Auto Parts Search


      Over 40 million used auto parts online. Shop online for auto and truck parts and save up to 75%

Learn how to repair a car or truck, install or remove parts, wire an engine, reset warning lights, replace fuel filter, fix auto body and more. Get Automotix DIY!
Help me findSearch
Get Full Access Automotix DIY provides automotive consumers and do it yourselfers; the most comprehensive repair information about 2004 Dodge RAM 1500 Pickup car and truck repair procedures including Dodge engine diagrams, wiring diagrams, repair work estimating measures, technical service bulletins, auto body work guidance, starter & alternator replacement procedures, serpentine belt replacement procedures, radiator & hose replacement procedures, tune-up & drivability specifications, quick lube illustrations, preventive maintenance guide, engine light reset instructions, parts removal and install procedures, fuel filter replacement directions, component location diagrams, air filter locations & replacement instructions, a/c system specifications, and general auto service procedures. You don't have to be a car mechanic or technician to know how to fix your 2004 Dodge RAM 1500 Pickup automobile. Try the Automotix DIY solution today!
DIY REPAIR SAMPLES > CONTINUE EXPLORING >

We have info for following modifications of 2004 Dodge RAM 1500 Pickup

  • 2004 Dodge RAM 1500 Pickup 3.7 V6 GAS, CID:225, Fuel Injection, Aspiration:225, Engine VIN:, Desg:K
  • 2004 Dodge RAM 1500 Pickup 4.7 V8 GAS, CID:287, Fuel Injection, Aspiration:287, Engine VIN:, Desg:N
  • 2004 Dodge RAM 1500 Pickup 5.7 V8 GAS, CID:345, Fuel Injection, Aspiration:345, Engine VIN:, Desg:D
  • 2004 Dodge RAM 1500 Pickup SRT10 8.3 V10 GAS, CC:8275, CID:505, Fuel Injection, Aspiration:505, Engine VIN:, Desg:H
  • 2004 Dodge RAM 1500 Pickup 4.7 V8 FLEX, CID:287, Fuel Injection, Aspiration:287, Engine VIN:, Desg:P

DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES FOR 2004 Dodge RAM 1500 Pickup AUTOMOBILES

Includes CV axle, universal joint, and driveline replacement, for domestic and imported 2004 Dodge RAM 1500 Pickup cars and light trucks from 1990+.

DRIVESHAFT, Replace -> Front -> Rear
Vehicle: 2004 Dodge RAM 1500 Pickup SRT10 8.3 V10 GAS

Front

  • With vehicle in neutral, position vehicle on hoist.
  • Remove exhaust crossover pipe.
  • Mark a line across axle companion flange, propeller shaft, flange yoke and transfer case for installation reference.
  • Remove axle/transfer case companion flange bolts. Remove dust boot clamp from the C/V joint end of shaft if equipped.
  • Remove propeller shaft.
  • Reverse procedure to install, noting the following:
    • Align reference marks.
    • Install NEW axle companion flange bolts, coated with Loctite 242, and torque front propeller shaft axle companion flange bolts to 85 ft. lbs.
    • Torque front propeller sh...

CLICK HERE TO GET FULL ACCESS TO 2004 Dodge RAM 1500 Pickup DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES

DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES FOR 2004 Dodge RAM 1500 Pickup AUTOMOBILES

Includes CV axle, universal joint, and driveline replacement, for domestic and imported 2004 Dodge RAM 1500 Pickup cars and light trucks from 1990+.

CV AXLE SHAFT, Replace
Vehicle: 2004 Dodge RAM 1500 Pickup 3.7 V6 GAS

  • With vehicle in neutral, position vehicle on hoist.
  • Remove half shaft nut from shaft.
  • Remove brake caliper and rotor.
  • Remove steering knuckle.
  • Disengage inner C/V joint from axle shaft with two pry bars between the C/V housing and axle housing.
  • Remove half shaft from vehicle.
  • Reverse procedure to inst...

CLICK HERE TO GET FULL ACCESS TO 2004 Dodge RAM 1500 Pickup DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES

DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES FOR 2004 Dodge RAM 1500 Pickup AUTOMOBILES

Includes CV axle, universal joint, and driveline replacement, for domestic and imported 2004 Dodge RAM 1500 Pickup cars and light trucks from 1990+.

CV AXLE SHAFT, Replace
Vehicle: 2004 Dodge RAM 1500 Pickup 4.7 V8 GAS

  • With vehicle in neutral, position vehicle on hoist.
  • Remove half shaft nut from shaft.
  • Remove brake caliper and rotor.
  • Remove steering knuckle.
  • Disengage inner C/V joint from axle shaft with two pry bars between the C/V housing and axle housing.
  • Remove half shaft from vehicle.
  • Reverse procedure to inst...

CLICK HERE TO GET FULL ACCESS TO 2004 Dodge RAM 1500 Pickup DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES

DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES FOR 2004 Dodge RAM 1500 Pickup AUTOMOBILES

Includes CV axle, universal joint, and driveline replacement, for domestic and imported 2004 Dodge RAM 1500 Pickup cars and light trucks from 1990+.

DRIVESHAFT U-JOINT, Replace -> Assemble -> Disassemble -> U-Joint with Injected Rings -> U-Joint with Snap Rings
Vehicle: 2004 Dodge RAM 1500 Pickup 4.7 V8 GAS

This procedure describes a propeller shaft equipped with a cardan joint in the tube yoke. For propeller shafts equipped with a companion/slip yoke, repeat the steps to remove the remaining cardan joint.

U-Joint with Snap Rings

Disassemble
  • Tap outside of bearing cap with a drift to loosen snap ring.
  • Remove snap rings from both sides of yoke.
  • Position yoke with grease fitting if equipped, pointing up.
  • Position a socket with a inside diameter large enough to receive bearing cap, beneath yoke on a press.
  • Place another socket with an outside diameter smaller than bearing cap on ...

CLICK HERE TO GET FULL ACCESS TO 2004 Dodge RAM 1500 Pickup DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES

DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES FOR 2004 Dodge RAM 1500 Pickup AUTOMOBILES

Includes CV axle, universal joint, and driveline replacement, for domestic and imported 2004 Dodge RAM 1500 Pickup cars and light trucks from 1990+.

DRIVESHAFT U-JOINT, Replace -> Assemble -> Disassemble -> U-Joint with Injected Rings -> U-Joint with Snap Rings
Vehicle: 2004 Dodge RAM 1500 Pickup 5.7 V8 GAS

This procedure describes a propeller shaft equipped with a cardan joint in the tube yoke. For propeller shafts equipped with a companion/slip yoke, repeat the steps to remove the remaining cardan joint.

U-Joint with Snap Rings

Disassemble
  • Tap outside of bearing cap with a drift to loosen snap ring.
  • Remove snap rings from both sides of yoke.
  • Position yoke with grease fitting if equipped, pointing up.
  • Position a socket with a inside diameter large enough to receive bearing cap, beneath yoke on a press.
  • Place another socket with an outside diameter smaller than bearing cap on ...

CLICK HERE TO GET FULL ACCESS TO 2004 Dodge RAM 1500 Pickup DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES

DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES FOR 2004 Dodge RAM 1500 Pickup AUTOMOBILES

Includes CV axle, universal joint, and driveline replacement, for domestic and imported 2004 Dodge RAM 1500 Pickup cars and light trucks from 1990+.

DRIVESHAFT, Replace -> Front -> Rear
Vehicle: 2004 Dodge RAM 1500 Pickup 4.7 V8 GAS

Front

  • With vehicle in neutral, position vehicle on hoist.
  • Remove exhaust crossover pipe.
  • Mark a line across axle companion flange, propeller shaft, flange yoke and transfer case for installation reference.
  • Remove axle/transfer case companion flange bolts. Remove dust boot clamp from the C/V joint end of shaft if equipped.
  • Remove propeller shaft.
  • Reverse procedure to install, noting the following:
    • Align reference marks.
    • Install NEW axle companion flange bolts, coated with Loctite 242, and torque front propeller shaft axle companion flange bolts to 85 ft. lbs.
    • Torque front propeller sh...

CLICK HERE TO GET FULL ACCESS TO 2004 Dodge RAM 1500 Pickup DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES

Shop online for auto body parts, engines, wheels, lights...

Click here to view more details about 2001 Dodge Ram 1500 Step Bumper2001 Dodge Ram 1500 Step Bumper, A High Quality, Direct Fit OE Replacement For Step Bumper Mount Kit.

Source: Auto Body Parts Store

$44.07

Click here to view more details2007 Dodge Dakota Wheel Hub, Front, 5 x 5.5 in. bolt pattern; 7.21 in. flange diameter; 9/16 x 18 in. stud size; 3.06 in. wheel pilot diameter; 3.09 in. brake pilot diameter; 1.93 in. flange offset; 4.14 in. hub pilot diameter; 33-spline; Driven; With modified flange; Includes ABS sensor, cable, and lug bolts; A high quality, OE replacement wheel hub assembly; With 2 years limited TrustBuilt warranty..

Source: Auto Body Parts Store

$165.50

Click here to view more details2008 Dodge Charger Taillight Passenger Side, Tail Lamp Lens/Housing; Passenger Side, , .

Source: Wheels / Rims, Mirrors & Lights Store

$45.45

Click here to view more details2005 Dodge Ram 1500 Pickup V8, 5.7 L, 350 CID Rebuilt Engine, Warranty: 3-Year/100,000 Mile, .

Source: Rebuilt Engines Store

$2,809.00

Click here to view more details1994 Dodge RAM 1500 Pickup Used Brake Master Cylinder, 3.9, AUTO, 4X2, Very Good.

Source: Used Auto Parts Store

$72.00

Click here to view more details1995 Dodge RAM 1500 Pickup Used Wiper Motor Front, Very Good.

Source: Used Auto Parts Store

$70.00
More parts
Help me findSearch
Auto Repair Quick Search
Help me find
Search DIY repair manuals by VIN...
Vehicle Identification Number is a unique serial number used by the automotive industry to identify individual motor vehicles

Find out what info we have for your vehicle

Get the Complete Technical Service Bulletins!
Get the Complete Technical Service Bulletins!Access diagrams and repair information such as wiring diagrams, diagnosis and repair charts, manufacturer service bulletins, and OEM Part numbers of your 2004 Dodge RAM 1500 Pickup vehicle.
Access the Complete guide!
Need To Fix Your Car or Truck?
Save Money With Free Car Insurance Quote
FREE car insurance quote
Enter Zip Code:
GOT A WEBSITE?Make money with Automotix

Make money with Automotix Partner Program.

Learn more

Auto Repair Quick Search
Help me find