Auto Parts Search


      Over 40 million used auto parts online. Shop online for auto and truck parts and save up to 75%

Learn how to repair a car or truck, install or remove parts, wire an engine, reset warning lights, replace fuel filter, fix auto body and more. Get Automotix DIY!
Help me findSearch
Get Full Access Automotix DIY provides automotive consumers and do it yourselfers; the most comprehensive repair information about 2005 Chevrolet Equinox car and truck repair procedures including Chevrolet engine diagrams, wiring diagrams, repair work estimating measures, technical service bulletins, auto body work guidance, starter & alternator replacement procedures, serpentine belt replacement procedures, radiator & hose replacement procedures, tune-up & drivability specifications, quick lube illustrations, preventive maintenance guide, engine light reset instructions, parts removal and install procedures, fuel filter replacement directions, component location diagrams, air filter locations & replacement instructions, a/c system specifications, and general auto service procedures. You don't have to be a car mechanic or technician to know how to fix your 2005 Chevrolet Equinox automobile. Try the Automotix DIY solution today!
DIY REPAIR SAMPLES > CONTINUE EXPLORING >

We have info for following modifications of 2005 Chevrolet Equinox

  • 2005 Chevrolet Equinox LS 3.4 V6 GAS, CID:207, Fuel Injection, Aspiration:207, Engine VIN:, Desg:F
  • 2005 Chevrolet Equinox LT 3.4 V6 GAS, CID:207, Fuel Injection, Aspiration:207, Engine VIN:, Desg:F

DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES FOR 2005 Chevrolet Equinox AUTOMOBILES

Includes CV axle, universal joint, and driveline replacement, for domestic and imported 2005 Chevrolet Equinox cars and light trucks from 1990+.

DRIVESHAFT U-JOINT, Replace -> Assemble -> Disassemble
Vehicle: 2005 Chevrolet Equinox LS 3.4 V6 GAS

Never clamp propeller shaft tubing in a vise. Clamping could dent or deform the tube causing an imbalance or unsafe condition. Always clamp on one of the yokes and support the shaft horizontally. Avoid damaging the slip yoke sealing surface. Nicks may damage the bushing or cut the lip seal.

Disassemble

  • Support propeller shaft in a line horizontal with table of a press.
  • Mark propeller shaft in order to show which end connects to transmission and which end goes to rear axle.
  • On models equipped with external snap ring retainers, proceed as follows:
    • Disassemble snap rings by ...

CLICK HERE TO GET FULL ACCESS TO 2005 Chevrolet Equinox DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES

DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES FOR 2005 Chevrolet Equinox AUTOMOBILES

Includes CV axle, universal joint, and driveline replacement, for domestic and imported 2005 Chevrolet Equinox cars and light trucks from 1990+.

DRIVESHAFT, Replace
Vehicle: 2005 Chevrolet Equinox LS 3.4 V6 GAS

  • Place transmission in neutral.
  • Raise and support vehicle.
  • Index mark relationship of propeller shaft to rear drive module flange.
  • Remove bolts securing underbody guard loop.
  • Remove underbody guard loop.
  • Place a support under propeller shaft at rear drive module.
  • Remove bolts securing propeller shaft yoke flange to rear drive module flange.
  • Index mark relationship of propeller shaft to power take-off unit (PTU) flange.
  • Place a support under propeller shaft at PTU.
  • Remove bolts securing propeller shaft to PTU flange.
  • Place a su...

CLICK HERE TO GET FULL ACCESS TO 2005 Chevrolet Equinox DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES

DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES FOR 2005 Chevrolet Equinox AUTOMOBILES

Includes CV axle, universal joint, and driveline replacement, for domestic and imported 2005 Chevrolet Equinox cars and light trucks from 1990+.

CV AXLE SHAFT, Replace -> Front -> Rear
Vehicle: 2005 Chevrolet Equinox LS 3.4 V6 GAS

Front

  • Raise and support vehicle, then remove tire and wheel assembly.
  • Remove engine splash shield, and stabilizer shaft link.
  • Disconnect wheel speed sensor electrical connector.
  • Insert a suitable drift through brake caliper and remove front wheel driveshaft nut.
  • Separate outer tie rod end from steering knuckle. Do not loosen tie rod end jam nut.
  • Separate lower ball joint from steering knuckle.
  • Attach front hub spindle remover tool No. J 42129, or equivalent, then disengage driveshaft from hub and bearing assembly.
  • Disengage driveshaft from transaxle using slide hammer tool No. J ...

CLICK HERE TO GET FULL ACCESS TO 2005 Chevrolet Equinox DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES

DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES FOR 2005 Chevrolet Equinox AUTOMOBILES

Includes CV axle, universal joint, and driveline replacement, for domestic and imported 2005 Chevrolet Equinox cars and light trucks from 1990+.

DRIVESHAFT, Replace
Vehicle: 2005 Chevrolet Equinox LT 3.4 V6 GAS

  • Place transmission in neutral.
  • Raise and support vehicle.
  • Index mark relationship of propeller shaft to rear drive module flange.
  • Remove bolts securing underbody guard loop.
  • Remove underbody guard loop.
  • Place a support under propeller shaft at rear drive module.
  • Remove bolts securing propeller shaft yoke flange to rear drive module flange.
  • Index mark relationship of propeller shaft to power take-off unit (PTU) flange.
  • Place a support under propeller shaft at PTU.
  • Remove bolts securing propeller shaft to PTU flange.
  • Place a su...

CLICK HERE TO GET FULL ACCESS TO 2005 Chevrolet Equinox DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES

DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES FOR 2005 Chevrolet Equinox AUTOMOBILES

Includes CV axle, universal joint, and driveline replacement, for domestic and imported 2005 Chevrolet Equinox cars and light trucks from 1990+.

CV AXLE SHAFT, Replace -> Front -> Rear
Vehicle: 2005 Chevrolet Equinox LT 3.4 V6 GAS

Front

  • Raise and support vehicle, then remove tire and wheel assembly.
  • Remove engine splash shield, and stabilizer shaft link.
  • Disconnect wheel speed sensor electrical connector.
  • Insert a suitable drift through brake caliper and remove front wheel driveshaft nut.
  • Separate outer tie rod end from steering knuckle. Do not loosen tie rod end jam nut.
  • Separate lower ball joint from steering knuckle.
  • Attach front hub spindle remover tool No. J 42129, or equivalent, then disengage driveshaft from hub and bearing assembly.
  • Disengage driveshaft from transaxle using slide hammer tool No. J ...

CLICK HERE TO GET FULL ACCESS TO 2005 Chevrolet Equinox DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES

DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES FOR 2005 Chevrolet Equinox AUTOMOBILES

Includes CV axle, universal joint, and driveline replacement, for domestic and imported 2005 Chevrolet Equinox cars and light trucks from 1990+.

DRIVESHAFT U-JOINT, Replace -> Assemble -> Disassemble
Vehicle: 2005 Chevrolet Equinox LT 3.4 V6 GAS

Never clamp propeller shaft tubing in a vise. Clamping could dent or deform the tube causing an imbalance or unsafe condition. Always clamp on one of the yokes and support the shaft horizontally. Avoid damaging the slip yoke sealing surface. Nicks may damage the bushing or cut the lip seal.

Disassemble

  • Support propeller shaft in a line horizontal with table of a press.
  • Mark propeller shaft in order to show which end connects to transmission and which end goes to rear axle.
  • On models equipped with external snap ring retainers, proceed as follows:
    • Disassemble snap rings by ...

CLICK HERE TO GET FULL ACCESS TO 2005 Chevrolet Equinox DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES

Shop online for auto body parts, engines, wheels, lights...

Click here to view more details2007 Chevrolet Equinox Door Handle, Front, Rear, AutoTrust Gold products are guaranteed to meet or exceed the original manufacturer's standards and quality; <b>Backed by a 5-year limited warranty</b>; If the part breaks or is damaged - even if you are involved in a wreck or accident - anytime within 5 years from purchase, simply cover shipping and handling and we will send you a new part..

Source: Auto Body Parts Store

$20.46

Click here to view more details2007 Chevrolet Equinox Bumper Step Pad, A high quality, direct fit OE replacement bumper step pad; With 2 years limited Trustbuilt warranty..

Source: Auto Body Parts Store

$68.43

Click here to view more details2009 Chevrolet Equinox Center Cap, Wheel Center Cap; Fits ALY05277; Polished With Machined And Gold Logo; Used, , .

Source: Wheels / Rims, Mirrors & Lights Store

$16.45

Click here to view more details about 1995 Dodge Caravan L4, 2.5 L, 2507 CC, 153 CID Rebuilt Engine1995 Dodge Caravan L4, 2.5 L, 2507 CC, 153 CID Rebuilt Engine, FWD, non turbo, roller cam, with balance assembly, (supplied with new head casting)., Warranty: 3-Year/100,000 Mile, .

Source: Rebuilt Engines Store

$1,558.00

Click here to view more details2009 Chevrolet Equinox Used Wiper Motor Front, from 1/30/08, Very Good.

Source: Used Auto Parts Store

$70.00

Click here to view more details2008 Chevrolet Equinox Used Exhaust Manifold, L. (Fr), Very Good.

Source: Used Auto Parts Store

$80.00
More parts
Help me findSearch
Auto Repair Quick Search
Help me find
Search DIY repair manuals by VIN...
Vehicle Identification Number is a unique serial number used by the automotive industry to identify individual motor vehicles

Find out what info we have for your vehicle

Get the Complete Technical Service Bulletins!
Get the Complete Technical Service Bulletins!Access diagrams and repair information such as wiring diagrams, diagnosis and repair charts, manufacturer service bulletins, and OEM Part numbers of your 2005 Chevrolet Equinox vehicle.
Access the Complete guide!
Need To Fix Your Car or Truck?
Save Money With Free Car Insurance Quote
FREE car insurance quote
Enter Zip Code:
GOT A WEBSITE?Make money with Automotix

Make money with Automotix Partner Program.

Learn more

Auto Repair Quick Search
Help me find