Auto Parts Search
We have info for following modifications of 2005 Chrysler Pacifica
- 2005 Chrysler Pacifica 3.8 V6 GAS, CID:230, Fuel Injection, Aspiration:230, Engine VIN:, Desg:L
- 2005 Chrysler Pacifica 3.5 V6 GAS, CC:3497, CID:215, Fuel Injection, Aspiration:215, Engine VIN:, Desg:4
MAINTENANCE LAMP RESET PROCEDURES FOR 2005 Chrysler Pacifica AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2005 Chrysler Pacifica cars and light trucks sold in the U.S. from 1990+.
Chrysler LLC Trucks -> Check Engine Lamp -> Chrysler, Dodge, Jeep & Plymouth Except Ram 50
Vehicle: 2005 Chrysler Pacifica 3.8 V6 GAS
On models less OBD II, the Check Engine lamp should light for approximately 3 seconds after the ignition has been turned On as a bulb inspection. If improper or no signals are received by the Powertrain Control Module (PCM) from various sensors and monitored systems or if the PCM enters its Limp-In mode, the PCM will light the Check Engine lamp. On Chrysler, Dodge and Plymouth models, After diagnosing and servicing the vehicle, the PCM memory will be cleared after approximately 40 to 100 ignition key On-Off cycles or by using a suitable scan tool. ...
CLICK HERE TO GET FULL ACCESS TO 2005 Chrysler Pacifica MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2005 Chrysler Pacifica AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2005 Chrysler Pacifica cars and light trucks sold in the U.S. from 1990+.
Chrysler LLC Trucks -> Check Gauge Warning Lamp ->
Vehicle: 2005 Chrysler Pacifica 3.5 V6 GAS
When the ignition is turned On, the lamp will light for approximately 2 seconds as a bulb inspection. The PCM continually monitors the engine oil pressure, engine coolant temperature and electrical system voltage. The check gauges lamp w...
CLICK HERE TO GET FULL ACCESS TO 2005 Chrysler Pacifica MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2005 Chrysler Pacifica AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2005 Chrysler Pacifica cars and light trucks sold in the U.S. from 1990+.
Chrysler LLC Trucks -> Tire Pressure Monitoring System (TPMS) Warning Indicator -> 2005-08 Pacifica -> Relearn -> Reset
Vehicle: 2005 Chrysler Pacifica 3.5 V6 GAS
Reset
The Low Tire Pressure indicator lamp will flash slowly and sound a single tone when tire pressure is low. If tire pressure drops lower, the indicator lamp will flash rapidly and the tone will be continuous. When the tire is inflated to the proper pressure the lamp and tone will turn Off. The vehicle may need to be driven at a speed above 15 MPH for up to 10 minutes for the TPMS to receive this information. If the lamp remains On, a problem in the low tire warning system is present and the low tire warning system must be d...
CLICK HERE TO GET FULL ACCESS TO 2005 Chrysler Pacifica MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2005 Chrysler Pacifica AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2005 Chrysler Pacifica cars and light trucks sold in the U.S. from 1990+.
Chrysler LLC Trucks -> Emission Maintenance Reminder Indicator -> Chrysler, Dodge & Plymouth
Vehicle: 2005 Chrysler Pacifica 3.8 V6 GAS
This Emission Maintenance Reminder System (Maintenance Required Lamp) is incorporated into the engine controller. The controller stores vehicle mileage into its memory every eight miles, then at 60,000, 82,500 or 120,000 miles it will light the EMR (Maintenance Required) lamp. When the indicated mileage is reached or the EMR lamp is on at all times, the following components must be replaced and the EMR lamp reset:
- At 60,00 miles, proceed as follows:
- Replace EGR valve.
- Clean EGR passage.
- Replace PCV valve.
- At 82,500 miles, replace oxygen sensor.
- At 120,000 miles, proceed as ...
CLICK HERE TO GET FULL ACCESS TO 2005 Chrysler Pacifica MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2005 Chrysler Pacifica AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2005 Chrysler Pacifica cars and light trucks sold in the U.S. from 1990+.
Chrysler LLC Trucks -> Electronic Throttle Control Indicator ->
Vehicle: 2005 Chrysler Pacifica 3.5 V6 GAS
When the ignition is turned On, the lamp will light for approximately 6-12 seconds as a bulb inspection. If the lamp is illuminated with the engine running, the vehicle is usually drivable but the electronic throttle system must be diagnosed and servic...
CLICK HERE TO GET FULL ACCESS TO 2005 Chrysler Pacifica MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2005 Chrysler Pacifica AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2005 Chrysler Pacifica cars and light trucks sold in the U.S. from 1990+.
Chrysler LLC Trucks -> Electronic Vehicle Information Center (EVIC) -> Pacifica
Vehicle: 2005 Chrysler Pacifica 3.5 V6 GAS
Electronic Vehicle Information Center (EVIC) is located in a overhead console and is programmable by driver to suit his/her driving needs:
- Place ignition switch in On position.
- Depress and release menu push button to display first programmable feature.
- Momentarily depress and release step push button to step through following programmable features:
- Language?
- Display U.S. or Metric?
- Use Factory Settings?
- Auto Door Locks.
- Auto Unlock On Exit?
- Remote Unlock Driver's Door First.
- Remote Unlock All Doors.
- Remote Lin...
CLICK HERE TO GET FULL ACCESS TO 2005 Chrysler Pacifica MAINTENANCE LAMP RESET PROCEDURES
Shop online for auto body parts, engines, wheels, lights...
More parts |
Get the Complete Technical Service Bulletins! |
Access diagrams and repair information such as wiring diagrams, diagnosis and repair charts, manufacturer service bulletins, and OEM Part numbers of your 2005 Chrysler Pacifica vehicle. |
Access the Complete guide! |