drive capacities, lube recommendations, grades, & viscosities
- Final drive fill & drain plug torques
- Number of lubrication fittings & plugs
- Power steering, brake, & clutch fluid recommendations
- Manual transmission/transaxle capacities, lube recommendations, grades, & viscosities
- Number of lubrication fittings & plugs
- Power steering, brake, & clutch fluid recommendations
- Engine oil capacities, API grade recommendations, SAE viscosity recommendations, drain plug torque
- Severe service maintenance & interval recommendations
- Tire sizes, wheel nut/bolt torque, pressures & rim sizes
- Transfer case capacities, lube recommendations, grades, & viscosities
TUNE-UP & DRIVEABILITY SPECIFICATIONS: Most tune-up specifications for most 2006 Nissan Murano cars and light trucks sold in the U.S. and Canada from 1980+
- Airflow sensor electrical specifications
- Tensioning specifications for systems with automatic tensioners
- Barometric pressure sensor specs
- Battery group number and cranking performance
- Crankshaft & camshaft position sensor resistance
- Engine compression pressures
- Coolant temperature sensor specs
- Computer advance.
- Diesel fuel temperature sensor resistance.
- Distributor advance specifications
- Ignition pickup coil resistance
- Exhaust gas recirculation temperature sensor resistance
- Engine fastener torque values
- Firing order diagrams
- Fuel system pressures
- Generator (alternator) specs
- Intake air temperature sensor specs
- Ignition coil specifications
- Fuel injector resistance
- Engine idle speeds
- Knock sensor resistance
- Manifold absolute pressure sensor specs
- Mixture control solenoid resistance
- Voltage regulator specs
- Spark plug applications & gaps
- Starter motor electrical specs.
- Tensioning specifications for systems without automatic tensioners
- Throttle body temperature sensor resistance
- Ignition timing in degrees at rpm
- Transmission oil temperature sensor resistance
- Throttle position sensor specs
- Vacuum sensor valve specs
CLICK HERE TO GET FULL ACCESS TO 2006 Nissan Murano SPECIFICATIONS DATA!
Shop online for auto body parts, engines, wheels, lights...
More parts |
Get the Complete Technical Service Bulletins! |
Access diagrams and repair information such as wiring diagrams, diagnosis and repair charts, manufacturer service bulletins, and OEM Part numbers of your 2006 Nissan Murano vehicle. |
Access the Complete guide! |