2005 Pontiac Aztek Brake Service (ONLINE REPAIR MANUALS)

Aztek, Rendezvous & Vue

Removal

• Raise and support vehicle.
• Mark relationship of drum to hub.
• Remove and discard retaining clip.
• Remove brake drum. If brake drum does not come off easily, proceed as follows:
• Loosen parking brake cable.
• Remove backing plate access hole plug.
• Disengage self adjuster by inserting suitable flat-bladed tool through backing plate access hole.
• Loosen adjuster screw by inserting another flat-bladed tool through access hole .
• Install access hole plug.
• Apply small amount of penetrating oil around brake drum center hole.
• Remove brake drum.
• Disengage adjuster spring hook e...

Certain general service procedures apply, regardless of whether the brakes are vacuum or hydraulically assisted. Only top quality, clean brake fluid should be used. More seals and valves are used with power brake systems than with ordinary brakes, so an inferior brake fluid will do much more damage. For the same reason, ensure all dirt is kept out of the system. Additionally, on models with hydraulic assist brakes, care must be taken not to mix the fluids of the booster hydraulic system and brake hydraulic system as the fluids are not compatible.

If the power unit fails, the brak...

When working on or around brake assemblies, care must be taken to prevent breathing asbestos dust, as many manufacturers incorporate asbestos fibers in the production of brake linings. During routine service operations, the amount of asbestos dust from brake lining wear is at a low level because of a chemical breakdown during use and a few precautions will minimize exposure. Do not sand or grind brake linings unless suitable local exhaust ventilation equipment is used to prevent excessiv...

Master Cylinder

Some vehicles use a conventional tandem master cylinder with two hydraulic pistons operating in-line. The primary piston controls the front brake system and the secondary piston controls the rear brake system.

Other models use a master cylinder that operates the same as the conventional master cylinder, but also incorporates a quick take-up feature in the rear chamber to reduce excessive pedal travel which may result from increased fluid displacement required to move the low drag caliper piston out against the rotor.

The quick take-up uses a spring-loaded ball check val...

Brake Lines & Linings

Remove one of the front wheels and inspect the brake disc, caliper and linings.

Do not allow any oil or grease on the linings. It is recommended that linings be replaced in sets when worn or damaged.

If the caliper is cracked or fluid leakage through the casting is evident, it must be replaced as a unit.

Brake Roughness

The most common cause of brake chatter on disc brakes is a variation in thickness of the disc. If roughness or vibration is encountered during highway operation or if pedal pumping is experienced at low speeds, the disc may have excessive thickness v...

When wheel slip is detected during a brake application, the ABS enters anti-lock mode. During anti-lock braking, hydraulic pressure in the individual wheel circuits is controlled to prevent any wheel from slipping. A separate hydraulic line and specific solenoid valves are provided for each wheel. The ABS can decrease, hold, or increase hydraulic pressure to each wheel brake. The ABS cannot, however, increase hydraulic pressure above the amount which is transmitted by the master cylinder during braking.

During anti-lock braking, a series of rapid pulsations is felt in the brake pedal...