Auto Parts Search


      Over 40 million used auto parts online. Shop online for auto and truck parts and save up to 75%

Learn how to repair a car or truck, install or remove parts, wire an engine, reset warning lights, replace fuel filter, fix auto body and more. Get Automotix DIY!
Help me findSearch
Get Full Access Automotix DIY provides automotive consumers and do it yourselfers; the most comprehensive repair information about 2005 Toyota Sienna car and truck repair procedures including Toyota engine diagrams, wiring diagrams, repair work estimating measures, technical service bulletins, auto body work guidance, starter & alternator replacement procedures, serpentine belt replacement procedures, radiator & hose replacement procedures, tune-up & drivability specifications, quick lube illustrations, preventive maintenance guide, engine light reset instructions, parts removal and install procedures, fuel filter replacement directions, component location diagrams, air filter locations & replacement instructions, a/c system specifications, and general auto service procedures. You don't have to be a car mechanic or technician to know how to fix your 2005 Toyota Sienna automobile. Try the Automotix DIY solution today!
DIY REPAIR SAMPLES > CONTINUE EXPLORING >

We have info for following modifications of 2005 Toyota Sienna

  • 2005 Toyota Sienna CE 3.3 V6 GAS, CC:3300, CID:202, Fuel Injection, Aspiration:202
  • 2005 Toyota Sienna LE 3.3 V6 GAS, CC:3300, CID:202, Fuel Injection, Aspiration:202
  • 2005 Toyota Sienna XLE 3.3 V6 GAS, CC:3300, CID:202, Fuel Injection, Aspiration:202
  • 2005 Toyota Sienna XLE Limited 3.3 V6 GAS, CC:3300, CID:202, Fuel Injection, Aspiration:202

DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES FOR 2005 Toyota Sienna AUTOMOBILES

Includes CV axle, universal joint, and driveline replacement, for domestic and imported 2005 Toyota Sienna cars and light trucks from 1990+.

CV AXLE SHAFT, Replace
Vehicle: 2005 Toyota Sienna XLE 3.3 V6 GAS

  • Raise and support vehicle.
  • Remove wheel and tire assembly.
  • Drain transmission fluid and transfer case oil.
  • Unstake drive shaft hub nut.
  • With an assistant applying brakes, remove drive shaft hub nut.
  • Remove nut, then disconnect stabilizer bar link fro shock absorber.
  • Remove bolt and separate ABS speed sensor wire and hose from shock absorber.
  • Remove bolt, then remove ABS speed sensor from steering knuckle.
  • Remove cotter pin and nut, then separate tie rod end from steering knuckle, using a suitable pry tool.
  • Remove bolt and nuts from lower ball joint, then separate lower control arm...

CLICK HERE TO GET FULL ACCESS TO 2005 Toyota Sienna DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES

DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES FOR 2005 Toyota Sienna AUTOMOBILES

Includes CV axle, universal joint, and driveline replacement, for domestic and imported 2005 Toyota Sienna cars and light trucks from 1990+.

DRIVESHAFT U-JOINT, Replace -> Assemble -> Disassemble
Vehicle: 2005 Toyota Sienna CE 3.3 V6 GAS

Disassemble

This procedure describes a driveline equipped with cardan joint in tube yoke. Driveline equipped with companion/slip yoke repeat steps to remove remaining cardan joint.

  • Place driveshaft on suitable workbench. Do not damage driveshaft when servicing on workbench. Ensure driveline and components are reference marked to prevent driveline imbalance. Do not tighten driveshaft too tightly in a vise because this will cause driveline to become out of balance and result in driveline vibration.
  • Tap outside of bearing cap with a drift to loosen snap ring.
  • Remove snap ri...

CLICK HERE TO GET FULL ACCESS TO 2005 Toyota Sienna DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES

DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES FOR 2005 Toyota Sienna AUTOMOBILES

Includes CV axle, universal joint, and driveline replacement, for domestic and imported 2005 Toyota Sienna cars and light trucks from 1990+.

CV AXLE SHAFT, Replace
Vehicle: 2005 Toyota Sienna LE 3.3 V6 GAS

  • Raise and support vehicle.
  • Remove wheel and tire assembly.
  • Drain transmission fluid and transfer case oil.
  • Unstake drive shaft hub nut.
  • With an assistant applying brakes, remove drive shaft hub nut.
  • Remove nut, then disconnect stabilizer bar link fro shock absorber.
  • Remove bolt and separate ABS speed sensor wire and hose from shock absorber.
  • Remove bolt, then remove ABS speed sensor from steering knuckle.
  • Remove cotter pin and nut, then separate tie rod end from steering knuckle, using a suitable pry tool.
  • Remove bolt and nuts from lower ball joint, then separate lower control arm...

CLICK HERE TO GET FULL ACCESS TO 2005 Toyota Sienna DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES

DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES FOR 2005 Toyota Sienna AUTOMOBILES

Includes CV axle, universal joint, and driveline replacement, for domestic and imported 2005 Toyota Sienna cars and light trucks from 1990+.

DRIVESHAFT U-JOINT, Replace -> Assemble -> Disassemble
Vehicle: 2005 Toyota Sienna XLE 3.3 V6 GAS

Disassemble

This procedure describes a driveline equipped with cardan joint in tube yoke. Driveline equipped with companion/slip yoke repeat steps to remove remaining cardan joint.

  • Place driveshaft on suitable workbench. Do not damage driveshaft when servicing on workbench. Ensure driveline and components are reference marked to prevent driveline imbalance. Do not tighten driveshaft too tightly in a vise because this will cause driveline to become out of balance and result in driveline vibration.
  • Tap outside of bearing cap with a drift to loosen snap ring.
  • Remove snap ri...

CLICK HERE TO GET FULL ACCESS TO 2005 Toyota Sienna DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES

DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES FOR 2005 Toyota Sienna AUTOMOBILES

Includes CV axle, universal joint, and driveline replacement, for domestic and imported 2005 Toyota Sienna cars and light trucks from 1990+.

DRIVESHAFT, Replace
Vehicle: 2005 Toyota Sienna XLE Limited 3.3 V6 GAS

  • Raise and support vehicle.
  • Remove exhaust pipe.
  • Have an assistant depress and hold brake pedal.
  • Loosen the cross groove joint set bolts a 1/2 turn.
  • Place reference marks on both flanges.
  • Remove nuts, bolts and washers at flanges.
  • Remove bolts and adjusting shims from...

CLICK HERE TO GET FULL ACCESS TO 2005 Toyota Sienna DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES

DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES FOR 2005 Toyota Sienna AUTOMOBILES

Includes CV axle, universal joint, and driveline replacement, for domestic and imported 2005 Toyota Sienna cars and light trucks from 1990+.

DRIVESHAFT, Replace
Vehicle: 2005 Toyota Sienna XLE 3.3 V6 GAS

  • Raise and support vehicle.
  • Remove exhaust pipe.
  • Have an assistant depress and hold brake pedal.
  • Loosen the cross groove joint set bolts a 1/2 turn.
  • Place reference marks on both flanges.
  • Remove nuts, bolts and washers at flanges.
  • Remove bolts and adjusting shims from...

CLICK HERE TO GET FULL ACCESS TO 2005 Toyota Sienna DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES

Shop online for auto body parts, engines, wheels, lights...

Click here to view more details about 1998 Toyota Sienna Fender, Front, Driver Side1998 Toyota Sienna Fender, Front, Driver Side.

Source: Auto Body Parts Store

$91.22

Click here to view more details2006 Toyota Sienna Headlight, Driver Side, Bulbs included; Composite, combination, and halogen type; DOT and SAE approved; A high quality, direct fit OE replacement headlight assembly; With 2 years limited TrustBuilt warranty..

Source: Auto Body Parts Store

$170.35

Click here to view more details2006 Toyota Sienna Radiator, Radiatior; 3.3 LTR; V6; 1 Row; Plastic [From 9/05], , .

Source: Wheels / Rims, Mirrors & Lights Store

$126.45

Click here to view more details2002 Toyota Sienna V6, 3 L, 2995 CC Rebuilt Engine, Warranty: 3-Year/100,000 Mile, .

Source: Rebuilt Engines Store

Ad Hoc

Click here to view more details2011 Toyota Sienna Used Ignition Switch W/Key, W/KEY, Very Good.

Source: Used Auto Parts Store

$61.00

Click here to view more details2000 Toyota Sienna Used Exhaust Manifold, Passenger Side Rear, Calif, R. (), Very Good.

Source: Used Auto Parts Store

$152.00
More parts
Help me findSearch
Auto Repair Quick Search
Help me find
Search DIY repair manuals by VIN...
Vehicle Identification Number is a unique serial number used by the automotive industry to identify individual motor vehicles

Find out what info we have for your vehicle

Get the Complete Technical Service Bulletins!
Get the Complete Technical Service Bulletins!Access diagrams and repair information such as wiring diagrams, diagnosis and repair charts, manufacturer service bulletins, and OEM Part numbers of your 2005 Toyota Sienna vehicle.
Access the Complete guide!
Need To Fix Your Car or Truck?
Save Money With Free Car Insurance Quote
FREE car insurance quote
Enter Zip Code:
GOT A WEBSITE?Make money with Automotix

Make money with Automotix Partner Program.

Learn more

Auto Repair Quick Search
Help me find