2001 GMC Savana 2500 Brake Service (ONLINE REPAIR MANUALS)

2WD Models

Except Montana, Silhouette, Trans Sport & Venture

Front

• Raise and support vehicle.
• Remove tire and wheel assembly.
• Remove caliper as outlined under "Caliper Service."
• Remove grease cap from hub/rotor, Fig. .
• Remove cotter pin, nut and washer.
• Remove hub/rotor from spindle, being careful not to damage spindle threads or outer bearing.
• Reverse procedure to install, noting the following:
• Apply high-temperature wheel bearing grease to inner and outer wheel bearings.
• Torque nut to 12 ft. lbs. while turning wheel assembly forward by hand, back nut off one flat or until hole in spindle...

C & K Series

Duo-Servo

Removal

• Raise and support vehicle.
• Mark relationship of wheel to hub, then remove tire and wheel assembly.
• On models equipped with full-floating axles, remove hub and drum assembly as described in "Drive Axles."
• On models equipped with semi-floating axles, proceed as follows:
• Install pin into park brake lever.
• Mark relationship of drum to axle.
• Remove rear brake drum retainers, as required.
• Remove rear brake drum.
• On all models, remove return springs and shoe guide, Fig. .
• Remove brake hold down springs and pins.
• Disconnect actuator lever and pivot.
• Remove lever return spri...

Delco Master Cylinder

When performing the following procedures, refer to Figs. and noting that the composite reservoir may vary in design.

Disassemble

• Remove master cylinder from vehicle.
• Remove reservoir cover and diaphragm. Discard old brake fluid in reservoir.
• Inspect cover and diaphragm. Replace if cut, cracked or deformed.
• Remove fluid level switch and proportioning valve assembly, if equipped.
• Depress primary piston and remove lock ring.
• Plug primary fluid outlet (outlet nearest to cowl when master cylinder is installed), then apply compressed air into secondary fluid outlet t...

Excessive Pedal Travel

• Worn brake linings.
• Disc pads knock back after cornering or rough road travel.
• Piston and linings not properly seated or positioned.
• Insufficient fluid in system.
• Loose wheel bearing adjustment.
• Damaged or worn caliper piston seal.
• Improper booster pushrod adjustment.
• Pads out of flat more than .005 inch.
• Rear brake automatic adjusters inoperative.
• Improperly ground rear brake shoes.

Brake Roughness Or Chatter; Pedal Pumping

• Excessive lateral runout of rotor.
• Rotor excessively out of parallel.

Excessive Pedal Effort

• Frozen or seized pistons.
• Brake fluid, oil or grease on ...

Delco Master Cylinder

When performing the following procedures, refer to Figs. and noting that the composite reservoir may vary in design.

Disassemble

• Remove master cylinder from vehicle.
• Remove reservoir cover and diaphragm. Discard old brake fluid in reservoir.
• Inspect cover and diaphragm. Replace if cut, cracked or deformed.
• Remove fluid level switch and proportioning valve assembly, if equipped.
• Depress primary piston and remove lock ring.
• Plug primary fluid outlet (outlet nearest to cowl when master cylinder is installed), then apply compressed air into secondary fluid outlet t...

Battery Ground Cable

Prior to service disconnect battery ground cable and isolate as required.

Radio Security System

Theftlock

If the Theftlock system is active when battery power is interrupted, the customers security code must be entered to restore proper function of the radio. To unlock a secured radio after power loss, proceed as follows:

• "LOC" appears with ignition in On position.
• Press "NM" and "000" will appear on display.
• Press "NM" again to make last two digits agree with security code.
• Press "HR" to make first 1 or 2 digits agree with security code.
• Press "AM-FM" to select code entered. "SEC" wi...